Page 169 of 190
COLD TYRE INFLATION PRESSURE (bar)
Tyres providedInflation pressure (bar)
Front tyres 205/45 R17 88Y
1.8
205/40 R18 86Y 1.8
Rear tyres 235/40 R18 95Y
2.0
235/35 R19 91Y 2.0
When the tyres are warm, add +0.3 bar to the pressure value prescribed. However, check that the value is correct with cold
tyres.
With snow tyres, add +0.2 bar to the pressure value prescribed for standard tyres.
If it is necessary to raise the car, refer to the "Raising the car" paragraph in the "In an emergency" chapter.
166
TECHNICAL SPECIFICATIONS
24-9-2013 11:50 Pagina 166
Page 170 of 190
DIMENSIONSDimensions are expressed in mm and refer to the car equipped with its standard-supplied tyres. Height is measured with car
unladen.
LUGGAGE COMPARTMENT VOLUMEUnladen capacity (V.D.A. standards): = 110 dm
3
AB C D E FGH L
3990 864 2380 746 1184 1639 1868 1606 2090
Small variations with respect to the reported values are possible depending on the dimensions of the rims.130
A0L0119
167
24-9-2013 11:50 Pagina 167
Page 171 of 190
PERFORMANCEVersionsTop speed (km/h)Acceleration from 0-100
km/h (sec)
1750 Turbo Petrol 2584,5
168
TECHNICAL SPECIFICATIONS
24-9-2013 11:50 Pagina 168
Page 172 of 190
WEIGHTSVersions1750 Turbo Petrol
Unladen weight (with all fluids, fuel tank
90% full and without optional equipment): 920
Payload including the driver: (*) 255
Maximum permitted loads (**)
– front axle: 490
– rear axle: 755
– total: 1175
Towable loads (kg)
- braked trailer: 0
- non-braked trailer: 0
Maximum load on roof: 0
Maximum load on ball joint (braked trailer): 0(*) If special equipment is fitted, the unladen vehicle weight increases, thus reducing the specified payload.
(**) Loads not to be exceeded. The user is responsible for arranging goods in the luggage compartment within the maximum permitted loads.
169
24-9-2013 11:50 Pagina 169
Page 173 of 190
REFUELLING
1750 Turbo PetrolPrescribed fuels / Original fluids
and lubricants
litres kg
Fuel tank 40-
Unleaded petrol not less than 95
RON (EN 228 specification)
including a reserve of 4 - 5-
Engine cooling system 10.69.4Mixture of 50% demineralised water
and 50% PARAFLU
UP
(*)
Engine sump 5.44.6
SELENIA SPORT POWER
Engine sump and filter 5.85.0
Transmission/differential casing: 1.881.6TUTELA TRANSMISSION
GEARTECH
Transmission hydraulic activation system 1.45 1.2 TUTELA CS SPEED
Hydraulic brake circuit with ABS 0.520.56 TUTELA TOP 4
Windscreen washer fluid reservoir 1.91.7Mixture of water and TUTELA
PROFESSIONAL SC 35
(*) When the vehicle is used in particularly harsh weather conditions, we recommend using a 60-40 mixture of PARAFLU
UPand demineralised water.
170
TECHNICAL SPECIFICATIONS
24-9-2013 11:50 Pagina 170
Page 174 of 190

FLUIDS AND LUBRICANTSYour car is equipped with an engine oil that has been thoroughly developed and tested in order to meet the requirements of the
Scheduled Servicing Plan. Constant use of the prescribed lubricants guarantees the fuel consumption and emission
specifications. Lubricant quality is crucial for engine operation and duration.
PRODUCT SPECIFICATIONS
UseFluid and lubricant specifications for a correct
use of the car Genuine fluids and
lubricants Replacement interval
Lubricant for
petrol engines
29)
SAE 5W-40 ACEA C3 grade totally synthetic
lubricant.
FIAT 9.55535-GH2 classification. SELENIA SPORT
POWER
Contractual Technical
Reference No. F052.H12According to
Scheduled Servicing
Plan
In case of emergency, if lubricants with the prescribed specifications are not available, products with the minimum indicated
ACEA performance can be used for topping up; in this case optimal performance of the engine is not guaranteed.
IMPORTANT
29) The use of products with specifications other than those indicated above could cause damage to the engine not covered by the warranty.
171
24-9-2013 11:50 Pagina 171
Page 175 of 190

UseFluid and lubricant specifications for a correct
use of the car Genuine fluids and
lubricants Applications
Lubricants and
greases for drive
transmission SAE 75W 85 grade synthetic lubricant
FIAT 9.55550-MZ3 classification.
TUTELA
TRANSMISSION
GEARTECH
Contractual Technical
Reference No. F704.C08TCT automatic
transmission
Specific fluid for electro-hydraulic ratio selector
actuators
FIAT 9.55550-SA1 classification TUTELA CS SPEED
Contractual Technical
Reference No. F005.F98
Lubricant for electro-
hydraulic actuator
Molybdenum disulphide grease, for use at high
temperatures. NL.G.I. 1-2 consistency
FIAT 9.55580 classification TUTELA ALL STAR
Contractual Technical
Reference No. F702.G07
Wheel side constant
velocity joints
Grease for constant velocity joints with low friction
coefficient. NL.G.I. 0-1 consistency
FIAT 9.55580 classification TUTELA STAR 700
Contractual Technical
Reference No. F701.C07
Differential side
constant velocity joints
Brake fluid Synthetic fluid for brake and clutch systems.
Exceeds specifications: FMVSS no. 116 DOT 4,
ISO 4925, SAE J1704.
FIAT 9.55597 classification TUTELA TOP 4
Contractual Technical
Reference No. F001.A93
Hydraulic brakes and
hydraulic clutch
controls
172
TECHNICAL SPECIFICATIONS
24-9-2013 11:50 Pagina 172
Page 176 of 190

UseFluid and lubricant specifications for a correct
use of the car Genuine fluids and
lubricants Applications
Protective agent
for radiators Red protective agent with antifreeze action, based
on inhibited monoethylene glycol with organic
formula. Exceeds CUNA NC 956-16, ASTM D
3306 specifications.
FIAT 9.55523 classification PARAFLU
UP
(*)
Contractual Technical
Reference No. F101.M01 Usage percentage:
50% demineralised
water 50%
PARAFLU
UP
(**)
Windscreen
washer fluid Mixture of alcohol, water and surfactants CUNA
NC 956-11
FIAT 9.55522 classification TUTELA
PROFESSIONAL SC 35
Contractual Technical
Reference No. F201.D02To be used diluted or
undiluted in
windscreen/rear
window washer/wiper
systems
(*)IMPORTANT Do not top up or mix with other fluids which have different specifications from those described.
(**)When the vehicle is used in particularly harsh weather conditions, we recommend using a mixture of 60%
PARAFLU
UPand 40% demineralised water.
173
24-9-2013 11:50 Pagina 173
Adhesive for
glassesMS Polymer
base adhesive
FIAT 9.55738/C classification SIMSON ISR 70-08 APSticking the glasses on
the body