Page 129 of 527

127
C4-Picasso-II_en_Chap04_conduite_ed01-2016
Starting-switching off the engine with Keyless Entry and Starting
F Place the gear selector lever at P or N for
vehicles with an automatic gearbox, or
n
eutral with a manual gearbox.
F
W
ith the electronic key inside the vehicle,
p
ress the brake pedal for vehicles with an
a
utomatic gearbox, or fully declutch for
v
ehicles with a manual gearbox.
Diesel vehicles
In temperatures below zero the
engine will not start until the
p
reheater warning lamp has
g
one off.
Starting the engine
The presence of the "Keyless Entry and
Starting" electronic key in the recognition zone
i
s
e
ssential.
It
is not necessary to place the electronic key in
t
he back-up reader.
If
the electronic key is not detected,
a
message is displayed. Move the
e
lectronic key into the recognition zone
s
o that the engine can be started.
In the event of a problem, see "Key not
detected
/ Back-up starting".
F
B riefly press the "
S TA R T/
STOP "
button while maintaining
p
ressure on the pedal until the
engine
s
tarts.
If one of the starting conditions is not met, a reminder message appears in the i
nstrument panel screen.
In some circumstances, it is necessary
to
turn the steering wheel slightly while
p
ressing the "START/STOP " button
to
assist unlocking of the steering; a
m
essage warns you when this is needed.
As a safety measure, never leave the
vehicle while the engine is running.
The
steering
column
unlocks
and
the
engine
s
tarts
more
or
less
instantly.
See
the
advice
below
for
Diesel
versions. If
this warning lamp comes on after
p
ressing "START/STOP ", you should
hold
the brake or clutch pedal down
u
ntil the warning lamp goes off and do
n
ot press the " START/STOP " button
again
before the engine starts.
4
Driving
Page 130 of 527

128
C4-Picasso-II_en_Chap04_conduite_ed01-2016
Key not detected
Back-up starting
When the electronic key is in the recognition zone and, after pressing the "START/STOP"
b
utton, the engine does not start:
F
P
lace the gear selector at P or N for
vehicles
with an automatic gearbox or
n
eutral for vehicles with a manual gearbox.
F
I
nsert the electronic key in the back-up
re
ader.
F
W
ith
the
electronic
key
inside
t
he vehicle, press the "
S TA R T/
STOP "
button.
The
engine
stops
and
the
steering
c
olumn
locks.
F
I
mmobilise
the
vehicle.
F
P
lace
the
gear
selector
at
P or N for
vehicles
with
an
automatic
gearbox,
or
n
eutral
with
a
manual
gearbox.
Switching off the engine
If the vehicle is not immobilised, the
engine
will not stop.
Do not leave your vehicle with the
electronic
key still inside. F
P
ress the brake pedal on vehicles with an
a
utomatic gearbox, or fully declutch with a
m
anual
g
earbox.
F
P
ress the "START/STOP" button.
The
engine starts.
Switching
off the engine leads to a loss
o
f braking assistance.
Driving
Page 131 of 527
129
C4-Picasso-II_en_Chap04_conduite_ed01-2016
When the electronic key is not detected or is no longer in the recognition zone, a message
a
ppears in the instrument panel when closing a
d
oor or trying to switch off the engine.
Emergency switch-off
In the event of an emergency only, the engine can be switched off
wi
thout
c
onditions.
Press
the "START/STOP" button for
a
bout 3 seconds.
In
this
case the steering column locks as soon
a
s
the
vehicle stops.
F
T
o confirm the instruction to
switch
off
the
engine,
press
the
"
START/STOP"
button
for
about
3
seconds.Back-up switch off
In the event of a fault with the electronic key, c ontact a CITROËN dealer or a qualified
workshop.
4
Driving
Page 132 of 527

130
C4-Picasso-II_en_Chap04_conduite_ed01-2016
Switching the ignition on
( without
s
tarting)
With the ignition on, the system goes i
nto energy economy mode when
n
ecessary to maintain the state of
charge
of the battery.
With
the electronic key in the reader or the
K
eyless Entry and Starting key inside the
v
ehicle, pressing the "START/STOP" button,
w
ith no action on the pedals
, allows the
ignition to be switched on.
F
P
ress the "START/STOP" button,
t
he instrument panel comes on
but the engine does not start.
F
P
ress the button again to switch off the
i
gnition and so allow the vehicle to be
lo
cked.
Anti-theft protection
Electronic engine immobiliser
The keys contain an electronic chip which has a
secret code. When the ignition is switched
o
n, this code must be recognised in order for
s
tarting to be possible.
This
electronic engine immobiliser locks the
e
ngine management system a few minutes
a
fter the ignition is switched off and prevents
s
tarting of the engine by anyone who does not
h
ave the key.
In the event of a malfunction, you are informed
by
a message in the instrument panel screen.
In
t
his
c
ase,
y
our
v
ehicle
d
oes
n
ot
s
tart;
c
ontact
a
CITROËN dealer if required.
Driving
Page 133 of 527

131
C4-Picasso-II_en_Chap04_conduite_ed01-2016
Electric parking brake
In the event of a battery failure, the
electric parking brake no longer works.
As
a safety measure, if the parking
b
rake is not applied, immobilise the
v
ehicle by engaging a gear (with a
m
anual gearbox) or placing a chock at
o
ne of the wheels.
Contact a CITROËN dealer or a
qualified
w
orkshop.
Indicator lamp
This indicator lamp comes on in the
instrument panel and in the control
lever to confirm the application of the
parking
b
rake.
The system provides, in automatic operation,
the
application
of
the
parking
brake
on
s
witching
off
the
engine
and
release
as
the
v
ehicle
moves
off.
The
driver
can
take
over
at
any
time
to
apply
o
r
release
the
parking
brake,
by
operating
the
c
ontrol
lever:
-
b
y briefly pulling the control lever to apply
the
brake,
-
b
y briefly pushing the control lever, while
pressing
the
foot
brake,
to
release.
Automatic
mode
is
activated
by
default.
The
technology
adopted
for
the
electric
p
arking
brake
does
not
allow
the
fitment
o
f
wheels
smaller
than
16
inches. It
goes
off
to confirm the release of the parking
b
rake.
The indicator lamp in the control lever flashes
during
manual application or release.
After
the
parking brake has been applied, the
s
imultaneous flashing of the two indicator
l
amps in the instrument panel and the control
lever alerts you to the need to fully secure your
vehicle
by
engaging a gear (with a manual
g
earbox)
or by placing the gear selector in
p
osition
P
with an automatic gearbox, or by
f
itting
a
chock to one of the wheels. (E.g.
p
arking
on a very steep slope or on a slope
w
ith
a
low
battery).
4
Driving
Page 134 of 527

132
C4-Picasso-II_en_Chap04_conduite_ed01-2016
Label on door panel
Before leaving the vehicle, check that the parking brake is applied: the
in
dicator lamps in the instrument panel
and
the control lever must be on fixed,
n
ot
f
lashing.
If
the parking brake is not applied, there
i
s an audible signal and a message is
d
isplayed on opening the driver's door.
Never leave a child alone inside the
vehicle
with the ignition on, as they
c
ould release the parking brake.When
towing, parking on a steep slope, o
r if your vehicle is heavily laden,
turn
the wheels towards the kerb and
e
ngage a gear (with a manual gearbox)
o
r place the gear selector at position P
with
an automatic gearbox.
For
towing, your vehicle is approved for
p
arking on slopes of up to 12%.
Manual operation
Application of the parking brake is confirmed by illumination of
the
brake indicator lamp and
t
he P indicator lamp in the control
lever, accompanied by the display of
the
m
essage
"
Parking
b
rake
a
pplied".
Manual release
With the ignition on or the engine running, to release the parking brake:
F
p
ress the brake pedal,
F
w
hile maintaining pressure on the brake
p
edal, briefly push the control lever.
The
complete release of the parking brake
i
s confirmed by the brake indicator lamp and
t
he P indicator lamp in the control lever going
o
ff,
a
ccompanied
b
y
t
he
d
isplay
o
f
t
he
m
essage
"
Parking brake released".
If you push the control lever without
pressing
the brake pedal, the parking
b
rake will not be released and a
m
essage is displayed.
Manual application
With the vehicle stationary: briefly pull the control lever.
Confirmation of the command is signalled by flashing of the indicator lamp in the control
l
eve r.
Driving
Page 135 of 527

133
C4-Picasso-II_en_Chap04_conduite_ed01-2016
With the vehicle stationary, the parking brake is automatically applied when the engine
is switched off
by pressing the START/STOP
b
utton. Application
of the parking brake
i
s confirmed by illumination of the
brake
indicator lamp and the P
indicator lamp in the control lever,
accompanied by the display of the
message
"Parking brake applied".
With
the engine stalled or in STOP
m
ode of Stop & Start, automatic
application
does not take place.
In automatic mode, you can manually
apply
o
r
r
elease
t
he
p
arking
b
rake
u
sing
t
he control lever.
Automatic operation
Automatic release
The complete release of the parking brake is confirmed by the brake
i
ndicator lamp and the P indicator
lamp
in the control lever going off,
a
ccompanied by the display of the
message
"Parking brake released".
When stationary with the engine running, do not depress the accelerator pedal unnecessarily,
you
risk releasing the parking brake.
Ensure first that the engine is running and the driver's door is properly closed.
The
electric parking brake releases
automatically and progressively when you
press
the accelerator :
F
M
anual gearbox: fully depress the clutch
p
edal, engage 1
st or reverse gear; press t
he accelerator pedal and let up the clutch
pedal.
F
A
utomatic
gearbox: select position D, M or
R
then
press
the
accelerator.
Automatic application
With an automatic gearbox, if the brake d oes not release automatically, check
t
hat the front doors are correctly closed.
4
Driving
Page 136 of 527

134
C4-Picasso-II_en_Chap04_conduite_ed01-2016
Special cases
Application of the parking brake is confirmed by illumination of
the
brake indicator lamp and
t
he P indicator lamp in the control
lever, accompanied by the display of
the
m
essage
"
Parking
b
rake
a
pplied". The
complete release of the parking
b
rake is confirmed by the brake
i
ndicator lamp and the P indicator
lamp in the control lever going off,
a
ccompanied by the display of the
message "Parking brake released".
In some situations, you may need to operate
the
parking brake manually.
Immobilisation of the vehicle
with the engine running
To immobilise the vehicle with the engine r
unning, briefly pull the control lever.
Parking the vehicle with the
brake released
In very cold conditions, it is
recommended that the parking brake
n
ot be applied (risk of freezing).
To
immobilise your vehicle, engage a
g
ear or fit a chock to one of the wheels.
Immobilisation of the vehicle with the
parking brake released
F
S
witch off the engine.
I
llumination of the warning lamps in the
i
nstrument panel and control lever confirm
application
of the parking brake,
F
S
witch on the ignition again, without
s
tarting the engine.
F
R
elease the parking brake manually by
p
ushing the control lever while keeping
y
our foot on the brake. F
S
witch off the ignition.
Driving