2020 TESLA MODEL Y Owner´s Manual

Operating Seat Heaters
To control the front seat heaters for the driver and
passenger, touch the corresponding control on the main climate control area at the bottom of the touchscreen.
To control the rear seat heaters (if equipped) or access
duplicate controls for the front seat heaters, touch the
fan icon, then touch the seat heater icon followed by
the seat for which you want to adjust heating. Seat
heaters operate at three setting levels from 3 (highest)
to 1 (lowest). When operating, the associated seat icon
displays twisting lines that turn red to indicate the setting level. You can touch
All Off to turn off all seat
heaters simultaneously.
Adjusting the Front Vents
Model Y has a unique horizontal face-level vent that
spans the width of the dashboard. Using the
touchscreen, you can pinpoint exactly where you want to direct the air
flowing from this vent when heating or
cooling the front cabin area.
1.
Driver vent and controls
2.
Passenger vent and controls
When the face-level vent is on you can adjust the direction of the air
flow from each vent. To adjust the
direction of the air
flow, simply touch the radiating air
waves from the corresponding vent on the touchscreen.
The air
flows in a single stream when centered or splits
into mirrored air streams when air is directed outward or inward from the center of the vent.
When Model Y detects that there are no passengers
sitting in the passenger seat, the passenger vent and controls automatically turn
off. Adjust the climate
settings to enable passenger air
flow.
NOTE: When you split a vent into two separate air
flows, the air flow in each direction is not as strong as
when all air is
flowing in a single direction.
NOTE: Outside air is drawn into Model Y through the
grill in front of the windshield. Keep the grill clear of
obstructions, such as leaves and snow.
Adjusting the Rear Vents
Model Y has vents located at the back of the center
console where air
flows from when the setting is turned
on from the touchscreen. To direct the
flow of air in the
rear cabin area, adjust the vents at the rear of the center console up, down, or from side to side as necessary.
Climate Controls
127Using the Touchscreen

Keep Climate On, Dog Mode, and
Camp Mode
The Keep Climate On, Dog, and Camp settings allow
you to keep the climate control system running when in Park, even after you

WARNING: Never leave children or pets in the
vehicle unattended. Due to automatic shut-off or
extreme outside conditions, the inside of the
vehicle can become dangerously hot, even when
Cabin Overheat Protection is enabled.
Climate Control Operating Tips

Overview
The touchscreen displays a map at all times. To move the map in any direction, hold and drag a
finger. To rotate
the map in any direction, hold and turn two
fingers.
To set the map

Drop a pin by pressing and holding your finger

anywhere on the map. When you drop a pin, or touch an
existing pin, the chosen location is centered on the map,
and a popup window provides information about the location. From this popup, you can navigate to the location, call the location (if a phone number is
available) and add or remove the location from your list of favorite destinations (see
Recent, Favorite, Home and
Work Destinations on page 133).
Navigating
To navigate to a location, touch Navigate, send the
destination from your phone, or speak a voice command (see
Using Voice Commands on page 141). You can
enter or speak an address, landmark, business, etc. You can also choose a saved
Home or Work location and
select from a list of recently used locations (the most recent displays at the top of the list), including charging stations you have visited.
NOTE: To remotely start navigation from your IOS

To enable Automatic Navigation, touch Controls >
Navigation > Automatic Navigation. You must have
your phone

navigating, the map displays this calculation at the bottom of the expanded turn-by-turn direction list (see
Navigating on page 131). When the turn-by-turn
direction list is compressed, touch the top of the list to expand it.
Throughout your route, Model Y monitors energy usage
and updates the calculation. A popup warning displays at the bottom of the turn-by-turn direction list in these situations:

To delete a Recent or Favorite destination, touch and hold it down
briefly, then touch the X that appears.
The top of the navigation list also provides shortcuts for
Home and Work locations. Touch Set Home or Set
Work to set an address to either of these locations.
After entering the address, touch
SAVE AS HOME or
SAVE AS WORK. Then simply touch these shortcuts
whenever you want to navigate home or to work.
To change the location associated with Home or Work, press and hold the shortcut icon and enter the new desired address in the "Set Your Home Address"
window. Then, touch
SAVE AS HOME or SAVE AS
WORK to save the new address.
To delete a saved Home or Work address, press and hold the shortcut icon, and then touch
CLEAR HOME or
CLEAR WORK.
NOTE: Based on your usage patterns, you may be
prompted to save a location as Home or Work.
NOTE: Once a Home or Work location is saved, Model Y
may prompt you to navigate to your Work location in
the mornings and to your Home location in the
evenings and tell you how long it will take to arrive based on current
tra