Page 517 of 828
06-38610-08
1. SPECIFICATIONS
Multifunction switch ▶
Item Rated load Voltage drop
Light 0.1 A Max. 0.25 V
Dimmer & passing High beam: 0.3 A / Low beam: 0.3 A
/ Passing: 0.3 AMax. 0.25 V
Turn signal lamp switch 0.5 A Max. 0.25 V
Hazard warning flasher switch 0.1 A -
Fog lamp 0.1 A -
Wiper LOW: 5 A (motor load)
HI: 7 A (motor load)
AUTO: 0.22 A (relay load)
LOCK: Max. 28 A (motor load)Max. 0.25 V
Auto washer 0.1 A -
Wiper 4.5 A (motor load)
20 A (Lock/Min)Max. 0.8 V
INT 25 mA -
MIST 5 A (motor load) Max. 0.25 V
Hazard warning flasher bezel switch ▶
Item Rated load
Hazard warning flasher switch 12 V-10 A
Rear heated glass switch 12 V-0.1 A
Windshield heated glass switch 12 V-0.1 A
TRIP switch 12 V-0.1 A
Outside rearview mirror control bezel switch ▶
Item Rated load
Outside rearview mirror switch 12 V-2 A
ESP OFF switch 12 V-0.1 A
Mirror folding switch 12 V-0.1 A
Page 519 of 828

06-58610-08
Major Functions of Multifunction Switch (Added functions)
Automatic hazard warning flasher switch
<00470047004700470d960047006900990090008c008d009300a0004700970099008c009a009a00610047006f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c0099004700890093009000950092009a00
47009b008f0099008c008c0047009b00900094008c009a0055>
<00470047004700470d96004700770099008c009a009a004700880095008b0047008f00960093008b00610047006f008800a100880099008b0047009e00880099009500900095008e0047008d00930088009a008f008c009900470089009300900095009200
9a0047009b008c00950047009b00900094008c009a0055>Auto washer switch
Washer fluid is sprayed
on the windshield and
the wiper sweeps off 4
times. Then, the fluid will
be sprayed again and the
wiper will automatically
operate 3 times.
Auto light switch
Front wiper and washer coupled operation
Pull the lever briefly (below 0.6 seconds):
Wiping without washer spray
Pull and hold the lever for more than 0.6 seconds:
Three wiping cylces with washer spray
4WD control switch
Driver's heated
seat switch
Passenger's heated
seat switchAudio remote control switch
Gear shift switch
Front room lamp spot switch
Sun roof switch
Main room lamp switch
Front wiper operation range
(move the wiper lever up/down)
Page 520 of 828

07-37810-01
1. OVERVIEW
The wiper and washer system are controlled by STICS according to driver's wiper switch
operation. And the detection of rain drops by rain sensor is transmitted to STICS as the signal for
wiper system control.
(saem as KYRON)
The characteristics of the wiper and washer system including basic functions of manual wiper are
as follows.
1) Wiper Function Coupled Auto Washer
Pressing the AUTO washer switch with the
ignition key OFF and INT AUTO switch OFF
sprays the washer fluid for 2 sec. and
operates the wiper 4 times and then
immediately sprays the washer fluid for 1.5
sec. and operates the wiper 3 times.
2) Integrated Auto Light Sensor in Rain Sensor Unit
The rain sensor unit is installed on the best
location to detect the rain drops and the
lighting intensity. And an auto light sensor is
newly integrated into the rain sensor unit for
more precise measurements. To control the
system, the sensed values of rain sensor and
auto light sensor are sent to pin no. 63 in
STICS unit. Auto
washer
operation
switch
(press)
Auto light
sensor
photodiode Rain sensor
emitter lens
Page 522 of 828
07-57810-01
Multifunction wiper and washer switchRain sensor unit
2. CONFIGURATION (INCLUDING RAIN SENSOR)
Auto washer switch
Pressing the switch makes washer fluid to be
sprayed for 2 sec. with four wiping, and washer
fluid to be sprayed for 1.5 sec. with three
wiping, with no delay of time
Front nozzle
Installed on both sides of the cowl grille
assembly (one on each side). Sprays
washer fluid in fan-shape to cover the
windshield area as much as possible.
Washer reservoir tank
Tank that supplies washer fluid to front washer
systemIntegrated into the auto light sensor.
Detects and sends amount of rain
drops to STICS
STICS
Front nozzle assembly
Washer reservoir tank assembly
Page 527 of 828

08-38610-09
Multifunction Wiper Switch:
AUTO and Sensitivity Control
1. OVERVIEW
The rain sensing wiper unit system doesn't control the wiper directly. The rain sensing unit
detects the amount of rain drops and sends the operating signal to STICS, and STICS drives the
wiper directly.
Rain Sensing Unit
(AUTO Light Sensor Integrated Type)
A sensor that emits infrared rays through LED
and then detects the amount of rain drops by
receiving reflected rays against sensing
section (rain sensor mounting section on the
windshield) with photodiode. The auto light
sensor is Integrated into the rain sensor (refer
to the below picture).AUTO: Wiper operates automatically by
rain sensor
FAST SLOW: Auto delay/auto speed
control. A position that can control
sensitivity against rains on the windshield
and transmits wiping demand signal
accordingly.
Emitter lens
The LED which is located at
bottom emits the infrared rays
and the lens guides the infrared
rays to target point.
Auto light sensor
Enlarged auto light
sensor section
Auto light sensor(Vertical)
Auto light sensor (Horizon)
Page 528 of 828
08-4
STICS Engine Compartment Fuse Box
STICS ▶
The rain sensing unit detects the amount of rain drops and sends the operating signal to STICS,
and STICS drives the wiper directly. At this moment, STICS determines the wiper operation mode
(washer, MIST, AUTO), then sends the information to the rain sensor.
Auto Light Sensor and Rain Sensor Coupled Control ▶
Rain detected headlamp: If it rains heavy which requires the highest INT speed (almost
LOW), the headlamps are turned on automatically. -
Night detected wiping: When the auto light control turns on the headlamps and the rain
sensor detects the rain, the wiper sensitivity is automatically increased by one level in
comparison with daytime.
(i.e. the AUTO wiper switch is at the 3rd level, but the wiper operates at the 4th level.) -Wiper relay (HI)
Wiper relay (LO)
Page 531 of 828
08-78610-09
3) Sensitivity Control
The wiper LOW relay is turned on and the wiper motor runs one cycle when the volume
<009a008c0095009a0090009b0090009d0090009b00a000470090009a004700900095008a0099008c0088009a008c008b0047004f008c009f00610047009a008c0095009a0090009b0090009d0090009b00a00047005700470d7d0047005800500047009e00
8f00900093008c0047009b008f008c00470090008e00950090>tion switch and the INT switch is
in the "ON" position, and the wiper motor is in "Parked" position). However, the wiper
motor can be operated only when the rain sensor detects the "Rain Detected" signal. 1.
If the volume sensitivity is changed more than 1 stage within 2 seconds, the wiper motor runs
only one cycle.
4) Auto Light Control
Only when the auto light switch is in "AUTO" position, it controls the tail lamp and
headlamp by communicating with the rain sensor (while the ignition key is in "ON"
position). 1.
Page 536 of 828
08-12
Rain detected headlamp: If it rains heavy which requires the highest INT speed (almost
LOW), the headlamps are turned on automatically.
Night detected wiping: When the auto light control turns on the headlamps and the rain
sensor detects the rain, the wiper sensitivity is automatically increased by one level in
comparison with daytime.
(i.e. the AUTO wiper switch is at the 3rd level, but the wiper operates at the 4th level.) 1.
2.
3. OPERATION MODE OF RAIN SENSING WIPER SYSTEM