2017 PEUGEOT 4008 Owners Manual

04
319
4008_en_Chap10d_Mitsu4_ed01-2016
RADIO
Selecting radio sourcePress the RADIO button to switch on
the radio.
Press the RADIO button repeatedly
to select the waveband; it changes in
the following order: FM1 / FM2 / FM3 /
MW / LW
/ FM1... Automatic station search
Manual station search
turn the

SEL knob to the left to search
the lower frequencies or to the right to
search the higher frequencies. Press the "9" or ":" button to search
the lower frequencies or the higher
frequencies respectively.
t

he search begins automatically and
stops at the first station found.
Selecting the waveband
Selection / Presetting

04
320
4008_en_Chap10d_Mitsu4_ed01-2016
Press one of the six buttons "1" to "6" until an
audible signal is heard.
t
he sound cuts out then becomes audible again
when the station has been preset.
t

he number of the button and the associated radio
frequency appear in the screen. Manual station presetting
to recall the pre-set stored setting, press the button and release it
within two seconds.
RADIO
You can preset up to six stations on each waveband.
Presetting a new station replaces the previous station. Automatic station presetting
Disconnecting the battery terminals clears the preset radio stations. Stations can only be preset automatically on wavebands FM1,
FM2 and FM3.
Presetting new stations replaces the previous stations.
t

his presetting can be activated automatically irrespective of the
waveband selected.
Press the RADIO button for more than
two seconds.
t

he six stations offering the best
reception are preset and classified
from the weakest to the strongest on
the six corresponding buttons.
Recalling preset stations
Press one of the six buttons "1" to "6".
t

he station
corresponding to the waveband selected appears on
the screen.

04
321
4008_en_Chap10d_Mitsu4_ed01-2016
RADIO
the "Radio Data System" (RDS) function on the FM waveband
permits:
-

access to the display of information, such as the name of the
station, ...
-


listening to the same station while travelling through dif
ferent
regions,
-

temporary tuning to traffic information announcements.
Most FM stations use RDS.
t

hese stations transmit non-audible
data in addition to their programmes.
t

he data transmitted in this way allows you access to various
functions, mainly displaying of the name of the station, automatic
retuning to alternative frequencies or temporary retuning to traffic
information announcements.
RDS allows you to continue listening to the same station by means
of alternative frequencies that carry the same station. However, in
certain conditions, RDS alternative frequencies may not be provided
throughout the country. Radio stations do not cover the whole country,
which explains the loss of reception of the station during a journey. "AF" alternative frequencies
Your radio automatically checks and selects the best frequency for
the radio station to which it is tuned (if the station broadcasts on
several transmitters or frequencies).
t

he frequency of a radio station covers approximately 30 miles
(50 km).
t

he change from one frequency to another explains the
temporary loss of reception during a journey.
If the station to which you are listening does not have several
frequencies in the region in which you are currently located, you can
deactivate alternative frequencies.
Some stations are organised in a network.
In different regions, they broadcast different or shared programmes
depending on the time of day.
You can follow:
-

a regional station only
,
-

the entire network, with the possibility that you will be listening
to a dif

ferent programme.
REG regional mode
On long distance journeys, when the stored station becomes weak,
the radio searches first for another frequency for the same station
(AF).
t

hen, if this fails, it searches for a frequency broadcasting the
regional programme (R
eg ). If this also fails, the radio returns to the
stored station.
RDS
Press the MENU button.
Press the SEL knob repeatedly to
select the RDS mode: "AF", "R
eg "
and "
t P" then turn the knob to select
the desired value.

04
322
4008_en_Chap10d_Mitsu4_ed01-2016
RADIO
"TP" traffic information
t
he "Traffic Programme" ( t P) function permits automatic
and temporary switching to an FM station broadcasting traffic
information.
t

he radio station or the source that you are listening to at this point
is put on hold.
Once the traffic information has ended, the system switches back to
the radio station or the source that you were listening to initially.
Press the TP button.
"
t P" appears in the screen. If the
station is compatible, "RDS" also
appears.
If the radio detects traffic information, "TRAF INF" appears on the
display, followed by the frequency of the broadcasting station, then
its name.
t

he volume is different from that of the previous source.
Following the broadcasting of the traffic information, the volume
returns to that of the source prior to the interruption.
When "
t P" appears in the screen, the radio stops only at RDS
stations broadcasting traffic information. "ALERT" emergency broadcasts
An emergency broadcast automatically and temporarily interrupts
the FM station or the source that you are listening to.
t

he message "AL e R
t
" appears in the screen and the volume is
different from that of the previous source.
Following the emergency broadcast, the message disappears and
the volume returns to that of the source prior to the interruption.
"PTY" themed type of programme
Some stations offer the option of listening to a themed type of
programme as a priority, selected from the list available below:
N
e WS, AFFAIRS, INFO, SPOR
t,
e D u CA
te
, DRAMA, C u L
tu
R e ,
SCI
e NC e , VARI e D, POP

M, ROCK M, e ASY

M, LI g H t M,
CLASSICS, O
t H e R M, W e A
t
H e R, FINANC e , CHILDR e N,
SOCIAL, RELIGION, PHONE
IN, TRAVEL, LEISURE, JAZZ,
CO
u N t RY, NA
t
ION M, OLDI e S, FOLK M, DOC u M e N t
.

04

323
4008_en_Chap10d_Mitsu4_ed01-2016
RADIO
Search for a "PTY" broadcastPress the PTY/SCAN button.
ten seconds after reception, the PTY

mode is cancelled. Press one of the six buttons "1" to "6" for more than
two seconds.
t

he sound cuts out then becomes audible again
when the programme has been stored.
t

he number of the button and the associated P t Y
programme appear in the screen. Presetting a "PTY" programme
You can preset up to six P
t Y programmes.
e

ach new programme stored replaces the previous one.
turn the

SEL knob to select PTY
mode; the symbol flashes and an
automatic search is made.
Once the station has been found, its
name appears in the screen.
Press the "9" or ":" buttons to find
another station. Press the PTY/SCAN button.
turn the

SEL knob to select PTY
mode, then press one of the six
buttons "1" to "6" to define the preset
location.

04
324
4008_en_Chap10d_Mitsu4_ed01-2016
RADIO
Changing the display language of the "PTY" programmeFunctions setting mode
t

his permits activation or deactivation
of the functions below.
Press the SEL knob repeatedly; the
setting mode for the functions changes
in the following order
: g RAC e NO te
DB / AF / R
eg /
t
P-S / PI-S / P t Y
(languages) / PH setting / C
t / OFF.
t

he functions setting mode is deactivated after approximately
10
seconds without any action.
Press the MENU button.
Press the SEL knob repeatedly to
select the PTY lang mode.
turn the

SEL knob to select the
language (
e N g LISH, FRANCAIS,
D
eut SCH, SV e NSK, e SPA g NOL,
I
t
ALIANO). Press then

MENU button.
turn the

SEL knob to the left to
deactivate the function ("OFF") or to
the right to activate it ("ON").

04
325
4008_en_Chap10d_Mitsu4_ed01-2016
DAB (Digital Audio Broadcasting)
Digital radio
Press the RADIO button repeatedly to
select the waveband; this changes in
the following order: FM1 / FM2 / FM3 /
DAB1 / DAB2 / DAB3 / MW / LW.
Selecting the waveband
Digital radio provides a superior audio quality and also additional
categories of traffic announcements.
t
he different channels offer a choice of radio stations in alphabetical order.
Automatic station search
Manual station search
turn the

SEL thumbwheel respectively
to the left to search for lower
frequencies or to the right to search for
higher frequencies. Press button "7" or "8" respectively
to search for lower or higher
frequencies.
t

he search begins automatically and
stops on the first station found. Press one of the six buttons "1" to "6" until an
audible signal is heard.
t

he sound cuts out, then becomes audible again
after storing.
t

he number of the button and the frequency of the
associated radio station appear on the display. Storing stations
to retrieve the pre-set memory setting, press the button and release
it within two seconds. Y

ou can store up to six stations for each waveband.
e

ach new stored station replaces the previous station.
"DAB" does not have 100% coverage of the country.
When the digital signal is weak, "DAB" allows you to continue
listening to the same station, by automatically switching to the
corresponding analogue "FM" station (if it exists).
RADIO

05
326
4008_en_Chap10d_Mitsu4_ed01-2016
MUSIC MEDIA PLAYERS
this can play audio CDs (CD-DA, CD-text, CD-R/R W)
or MP3 CDs. Ejecting a disc
CD player
Selecting CD mode
If the player already contains a disc,
press the MEDIA button.
"M
e DIA", the track number and the
playing time appear in the screen.
Insert circular compact discs only.
8 cm compact discs must be inserted in the centre of the player slot. After inserting a disc, printed face upwards, the player starts
automatically. Press this button to remove the
disc from the player. t
he system
automatically switches to radio mode.
Once ejected, if the compact disc is not removed within
fifteen
seconds, it is reloaded into the player.