2011 TOYOTA AYGO Owners Manual

ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE159
MS16014
If the vehicle is going to skid during driv-
ing, the slip indicator light blinks. Special
care should be taken while driving.
The slip indicator light comes on for a few
seconds when the engine switch is turned
to the “ON” position. If the indicator light
does not come on when the engine switch
is turned on, contact any authorized Toyo-
ta dealer or repairer, or another duly qual-
ified and equipped professional.
ST16005
“VSC” warning light
This light warns that there is a problem
somewhere in the vehicle stability control
system or the traction control system.
The light will come on when the engine
switch is turned to the “ON” position and
will go off after a few seconds.
If the light comes on while driving, the
systemdoes not work. However, as con-
ventional braking operates when applied,
there is no problem to continue your driv-
ing.
In the following cases, contact any autho-
rized Toyota dealer or repairer, or another
duly qualified and equipped professional:
DThe warning light does not come on
after the engine switch is turned to the
“ON” position.
DThe warning light remains on after the
engine switch is turned to the “ON”
position.
DThe warning light comes on while driv-
ing.
11 02.18
AYGO WE 99E37E

160ENGINE (IGNITION) SWITCH, TRANSMISSION AND PARKING BRAKE
Parking brake
MS16002b
When parking, firmly apply the parking
brake to avoid inadvertent creeping.
To set: Pull up the lever. For better hold-
ing power, first depress the brake pedal
and hold it while setting the parking
brake.
To release: Pull up the lever slightly (1),
press the lock release button (2), and low-
er (3).
To remind you that the parking brake is
set, the parking brake reminder light in
the instrument cluster remains on until you
release the parking brake.
CAUTION
Before driving, be sure the parking
brake is fully released and the park-
ing brake reminder light is off.
11 02.18
AYGO WE 99E37E

AUDIO SYSTEM161
Section 1−8
OPERATION OF INSTRUMENTS AND
CONTROLS
Audio system
DReference 162............................................
DUsing your audio system 162...............................
DAudio system operating hints 170............................
AYGO WE 99E37E11 02.18

162AUDIO SYSTEM
Reference
MS17001
AM·FM radio/compact disc player (with
compact disc changer controller)
This Section describes some of the basic
features on Toyota audiosystems. Some
information may not pertain to your sys-
tem.
Your audiosystem works when theengine
switch is in the “ACC” or “ON” position.
TURNING THE SYSTEM ON AND OFF
Push “
” (Power) to turn the audio sys-
tem on and off. The audio power can be
turned on only once even when the key
is not in the engine switch. The power,
however, will automatically turn off when
30 minutes have elapsed.
Push “AM/FM” or “CD/AUX” to turn on
that function without pushing “
” (Power).
You can turn on the compact disc player
by inserting a compact disc.
You can turn off each player by ejecting
the compact disc. If the audiosystem was
previously off, then the entire audio sys-
tem will be turned off when you eject the
compact disc. If another function was pre-
viously on, it will come on again.
SWITCHING BETWEEN FUNCTIONS
Push “AM/FM” or “CD/AUX” if the system
is already on but you want to switch from
one function to another.
VOLUME CONTROL
To adjust the volume, push and release
“”or“” side of the “VOL” button.
AYGO WE 99E37E11 02.18
Using your audio system—
—Some basics

AUDIO SYSTEM163
AUDIO CONTROL
This function is to adjust the tone or bal-
ance. Push the “AUDIO CONT” button to
switch to the audio control mode. To
switch to the BAS, TRE, FAD, or BAL,
push the “AUDIO CONT” button. To adjust
each mode, push the “TUNE/TRACK (
)” button.
BAS: Adjusts low−pitched tones
TRE: Adjusts high−pitched tones
FAD: Adjusts the sound balance be-
tween the instrument panel and
front door speakers
BAL: Adjusts the sound balance be-
tween the right and left speakers
YOUR RADIO ANTENNA
To remove an antenna, carefully turn it
counterclockwise.
NOTICE
zTo prevent damage to the antenna,
be sure to remove it before driving
your Toyota through an automatic
car wash.
zWhen storing the vehicle in a ga-
rage, remove the antenna if it
touches the ceiling.
YOUR COMPACT DISC PLAYER
When you insert a disc, gently push it in
with the label side up. The compact disc
player will play from track 1 through to
the end of the disc. Then it will play from
track 1 again.
NOTICE
Never try to disassemble or oil any
part of the compact disc player. Do
not insert anything other than com-
pact discs into the slot.
The player is intended for use with 12 cm
(4.7 in.) disc only.
MS17003
AUX
Portable music players, such as compact
disc and MD players, can be listened to
through the car stereo speakers by con-
necting a player to the AUX port located
on the audio front panel.
AYGO WE 99E37E11 02.18

164AUDIO SYSTEM
—Controls and features
MS17002a
Details of specific buttons, controls and
features are described in the alphabetical
list that follows.
AYGO WE 99E37E11 02.18

AUDIO SYSTEM165
123456(Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in
the desired station. (See “TUNE/TRACK”
button). Push and hold down the button
until you hear a beep—this will set the
station to the button. The button number
will appear on the display.
To recall a preset station: Push the button
for the station you want. The button num-
ber and station frequency will appear on
the display.
These systems can store one AM and
three FM station for each button. (The
display will show “AM”, “FM1”, “FM2” or
“FM3” when you push “AM/FM”.) The pre-
set station memory will be canceled out
if the power source is interrupted. (Battery
disconnected or fuse blown.)
(Eject button)
Push this button to eject a compact disc.
After you turn the engine switch to
“LOCK”, you will be able to eject a com-
pact disc but you will not be able to rein-
sert it.
TUNE/TRACK (Tuning/Track up/down)
Radio
Tuning:
Quickly push and release the “”or“”
button. Each time you push the button,
the radio will step up or down to another
frequency. If you hear a beep, you held
the button too long and the radio will go
into the seek mode.Seeking:
Push and hold the “”or“” until you
hear a beep. The radio will begin seeking
up or down for a station of the nearest
frequency and will stop on reception. Each
time you push the button, the stations will
be searched automatically one after anoth-
er.
Compact disc player
By using this button, you can either skip
up/down to a different track or fast for-
ward/reverse the track you are listening
to.
Skip up/down tracks:
Quickly push and release the “”or“”
button. The track number will appear on
the display. If you hear a beep, you held
the button too long, and the player will
fast forward or reverse a track.
Fast forward/reverse tracks:
Push and hold the “
”or“” until
you hear a beep. While you are holding
the button, the player will fast forward/re-
verse the track. When you release the
button, the player will resume playing.
“
”(Power)
Push “
” to turn the audiosystem on
and off. The audio power can be turned
on only once even when the key is not
in the engine switch. The power, however,
will automatically turn off when 30 minutes
have elapsed.
VOL (Volume)
The volume can be adjusted by pushing
the “”or“” button.
AYGO WE 99E37E11 02.18

166AUDIO SYSTEM
AF (Alternative Frequency)
This button is used for seeking RDS (Ra-
dio Data System) stations all over the
band.
Each time you push “AF”, the AF mode
will change in the following order:
AF on: “AF” appears on the display. In
this mode, the radio switches over to the
broadcasting station providing good recep-
tion within the same PI (Program Identifi-
cation) code.
REG on: “AF REG” appears on the dis-
play. In this mode, the radio switches over
to a broadcasting station providing good
reception within the same local PI (Pro-
gram Identification) code.
To turn the AF function off, push the
switch once again.
AM/FM
Push “AM/FM” to switch between the AM
and FM band. “AM”, “FM1”, “FM2” or
“FM3” will appear on the display.
If the audiosystem is off, you can turn
on the radio by pushing “AM/FM”.
AST (Autostore)
Push “AST” until a beep is heard to auto-
matically preset frequencies of up to 6
radio stations for each band (FM3 and
AM).
If you use the “AST” in the FM mode
(FM1, FM2, FM3), it will be automatically
stored in FM3. For example, even if you
Autostore in FM1, the mode will change
to FM3.
Push “AST” until a beep is heard. If the
radio cannot seek out any stations, it will
receive the frequency before you operate
“AST”.AUDIO CONT (Audio control)
Manual tone adjustment function—
This button is used to adjust the tone
manually.
For low−pitch tone adjustment, push
“AUDIO CONT” repeatedly until “BAS”
appears on the display. Then push the
“”or“” side of the “TUNE/TRACK”
button to suit your preference.
The display will show the range from
“BAS−5” to “BAS +5”.
For high−pitch tone adjustment, push
“AUDIO CONT” repeatedly until “TRE”
appears on the display. Then push the
“”or“” side of the “TUNE/TRACK”
button to suit your preference.
The display will show the range from
“TRE−5” to “TRE +5”.
Sound balance adjustment function—
This button is also to adjust the sound
balance between the front and rear, and
the right and left speakers.
For front/rear adjustment, push “AUDIO
CONT” repeatedly until “FAD” appears on
the display. Then push the “”or“”
side of the “TUNE/TRACK” button to ad-
just the front/rear balance.
The display will show the range from “FAD
F7” to “FAD R7”.
For left/right adjustment, push “AUDIO
CONT” repeatedly until “BAL” appears on
the display. Then push the “”or“”
side of the “TUNE/TRACK” button to ad-
just the left/right balance.
The display will show the range from “BAL
L7” to “BAL R7”.
AYGO WE 99E37E11 02.18