1993 CADILLAC FLEETWOOD Owners Manual

Downloaded from www.Manualslib.com manuals search engine Wheel Replacement
Replace any wheel that is bent, cracked or badly rusted. If wheel nuts
keep coming loose, the wheel, wheel bolts, and wheel nuts should be
replaced.
If the wheel leaks air out, replace it (except some aluminum
wheels, which can sometimes be repaired). See your Cadillac dealer if any
of these conditions exist.
Your dealer will know the kind
of wheel you need.
Each new wheel should have the same load carrying capacity, diameter,
width, offset, and be mounted the same way as the one it replaces.
If you need to replace any of your wheels, wheel bolts, or wheel nuts,
replace them
only with new GM original equipment parts. This way, you
will be sure to have the right wheel, wheel bolts, and wheel nuts for your
Cadillac model.
I
A CAUTION:
Using the wrong replacement wheels, wheel bolts, or wheel nuts
on your vehicle can be dangerous. It could affect the braking
and handling
of your vehicle, make your tires lose air and make
you lose control. You could have a collision in which you or
others could be injured. Always use the correct wheel, wheel
1 bolts, and wheel nuts for replacement.

Downloaded from www.Manualslib.com manuals search engine I
Vcsd Redacement Wheels
A CAUTION:
Putting a used wheel on your vehicle is dangerous. You can’t
know how it’s been used or how many miles it’s been driven. It
could fail suddenly and cause an accident. If you have to replace
a wheel use am
GM orininn1 equipment wheel.
Tire Chains
n I’ U
1
4. 2’
n f 11

Downloaded from www.Manualslib.com manuals search engine H A CAUTION: I
Cleaning products can be hazardous. Some are toxic. Others
can burst into flame
if you strike a match or get them on a hot
part of the vehicle. Some are dangerous if you breathe their
fumes in
a closed space. When you use anything in a container
to clean your Cadillac, be sure to follow the instructions. And
always open your doors or wiridows when
you're cleaning the
inside.
Never use these tu clean
your vehicle:
0 Benzene
CAUTION: (Continued)
301

Downloaded from www.Manualslib.com manuals search engine CAUTION: (Continued)
0
0
0
0
0
0
0
Naphtha
Carbon Tetrachloridc
Acetone Paint Thinner
Tbrpentine
Lacquer Thinner I
Nail Polish Remover I
They can all be hazardous -- some more than others -- and they
can all damage your vehicle, too.
I
I
,. . - - . . . .- . :,. : ,- .. I
NOTICE:
,... . -~
Don’t use anv of these unless this manual savs vou can. In manv
CLEANING THE INSIDE OF YOUR
CrnILUC
Use a vacuum cleaner often to get rid of dust and loose dirt. Wipe vinyl
with a clean, damp cloth.
Your Cadillac dealer has
two GM cleaners -- a solvent-type spot lifter and
a foam-type powdered cleaner. They will clean normal spots and stains
very well.
“I
n
J
-i
n
302

Downloaded from www.Manualslib.com manuals search engine r
r
Here are some cleaning tips:
Always read the instructions on the cleaner label.
Clean up stains as soon as you can -- before they set.
Use a clean cloth or sponge, and change to a clean area often. A soft
Use solvent-type cleaners in a well-ventilated area only. If you use
If a ring forms after spot cleaning, clean the entire area immediately
brush
may be used if stains are stubborn.
them, don't saturate the stained area.
or it will set.
USING FOA2M-T"E CLEANER ON FABRIC
Vacuum and brush the area to remove any loose dirt.
Always clean a whole trim panel or section. Mask surrounding trim
Mix Multi-Purpose Powdered Cleaner following the directions on the
Use suds only and apply with a clean sponge.
Don't saturate the material.
Don't rub it roughly.
As soon as you've cleaned the section, use a sponge to remove the
Rinse the section with a clean, wet sponge.
Wipe off what's left with a slightly damp paper towel or cloth.
Then dry it immediately with an air hose, a hair dryer or a heat lamp.
along
stitch or welt lines.
container label.
suds.
303
0 Wipe with a clean cloth.

Downloaded from www.Manualslib.com manuals search engine 1
USING SOLVE’NT-TJTE CLEANER ON
FmMC
First, see if you have to use solvent-type cleaner at all. Some spots and
stains will clean
off better with just water and mild soap.
n
u11 I
If you need to use it, then:
e Gently scrape excess soil from the trim material with a clean, dull -
knife or scraper. Use very little cleaner, light pressure and clean cloths ’.
(preferably cheesecloth). Cleaning should start at the outside of the
stain, “feathering” toward the center. Keep changing to a clean
section
of the cloth.
When you clean a stain from fabric, immediately dry the area with an
air hose, hair dryer, or heat lamp to help prevent a cleaning ring. (See
--
the previous NOTICE.)
SPECIAL CLEANING PROBLEMS
Greasy or Oily Stains: Like grease, oil, butter, margarine, shoe polish,
coffee with cream, chewing gum, cosmetic creams, vegetable oils, wax
crayon, tar and asphalt.
0 Carefully scrape off excess stain.
Then follow the solvent-type instructions above.
Shoe polish, wax crayon, tar and asphalt will stain if left on a vehicle
seat fabric. They should be removed as soon as possible. Be careful,
because the cleaner will dissolve them and may cause them to bleed.
Non-Greasy Stains: Like catsup, coffee (black), egg, fruit, fruit juice,
milk, soft drinks, wine, vomit, urine and blood.
Carefully scrape off excess stain, then sponge the soiled area with cool
7
water. U
If a stain remains, follow the foam-type instructions above.
0 If an odor lingers after cleaning vomit or urine, treat the area with a
waterbaking soda solution:
1 teaspoon (5 ml) of baking soda to 1 cup
(250 ml) of lukewarm water.
0 Finally, if needed, clean lightly with solvent-type cleaner.
n
U
P -i
304

Downloaded from www.Manualslib.com manuals search engine Combination Stains: Like candy, ice cream, mayonnaise, chili sauce and
unknown stains.
Carefully scrape off excess stain, then clean with cool water and allow
to dry.
If a stain remains, clean it with solvent-type cleaner.
_I CLEANING WIWZ OR LEATHER
Just use warm water and a clean cloth.
_- e Rub with a clean, damp cloth to remove dirt. You may have to do it
more than once.
Things like tar, asphalt and shoe polish will stain if you don’t get them
off quickly. Use a clean cloth and solvent-type vinyl/leather cleaner.
CLEANING THE TOP OF THE
INSTRUMENT PANEL
c_
Use only mild soap and water to clean the top surfaces of the instrument
reflections in the windshield and even make it difficult to see through the
windshield under certain conditions.
- panel. Sprays containing silicones or waxes may cause annoying
__
Care Of Wood Panels
Use a clean cloth moistened in warm soapy water, (use mild dish
washing soap).
Dry the wood immediately with a clean cloth. -
Wood surfaces can be polished using ordinary household furniture
polishes. Apply the polish to a clean cloth, then rub the cloth
on the
wood panel.
305

Downloaded from www.Manualslib.com manuals search engine CARE OF SAFETYBELTS
Keep belts clean and dry.
A CAUTION:
Do not bleach or dye safety belts. If you do, it may severely
weaken them. In a crash they might not be able to provide
adequate protection. Clean safety belts only with mild soap and
lukewarm water.
GLASS
Glass should be cleaned often. GM Glass Cleaner (GM Part No.
1050427) or a liquid household glass cleaner will remove normal tobacco
smoke and dust films.
Don’t use abrasive cleaners on glass, because they may cause scratches.
Avoid placing decals
on the inside rear window, since they may have to be
scraped
off later. If abrasive cleaners are used on the inside of the rear
window, an electric defogger element may be damaged.
Any temporary
license should not be attached across the defogger grid.
CLEANING THE OUTSIDE OF THE
WINDSHIELD
AND mPER BLADES
If the windshield is not clear after using the windshield washer, or if the
wiper blade chatters when running,
wax or other material may be on the
blade or windshield.
Clean the outside
of the windshield with GM Windshield Cleaner,
Bon-Ami Powder@ (GM Part
No. 1050011). The windshield is clean if
beads do not form when you rinse it with water.
Clean the blade by wiping vigorously with a cloth soaked in full strength
windshield washer solvent. Then rinse the blade with water.
Wiper blades should be checked on
a regular basis and replaced when
worn.
306