2012 SSANGYONG NEW ACTYON SPORTS light

02-138710-01
Rain sensing unit
(AUTO light integrated type)
▶INT Switch Auto Position Reminder (Power-Up Reminder Wiper)
When turning off and on the auto INT switch, the system drives the wiper motor through
LOW relay regardless of communication with rain sensor.
When turning the INT-AUTO switch from the "OFF" to "ON" position with the ignition switch
in the "ON" mode, the LOW relay operates to drive the wiper motor for 1 cycle, regardless
of the rain sensor communication.
After that, when turning the INT-AUTO switch from the "OFF" to "ON" position, the LO
W
relay operates to drive the wiper motor for 1 cycle only if data from the rain sensor
indicates rain drops. -
-
Multifunction wiper switch:
AUTO and sensitivity control
A sensor that emits infrared rays through LED
and then detects the amount of rain drops by
receiving reflected rays against sensing section
(rain sensor mounting section on the
windshield) with photodiode (auto light sensor
integrated type)AUTO: Wiper operates automatically by rain
sensor
FAST↔SLOW: Auto delay/Auto speed control. A
position that can control sensitivity against rains
on the windshield and transmits wiping demand
signal accordingly

02-20
▶Auto Light Control
The tail lamps and headlamps can be controlled by the communication with the rain
sensor only when the auto light switch is in "AUTO" position with the ignition switch "ON". -
Rain detected headlamp: If it rains heavy which requires the highest INT speed (almost
LOW), the headlamps are turned on automatically. -
Night detected wiping: When the auto light control turns on the headlamps and the rain
sensor detects the rain, the wiper sensitivity is automatically increased by one level in
comparison with daytime.
(i.e. the AUTO wiper switch is at the 3rd level, but the wiper operates at the 4th level.) -
Enlarged auto light sensor Emitter lens
The LED emitting the infrared
rays is installed on the bottom
and the lens guides the
infrared rays to target point.
Auto light sensor (Vertical)
Auto light sensor (Horizon)

02-278710-01
▶Door Ajar Warning
The warning light comes on when opening any door while the vehicle speed is below 10
km/h.
The warning light goes off when closing the door under step (1).
The warning light blinks when the vehicle speed is over 10 km/h while the warning light is
turned on.
The warning light blinks when a door is open while the vehicle speed is over 10 km/h.
The warning light goes off when closing the door under step (3).
The warning light comes on when the vehicle speed goes below 10 km/h under step (3). 1.
2.
3.
4.
5.
6.
Since the luggage room tailgate does not have the door switch, the door ajar warning light
does not come on when it is open.

02-28
▶Seat Belt Warning
The seat belt warning light comes on and the chime buzzer sounds for 6 seconds when
turning the ignition key to "ON" from "OFF".
If the seat belt is fastened before turning the ignition key to the the "ON" position, the
warning light blinks, however, the chime buzzer does not sound.
The seat belt warning light goes off and the chime buzzer stops when turning the ignition
switch to the "OFF" position during the warning operation.
The chime buzzer stops and the seat belt warning light stays on for the remainig time when
fastening the seat belt.
The seat belt warning light comes on and the chime buzzer sounds for 6 seconds again
when unfastening the seat belt during fastening operation while the ignition key is "ON"
position. 1.
2.
3.
4.
The seat belt warning light blinks and the chime buzzer sounds for 6 seconds when turning the
ignition key to "ON" without fastening the seat belt. After fastening the seat belt, the chime buzzer
stops.
Seat Belt Warning LightChime Buzzer

02-298710-01
▶Parking Brake Warning
The parking brake warning light comes on for approx. 4 seconds when turning the ignition
key from the "OFF" to the "ON" position regardless of the vehicle speed and the parking
brake switch position. After this 4 seconds, the warning light comes on, goes off or blinks
according to the vehicle speed and the parking brake switch position.
The warning light comes on when the parking brake is applied and the vehicle speed is
below 10 km/h.
The warning light goes off when releasing the parking brake under step (2).
The warning light blinks and the chime buzzer sounds for 2.5 seconds and stops for 1.5
seconds when the vehicle speed is over 10 km/h for more than 2 seconds while the
parking brake is applied.
The warning light goes off and the chime buzzer stops when releasing the parking brake
under step (4).
The warning light comes on and the chime buzzer stops when the vehicle speed goes
down below 10 km/h under step (4).
This function does not work when the ignition switch is in "OFF" position. 1.
2.
3.
4.
5.
6.
7.

02-458710-01
3. STICS CONTROL REGARDING THEFT WARNING ALARM
1) Armed mode
The followings are definition of DOOR OPEN/CLOSE and DOOR LOCK/UNLOCK in respect of
theft deterrent system. -
DOOR OPEN and DOOR CLOSE
DOOR OPEN: - Any of all door switches (including engine hood, driver's door, passenger's
door or rear door) is in "OPEN" position.
DOOR CLOSE: - All door switches (including engine hood, driver's door, passenger's door,
rear door and tailgate) are in "CLOSE" position.
The door lock/unlock operation does not affect the engine hood.
OPEN/CLOSE of the dech tailgate does not affect entering the armed mode.
In other words, when the hood and front/rear door are closed even if the dech tailgate is
open, the vehicle can enter the armed mode. -
-
DOOR LOCK & DOOR UNLOCK
DOOR LOCK: -
Indicates that driver's, passenger's and rear door and tailgate lock switches
are in LOCK positions.
DOOR UNLOCK: -
Indicates that driver's, passenger's or rear door or tailgate lock switches
are in UNLOCK positions.
Engine hood open warning lamp
The warning lamp comes on when the engine
hood is open.
Since the luggage room tailgate does not have the door switch, the door ajar warning light
does not come on when it is open.

03-8
4. START FUNCTION
1) Immobilizer Function
The immobilizer system prevents the vehicle theft by allowing only the authorized key to start the
engine. The transponder inside the key communicates with the immobilizer installed in the key
box, and the system permits the engine to start after confirming the encrypted coding from the
engine ECU.
For the vehicle with the immobilizer, there can be a problem in starting the vehicle or the
system error:Immobilizer & rechargeable
unit sends encrypted code
to transponder (2)
Sends an encrypted signal to
unit as a response (3) Randomly transmitted code is changed
to an encrypted signal in immobilizer &
rechargeable unit (4)
System compares signal from
transponder and encrypted signal in
immobilizer & rechargeable unit (5)
When two or more immobilizer keys come into contact with (each) other(s).
When the key is close to any device sending or receiving electromagnetic fields or waves
other than Ssangyong products.
When the key is close to any electronic or electric devices such as lighting equipment,
security keys or security cards.
When the key is close to a magnetic or metal object or a battery. a.
b.
c.
d.
Immobilizer &
rechargeable unitTransponder

04-4
1. DESCRIPTIONS OF INDICATOR DISPLAY
Tachometer
ESP indicator/warning light
Immobilizer indicator
Glow indicator
Front fog light indicator
High beam indicator
ESP OFF indicator
Seat belt reminder (driver’s seat)
Seat belt reminder (passenger’s seat)
Engine oil pressure warning light
LCD Display
Engine overheat warning light
Engine check warning light
Auto cruise indicator
Light indicator
Winter mode indicator 1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.Engine hood open warning light
Battery charge warning light
Hazard Indicator
Water separator warning light
Air bag warning light
4WD CHECK warning light
4WD LOW indicator
4WD HIGH indicator
Speedometer
Turn signal indicator
Coolant temperature gauge
Brake warning light
Door ajar warning light
ABS warning light
Fuel gauge
Low fuel level warning light 17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32. It sends and receives information to/from each unit through CAN communication line. The LCD
display and separate ESP ON/OFF indicator are newly added.