Page 129 of 404
127
DS3_en_Chap06_conduite_ed01-2014
ProgrammingOperating faults
If there is an operating fault, when r
everse gear is engaged this w
arning
lamp comes on in the instrument panel,
a
ccompanied by an audible signal (short beep)
a
nd
a
message in the multifunction screen.
You
can
activate
or
deactivate
the
system
by
m
eans
of
the
multifunction
screen
configuration
m
enu.
The
system
state
is
memorised
when
s
witching
off
the
ignition.
For
more
information
on
access
to
the
parking
s
ensors
menu,
refer
to
" Vehicle
configuration"
o
r
" Vehicle
parameters"
section
for
your
m
ultifunction
s
creen.
The
system
will
be
deactivated
a
utomatically
when
towing
a
trailer
or
w
hen a bicycle carrier is fitted (vehicle
fitted with a towbar or bicycle carrier
recommended
by
CITROËN). In bad or wintry weather, ensure that
the
sensors are not covered with mud,
f
rost
or snow.
driving
Page 130 of 404
DS3_en_Chap06_conduite_ed01-2014
Reversing camera
The reversing camera cannot in any c
ircumstances be a substitute for
v
igilance on the part of the driver. Clean
the reversing camera regularly
u
sing a soft, dry cloth.
A
reversing camera is activated automatically
w
hen
r
everse
g
ear
i
s
enga
ged.
The
colour image is provided in the navigation
sc
reen. The space between the blue lines represents the
width of your vehicle except for the door mirrors.
The blue lines represent the general direction o
f the vehicle.
The red line represents a distance of about
30
cm beyond the edge of your vehicle's
r
ear bumper. The audible signal becomes
c
ontinuous from this limit.
The
green lines represent distances of about
1
and 2 metres beyond the edge of your
v
ehicle's rear bumper.
Page 131 of 404
129
DS3_en_Chap06_conduite_ed01-2014
driving
Page 132 of 404
DS3_en_Chap07_visibilite_ed01-2014
Visibility
This section describes all of the lighting and wiper controls, headlamp adjustment, the various interior lamps including the interior mood lighting
a
nd in particular, the LED lamps, a true signature of your vehicle.
Page 133 of 404
DS3_en_Chap07_visibilite_ed01-2014
Page 134 of 404

DS3_en_Chap07_visibilite_ed01-2014
Lighting controlsSystem for selection and control of the various front and rear lamps providing the vehicle's lighting.
T he various front and rear lamps of the vehicle
a
re designed to adapt the driver's visibility
p
rogressively according to climatic conditions:
-
s
idelamps, to be seen,
-
d
ipped beam headlamps to see without
d
azzling
o
ther
d
rivers,
-
m
ain beam headlamps to see clearly when
t
he road is clear.
Main lighting
Other lamps are installed to fulfil the requirements of particular conditions of
v
isibility:
-
a
rear foglamp to be seen from afar,
-
f
ront foglamps for improved vision,
-
L
ED lamps to be seen during the daytime.
Additional lighting
Various automatic lighting control modes are also available according to the following
op
tions:
-
g
uide-me-home lighting,
-
a
utomatic illumination of headlamps.
Programming
In some weather conditions (e.g. low temperature or humidity), the presence
o
f misting on the internal sur face of the
g
lass of the headlamps and rear lamps
i
s normal; it disappears after the lamps
h
ave been on for a few minutes.
Page 135 of 404
133
DS3_en_Chap07_visibilite_ed01-2014
Model without AUTO lighting
Model with AUTO lighting
Manual controls
The lighting is controlled directly by the driver by means of the ring A and the stalk B.
Automatic
illumination of headlamps.
B.
S
talk for switching the headlamp beam:
p
ull the stalk to switch between dipped and
m
ain beam headlamps.
In
the lamps off and sidelamps modes,
t
he driver can switch on the main beam
h
eadlamps temporarily ("headlamp flash") by
m
aintaining a pull on the stalk.
A.
M
ain lighting mode selection ring: turn it
t
o position the symbol required facing the
ma
rk.Lighting
off / daytime running lamps.
Sidelamps
o
nly.
Dipped headlamps or main beam headlamps.
displays
Lighting of the corresponding indicator lamp on the instrument panel confirms the switching on
o
f the lighting selected.
The
instrument panel has permanent back-
lighting.
Illumination of the instrument panel is
t
herefore not linked to the exterior lighting.
Visibility
Page 136 of 404

DS3_en_Chap07_visibilite_ed01-2014
c. Foglamp selection ring.
The foglamps operate with the dipped and main
b
eam
h
eadlamps.
Rotate
and release the ring c
:
F
f
or wards a first time to switch on the front
fo
glamps,
F
f
or wards a second time to switch on the
r
ear
fo
glamp,
F
r
ear wards a first time to switch off the rear
fo
glamp,
F
r
ear wards a second time to switch of the
f
ront fog lamps.
Model with front foglamps
and a rear foglamp Lighting on audible warning
When the ignition is switched off, all o
f the lamps switch off automatically,
u
nless guide-me-home lighting is
a
ctivated.
If
the lighting is switched on manually
a
fter switching off the ignition, there
i
s an audible signal when a front door
i
s opened to warn the driver that
they
have forgotten to switch off the
v
ehicle's lighting, with the ignition off.
In
good or rainy weather, by both day
a
nd night, the front foglamps and the
r
ear foglamp are prohibited. In these
s
ituations, the power of their beams
m
ay dazzle other drivers.
Do not forget to switch off the front
f
oglamps and the rear foglamp when
t
hey are no longer necessary.
Front
and
rear
foglamps
When
the
lighting
is
switched
off
automatically
(
with
AUTO
model)
or
when
the
dipped
h
eadlamps
are
switched
off
manually,
the
f
oglamps
and
sidelamps
will
remain
on.
F
T
urn
the
ring
rear wards
to
switch
off
the
f
oglamps,
the
sidelamps
will
then
switch
off.