1990 MITSUBISHI SPYDER clutch

A U T O M A T I C T R A N S A X L E
OVERHAUL Transaxle
the differential cover
the differential
. .
the differential outer’
race.
,,
the differential assembly.. .
out the end clutch’ installation
move the cover holder and end
the end assembly.
TSB Revision

AUTOMATIC TRANSAXLE
OVERHAUL
-Transaxle
the thrust plate.
the end clutch hub.
t h r u s t b e a r i n g
NOTE
It may be stuck to the and clutch
out the end clutch shaft.
the idler gear cover mounting then’
the idler gear cover and gasket.
the bolt stopper and remove the bolt.
TSB Revision

AUTOMATIC TRANSAXLEOVERHAUL -Transaxle
the input shaft and remove the front
and rear clutch assembly together.
thrust bearing
the clutch hub.
NOTE
. .
The thrust race may be to the clutch ‘hub.
thrust bearing
,
the drum.
TSBRevision

AUTOMATIC TRANSAXLE
OVERHAUL Transaxle .
thrust bearing and washer the
rear clutch.
.
Thrust bearing
race
TSB Revision
the rear clutch assembly front
assembly.
.
thrust bearing the rear clutch- hub.
the rear clutch hub, the ,
thrustrace ontheend of ‘the hub.

AUTOMATIC TRANSAXLE
OVERHAUL
Thrust washer Thrust race
thrust bearing in the, drum.
. ,
the clutch assembly in the drum.
the clutch assembly and drum into the
transaxle case at the same time.
thrust race and washer to back
of the oil pump with
the special tool to install, a oil pump gasket
and oil pump assembly.
Oil pump assembly mounting bolts: 21 Nm
Revision

AUTOMATICOVERHAUL
end play of the input
value, replace race thrust washer
to the standard
Standard value:
the idler shaft lock bolt
lock to the specified torque.
of the lock plate prevent
Idler shaft lock bolt:
,
. .
.. .
the idler cover new
Idler gear cover’ (8
spacer, idler gear arid
the idler shaft.
Caution
Assemble so that the on
i d l e r g e a r f a c e s .
I-
. ,
,
.
. .
the clutch shaft ‘from
spline.
--. . .
I.
,
TSB Revision

A U T O M A T I C T R A N S A X L E
O V E R H A U L
-Transaxle
Thrust bearina
the thrust washer on the the
clutch.
.
,
the end clutch hub on end clutch assembly.
. .,
. ..
,
thrust bearing
with petrolatum.
a new to the
end clutch’ assembly.
to the of
.
TSB Revision

A U T O M A T I C T R A N S A X L E
OVERHAUL
the end clutch cover tighten the
specified torque.’
End cover mounting
assembly.
with a length mm
in.) and diameter of 1.6 mm in.) on the
rear bearing retainer at the position shown the diagram
and install the outer race.
the differential rear
the to the specified torque:
the bolts, remove the differential
remove the if solder is
repeat steps (51) using the solder with the diameter
of 3 mm.
Differential rear bearing retainer bolts:
35Nm (26
,
the of the
and adjust by selecting a
that will provide the value and
preload..
S t a n d a r d v a l u e :
,,
TSB Revision