2017 VOLVO XC90 TWIN ENGINE HYBRID Owners Manual

MAINTENANCE AND SERVICING
}}
543

NOTE
•The system cannot detect changes in theoil level immediately. The vehicle must bedriven approximately 20 miles (30 km) orhave been parked on level ground withthe engine off for 5 minutes before theoil level reading will be correct.
•If the necessary conditions are not metfor checking the oil level electronically(time interval after the engine wasswitched off, if the vehicle is parked onan incline, etc.), No values available willbe displayed. This does not indicate aproblem with the oil level sensor.

Related information
•Engine oil (p. 541)
•Ignition modes (p. 400)
Windshield wipers in the serviceposition
The windshield wiper blades must be in the verti-cal (service) position for replacement, washingor to lift them away from the windshield whene.g., removing ice or snow.
Wipers in the service position

CAUTION
Be sure the wiper blades are not frozen inposition before attempting to move them tothe service position.

Putting the windshield wipers in the
service position
The service position can be activated while thevehicle is stationary and the wipers are not acti-vated.
The service position can be activated in two waysfrom the center display:
Via Function view
–From Function view, tap the Wiper ServicePosition button. The indicator light in thebutton will illuminate when the service posi-tion is activated.
>The windshield wipers will move to thevertical position.

Via Settings
1.Tap Settings in the center display's Topview.
2.Tap My CarWipers
3.Tap the Wiper Service Position box.
>The windshield wipers will move to thevertical position.

Deactivating service position
The service position can be deactivated in twoways from the center display:

||
MAINTENANCE AND SERVICING
544

Via Function view
–From Function view, tap the Wiper ServicePosition button. The indicator light in thebutton will go out when the service positionis deactivated.

Via Settings
1.Tap Settings in the center display's Topview.
2.My CarWipers
3.Tap the Wiper Service Position to deselectthe box.
The wipers will also leave the service position if:
•The wipers are activated.
•The windshield washers are activated.
•The rain sensor is activated.

CAUTION
If the wiper arms have been folded out fromthe windshield while in the service position,fold them back against the windshield beforereturning the wipers to the normal position tohelp avoid scratching the paint on the hood.
Related information
•Replacing wiper blades (p. 544)
•Using the windshield wipers (p. 161)
Replacing wiper blades
The wiper blades should be replaced regularlyfor best effect.
The windshield wiper blades must be in the verti-cal (service) position for replacement, washingor to lift them away from the windshield whene.g., removing ice or snow.

Replacing the windshield wiper blades

MAINTENANCE AND SERVICING
545
With the wipers in the service position, foldout the wiper arm from the windshield. Pressthe button on the wiper blade attachmentand pull the wiper blade straight out, parallelwith the wiper arm.
Slide in the new wiper blade until it clicksinto place.
Check that the blade is securely in place.
4.Press the wipers back against the wind-shield.
The windshield wiper blades are different lengths

NOTE
The windshield wiper blades are differentlengths. The blade on the driver

MAINTENANCE AND SERVICING
546
Refilling coolant
Coolant helps keep the gasoline engine at theproper operating temperature. The heat transfer-red from the engine to the coolant can be usedto warm the passenger compartment.
When refilling coolant, follow the instructions onthe package and use the recommended amountof coolant. Never fill the cooling system withwater only; this could lead to freezing, corrosionand engine damage.

WARNING
If the engine has been running, the coolantwill be very hot. Allow the engine to coolbefore opening the coolant expansion tank. Ifthis is not possible, open the cap very slowlyto allow pressure to dissipate.
Coolant expansion tank
Lift the rubber strip by pressing it inward inthe engine compartment.
Remove the plastic cover by folding out thecatch and lifting the cover upward.
Unscrew the expansion tank cap and addcoolant. The level should be between theMIN and MAX marks on the tank.
Put the other components back in place in thereverse order.
CAUTION
•High levels of chlorine, chlorides andother salts may cause corrosion in thecooling system.
•Only use coolants with corrosion protec-tion recommended by Volvo.
•The ratio of coolant to water is 50/50.
•Mix the coolant with tap water of drinka-ble quality.
•If maintenance is performed on the cool-ing system or if the coolant is replaced,flush the cooling system with clean waterbefore adding new a new coolant/watermixture.
•The engine may only be operated with aproperly filled cooling system. Otherwise,high temperatures and cracks in the cyl-inders may occur.

Related information
•Coolant specifications and volumes(p. 566)

MAINTENANCE AND SERVICING
}}
* Option/accessory, for more information, see Introduction.547
Refilling the windshield washer fluidreservoir
Washer fluid helps keep the windshield andheadlights clean.
The windshield and headlight washers* share acommon reservoir. Open the blue cap to refillwasher fluid (see the illustration for the locationof the reservoir).
During cold weather, the reservoir should be filledwith windshield washer solvent containing anti-freeze. Use Volvo Original Washer Fluid or theequivalent with a recommended pH valuebetween 6 and 8 in a 1:1 solution.
When there is approx. 1 qt (1 liter) of washerfluid remaining in the reservoir, a text message
and the symbol will be displayed in theinstrument panel.

Related information
•Opening and closing the hood (p. 539)
•Engine compartment overview (p. 540)
Cleaning the exterior
The vehicle should be washed at regular inter-vals since dirt, dust, insects and tar spotsadhere to the paint and may cause damage. Tohelp prevent corrosion, it is particularly importantto wash the car frequently in the wintertime.

Hand washing
The following points should be kept in mind whenwashing and cleaning the car:

CAUTION
Avoid using car washing detergents with a pHvalue lower than 3.5 or higher than 11.5.Doing so could result in discoloring of ano-dized aluminum surfaces on e.g., roof rails orthe frames around the side windows.
•Avoid washing your car in direct sunlight.Doing so may cause detergents and wax todry out and become abrasive. To avoidscratching, use lukewarm water to soften thedirt before you wash with a soft sponge, andplenty of sudsy water.
•Bird droppings: Remove from paintwork assoon as possible. Otherwise the finish maybe permanently damaged.
•A car washing detergent can be used tofacilitate the softening of dirt and oil.

||
MAINTENANCE AND SERVICING
548
•Dry the car with a clean chamois andremember to clean the drain holes in thedoors and rocker panels.
•Tar spots can be removed with tar removerafter the car has been washed.
•A stiff-bristle brush and lukewarm soapywater can be used to clean the wiper blades.Frequent cleaning of the windshield andwiper blades improves visibility considerablyand also helps prolong the service life of thewiper blades.
•Wash off the dirt from the underside (wheelhousings, fenders, etc).
•In areas of high industrial fallout, more fre-quent washing is recommended.

CAUTION
•During high pressure washing, the spraymouthpiece must never be closer to thevehicle than 13" (30 cm). Do not sprayinto the locks.
•Dirt, snow, etc., on the headlights canreduce lighting capacity considerably.Clean the headlights regularly, for exam-ple when refueling.
Special laminated panoramic roof cau-tions:
•Always close the laminated panoramicroof and sun shade before washing yourvehicle.
•Never use abrasive cleaning agents onthe laminated panoramic roof.
•Never use wax on the rubber sealsaround the laminated panoramic roof.

NOTE
When washing the car, remember to removedirt from the drain holes in the doors and sills.

Automatic car washes
•We do NOT recommend washing your car inan automatic wash during the first few
months (because the paint will not havehardened sufficiently).
•An automatic wash is a simple and quick wayto clean your car, but it is worth rememberingthat it may not be as thorough as when youyourself go over the car with sponge andwater. Keeping the underbody clean is mostimportant, especially in the winter. Someautomatic washers do not have facilities forwashing the underbody.
NOTE
Condensation may form temporarily on theinside of the lenses of exterior lights such asheadlights or taillights. This is normal and thelights are designed to withstand moisture.Normally, condensation will dissipate after thelights have been on for a short time.

MAINTENANCE AND SERVICING
549

CAUTION
When using an automatic car wash in whichthe vehicle has to be able to roll freely, theauto-hold brake function must be deactivated.If this is not done, the brakes will automati-cally be applied when the vehicle is stationary.
To deactivate this function:
1.Drive the vehicle into the car wash
2. Turn off the auto-hold function using thecontrol on the center console
3. Turn off the parking brake's automaticfunction in the center display's Top view
(tap Settings, tap My CarElectricParking Brake and deselect AutoActivate Parking Brake)
4.Put the gear selector in N
5.Switch off the ignition by turning the startknob to STOP and holding it in this posi-tion for at least 4 seconds
The vehicle will then be able to roll freely.
CAUTION
•Before driving into an automatic carwash, turn off the optional rain sensor toavoid damaging the windshield wipers.
•Make sure that side view mirrors, auxiliarylamps, etc, are secure, and that anyantenna(s) are retracted or removed. Oth-erwise there is risk of the machine dis-lodging them.
•Chromed wheels: Clean chrome-platedwheels using the same detergents usedfor the body of the vehicle. Aggressivewheel-cleaning agents can permanentlystain chrome-plated wheels.

WARNING
•When the vehicle is driven immediatelyafter being washed, apply the brakes,including the parking brake, several timesin order to remove any moisture from thebrake linings.
•Engine cleaning agents should not beused when the engine is warm. This con-stitutes a fire risk.

Exterior components
Volvo recommends the use of special cleaningproducts, available at your Volvo retailer, forcleaning colored plastic, rubber, or ornamentalcomponents such as chromed strips on the exte-
rior of your vehicle. The instructions for usingthese products should be followed carefully. Sol-vents or stain removers should not be used.
CAUTION
•Avoid waxing or polishing plastic or rub-ber components
•Polishing chromed strips can wear awayor damage the surface
•Polishes containing abrasive substancesshould not be used

Related information
•Paint damage (p. 553)
•Corrosion protection (p. 552)
•Polishing and waxing (p. 554)
•Windshield wipers in the service position(p. 543)

MAINTENANCE AND SERVICING
* Option/accessory, for more information, see Introduction.550
Cleaning the interior
Only use cleaning agents and car care productsrecommended by Volvo. Clean regularly and fol-low the instructions included with the car careproduct.

CAUTION
•Under no circumstances should gasoline,naphtha or similar cleaning agents beused on the plastic or the leather sincethese can cause damage.
•Take extra care when removing stainssuch as ink or lipstick since the coloringcan spread.
•Use solvents sparingly. Too much solventcan damage the seat padding.
•Start from the outside of the stain andwork toward the center.
•Sharp objects (e.g. pencils or pens in apocket) or Velcro fasteners on clothingmay damage the textile upholstery.
•Clothing that is not colorfast, such asnew jeans or suede garments, may stainthe upholstery.

Fabric upholstery and ceiling liner
Clean with soapy water or a detergent. For moredifficult spots caused by oil, ice cream, shoe pol-ish, grease, etc., use a clothing/fabric stainremover. Consult your Volvo retailer.
Leather * care
Volvo's leather upholstery is manufactured with aprotectant to repel soiling. Over time, sunlight,grease and dirt can break down the protection.Staining, cracking, scuffing, and fading can result.
Volvo offers an easy-to-use, non-greasy leathercare kit formulated to clean and beautify yourvehicle's leather, and to renew the protectivequalities of its finish. The cleaner removes dirtand oil buildup. The light cream protectantrestores a barrier against soil and sunlight.
Volvo also offers a special leather softener thatshould be applied after the cleaner and protec-tant. It leaves leather soft and smooth, andreduces friction between leather and other fin-ishes in the vehicle.
Volvo recommends cleaning, protecting and con-ditioning your vehicle's leather two to four times ayear. Ask your Volvo retailer about Leather CareKit 951 0251 and Leather Softener 943 7429.

Cleaning leather upholstery
1. Pour leather cleaner on a damp sponge andsqueeze it until the cleaner foams.
2. Apply the foam to the stain by moving thesponge with circular movements.
3. Dampen the stain thoroughly with thesponge. Let the sponge absorb the stain, donot rub.
4. Dry the stain with soft paper towels or atowel, and allow the leather to dry completely.
Protecting leather upholstery
1. Put a small amount of protectant cream on acloth and apply a thin coating of cream to theupholstery with light circular movements.
2. Allow the leather to dry for 20 minutes.
This will help the leather resist staining and pro-tect against sunlight's harmful UV rays.

Cleaning a leather-covered steering
wheel
•Remove soil, dust, etc., with a damp spongeand a neutral soap solution.
•Leather should be allowed to breath. Nevercover the steering wheel with a plastic pro-tector.
•Volvo recommends cleaning, protecting andconditioning the steering wheel with Volvo'sLeather Care Kit 951 0251 and LeatherSoftener 943 7429.
If there are stains on the steering wheel:
Type 1 (ink, wine, coffee, milk, sweat or blood)
–Use a soft cloth or sponge. Wipe the wheelwith a solution with 5% ammonia. For bloodstains, mix approx. 1 cup (2 dl) of water andone ounce (25g) of salt and wipe the stain.
Type 2 (fat, oil, sauces, or chocolate)
1.Same procedure as for type I stains.