2017 MAZDA MODEL MX-5 Owners Manual (in English)

7–55
If Trouble Arises
When Trunk Lid Cannot be Opened
12. Remove the windblocker.


Windblocker

13. Partially peel back the cover on the
right side from the middle of the
vehicle.



14. Pull out the cap and release the trunk
lock.
After performing this emergency
measure, have the vehicle inspected at
an Authorized Mazda Dealer as soon as
possible.


CAUTION
Do not pull the screw when pulling the
cap. Otherwise, the screw may fall off
and become lost.

Roof does not operate electrically
1. Remove the antenna if it is
installed. Refer to Antenna on page
5-13 .
2. Lift up the rear roof by hand.
Refer to When the Roof Cannot be
Closed on page 7-57 .
3. Remove the fasteners on the right side
of the vehicle.



4. Push the stopper rubber through the
cover on the right side of the vehicle
while slightly lifting the cover up.


Cover
Stopper Rubber
/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–56
If Trouble Arises
When Trunk Lid Cannot be Opened
5. Lift up the cover from the outside of
the vehicle.



6. Insert your hand beneath the lifted
cover and loosen the cap screws until
they spin freely.



7. Pull out the cap and release the trunk
lock.



CAUTION
At this point, do not open the trunk.
If the trunk is opened before the rear
roof is completely closed, the trunk
may contact the rear roof and cause
damage and become scratched.

8. Close the rear roof by hand. Refer to
When the Roof Cannot be Closed on
page 7-57 .
9. Open the trunk lid.
After performing this emergency
measure, have the vehicle inspected at
an Authorized Mazda Dealer as soon as
possible.

/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–57
If Trouble Arises
When the Roof Cannot be Closed
When the Roof Cannot be Closed
If the roof cannot be closed electrically by pressing the retractable fastback switch, verify
the roof operation conditions ¿ rst.
Refer to Operation Conditions on page 3-44 .
If the roof cannot be closed even after the operation conditions are all met, have it checked
at an Authorized Mazda Dealer.
If you are unable to have the roof checked at an Authorized Mazda Dealer, the roof can be
closed manually as an emergency measure.
The procedure for manually closing the roof is as follows:

1. Opening the rear roof
Release the locks of the rear roof and open it.
2. Closing the front roof
Lift up the front roof and close it.
3. Closing the rear roof
Tie the ropes to the rear roof links and close the rear roof.

Front roofRear roof
Rear roof link

CAUTION
 


¾ Do not drive the vehicle with the roof partially open. The vehicle operation may be aff ected
by the wind and could result in an accident.
 


¾ Do not perform the procedure in a strong wind as it could cause an unexpected accident.



¾ Two adults are required to perform the procedure, especially when lifting up the front roof.
Do not do it alone so as not to cause injury or vehicle damage.
 


¾ Some steps in the procedure require using multiple tools at the same time and a certain
level of technical expertise. In addition, holding your body extended over the car can result
in muscle strains so Mazda recommends having the roof checked at an Authorized Mazda
Dealer.

/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–58
If Trouble Arises
When the Roof Cannot be Closed
N O T E
 


y This procedure is for manually closing the roof as an emergency measure. After closing
the roof manually, electric operation is not possible until the system is restored by an
Authorized Mazda Dealer.
 


y Using a À ashlight will facilitate the procedure.
Manual closing
Before closing manually
WARNING
Verify that the ignition is switched off
before manually operating the roof:
Manually closing the roof with the
ignition not switched off is dangerous
as the motors could turn on suddenly
and cause injury resulting from
hands or fi ngers being pinched in the
mechanism.

1. Park on a hard, level surface off the
right-of-way and ¿ rmly set the parking
brake.
2. Put a vehicle with an
automatictransmission in Park (P), a
manual transmission in Neutral.
3. Switch the ignition off while depressing
the brake pedal.
4. Turn on the hazard warning À asher if it
is needed.

Tool preparation
Take out the ¿ ve tools stored in the seat
side box.
Refer to Seat Side Box on page 5-138 .

WireGear
(tool kit)Rope
L-shaped
hexagonal wrench
(Small)L-shaped
hexagonal wrench
(Large)

Opening the rear roof
CAUTION
 


¾ When turning the bolt, cover the front
roof using a cloth. The front roof may
be damaged if the L-shaped hexagonal
wrench contacts it.
 


¾ Because the clearance with the stored
front roof is narrow, be careful not to let
the L-shape hexagonal wrench contact
the roof when turning the bolt.

N O T E
Moving the seats as far forward as
possible and folding the seatbacks forward
will facilitate the procedure.
Refer to Seat Operation on page 2-4 .

/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–59
If Trouble Arises
When the Roof Cannot be Closed
1. Remove the antenna if it is installed.
Refer to When the Antenna on page
5-13 .
2. Insert the short end of the L-shaped
hexagonal wrench (Large) into the
motor bracket bolt.

Bolt

NOTE
If it is dif¿ cult to see the bolt, remove the
windblocker and identify the bolt from the
center of the vehicle.

Windblocker

3. Turn the L-shaped hexagonal wrench
(Large) counterclockwise to loosen the
bolt slightly.


4. Remove the L-shaped hexagonal
wrench (Large) once from the bolt,
then insert the long end of the wrench
into the bolt.
N O T E
The tip of the long end of the L-shaped
hexagonal wrench can be used at an
angle. Moving the wrench upward slightly
will increase the clearance between the
rear roof and the stored front roof and
facilitate the procedure.

5. Turn the L-shaped hexagonal wrench
(Large) counterclockwise 13 times or
more while pressing the wrench against
the bolt.


/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–60
If Trouble Arises
When the Roof Cannot be Closed
N O T E
 


y The bolt cannot be removed completely.



y If it is hard to turn the bolt, repeat Step
3 a few times.

6. Hook the wire to the link pin shown in
the ¿ gure.
7. While one person pushes the rear roof
down, another person pulls the wire
until a latch sound is heard and the rear
roof unlocks.
Lock
Link Pin
Wire
Unlock

8. Do the same procedure on the other
side.
9. While standing on both sides of the
vehicle, lift the rear roof to the position
it stops while keeping the height of
its left and right sides as parallel as
possible.


CAUTION
 


¾ Do not let go of the rear roof on both
sides until it is fully open. The rear roof
could fall if it is released too soon and
cause injury.
 


¾ Do not attempt to forcefully lift the
rear roof. If the rear roof is forcefully
lifted without being unlocked, it could
damage vehicle parts.
 


¾ Lift the rear roof with its left and right
height as parallel as possible. If the
rear roof is lifted with the left or right
height slanted, it could deform the link
mechanism.

Closing the front roof
CAUTION
 


¾ Some steps in the procedure require
holding your body in a strained position
and if over exerted it could result in
injury.
 


¾ Do the procedure being very careful not
to get your hands and fi ngers caught
while closing the front roof. Otherwise,
your hands or fi ngers could be injured.
 


¾ Removal of the headliner is included
in the procedure, however, never drive
the vehicle with the headliner removed.
Driving the vehicle with the headliner
removed is prohibited by law. Correctly
perform the procedure while following
the instructions.

/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–61
If Trouble Arises
When the Roof Cannot be Closed
1. While standing on both sides of the
vehicle, hold the front and rear sides
of the front roof and pull the front roof
upward.


2. Switch your hand on the rear side of
the front roof to the front side and pull
the front roof forward.


3. Stop pulling the front roof before it
completely closes.


N O T E
The next step cannot be done if the front
roof is closed completely.

4. Remove the link covers on the left and
right sides by pulling them out by hand.

Link cover

5. Remove the fasteners and the headliner.


6. Lightly press the front edge of the front
roof from outside of the vehicle to
close the front roof completely.


/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD

7–62
If Trouble Arises
When the Roof Cannot be Closed
7. Insert the short end of the hexagonal
wrench (Small) into the gear (tool kit)
and assemble.

L-shaped hexagonal
wrench (Small)Gear (tool kit)

8. Insert the point of the gear (tool kit)
into the hole beside the top lock
motor gear with the hexagonal wrench
inserted into the gear tool.

Top lock motor
gear
Gear (tool kit)

CAUTION
Insert the gear (tool kit) securely until
it engages with the top lock motor
gear. If the gear (tool kit) is not inserted
securely, it may come off and be
damaged.

9. Rotate the hexagonal wrench and move
the hook in the lock direction so that
there is enough space for the opening
of the headliner to be attached to the
hook.

Unlock
Unlock
LockLock

N O T E
Turning the gear (tool kit) requires some
effort due to motor resistance. Slowly
operate the hexagonal wrench.

10. Insert the hook into the opening of the
headliner

Hook
Headliner
/:A(4'#,A'FKVKQPKPFD/:A(4'#,A'FKVKQPKPFD