2011 TOYOTA AYGO Owners Manual

OCCUPANT RESTRAINT SYSTEMS103
MS13059
CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.
MS13060
To remove the child seat:
Press the buckle release button and re-
move a locking clip in case of use and
allow the belt to retract completely. The
belt will move freely again and be ready
to work for an adult or older child passen-
ger.
AYGO WE 99E37E11 02.18

104OCCUPANT RESTRAINT SYSTEMS
MS13061a
(C) JUNIOR SEAT INSTALLATION
A junior seat must be used in a for-
ward−facing position only.
MS13074
Move seat
fully back
CAUTION
DAforward−facing child restraint sys-
tem should be allowed to be
installed on the front passenger
seat only when it is unavoidable.
Always move the seat as far back
as possible, because the front pas-
senger airbag could inflate with
considerable speed and force.
Otherwise, the child may be killed
or seriously injured.
DOn vehicles with side airbags or
both side and curtain shield air-
bags, do not allow the child to lean
against the side door or around the
side door even if the child is
seated in the child restraint system.
It is dangerous if the side airbag
inflates, and the impact could cause
death or serious injury to the child.
AYGO WE 99E37E11 02.18

OCCUPANT RESTRAINT SYSTEMS105
MS13062a
To install the junior seat:
Sit the child on a junior seat. Run the lap
and shoulder belt through or around the
junior seat and across the child following
the instructions provided by its manufac-
turer and insert the tab into the buckle
taking care not to twist the belt.
Make sure the shoulder belt is correctly
across the child’s shoulder and that the
lap belt is positioned as low as possible
on the child’s hips. See “Seat belts” on
page 48 for details.
CAUTION
DAlways make sure the shoulder belt
is positioned across the center of
child’s shoulder. The belt should be
kept away from child’s neck, but
not falling off child’s shoulder.
Otherwise, the child may be killed
or seriously injured in the event of
sudden braking, sudden swerving or
an accident.
DBoth high−positioned lap belts and
loose−fitting belts could cause
death or serious injuries due to
sliding under the lap belt during a
collision or other unintendedevent.
Keep the lap belt positioned as low
on a child’s hips as possible.
DFor child’s safety, do not place the
shoulder belt under child’s arm.
DAfter inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
DDo not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.
DIf the seat belt does not function
normally, it cannot protect your
child from death or serious injury.
Contact any authorized Toyota deal-
er or repairer, or another duly quali-
fied and equipped professional, im-
mediately. Do not install the child
restraint system on the seat until
the seat belt is fixed.
AYGO WE 99E37E11 02.18

106OCCUPANT RESTRAINT SYSTEMS
MS13063
To remove the junior seat:
Press the buckle release button and allow
the belt to retract.
MS13066c
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
AYGO WE 99E37E11 02.18
—Using a top strap
(with rear seats)

OCCUPANT RESTRAINT SYSTEMS107
MS13073b
Anchor brackets
Use the anchor brackets behind the seat-
backs to attach the top strap.
Anchor brackets are installed for both
seating positions.
This symbol indicates the locations of the
anchor brackets.
MS13067a
TO USE THE ANCHOR BRACKET:
1. Move up the head restraint.
AYGO WE 99E37E11 02.18

108OCCUPANT RESTRAINT SYSTEMS
MS13068d
2. Fix the child restraint system with
the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see “Child restraint” on
page 80 in this Section.
CAUTION
DMake sure the top strap is securely
latched, and check that the child
restraint system is secure by push-
ing and pulling it in different direc-
tions.
DFollow all the installation instruc-
tions provided by its manufacturer.
MS13069a
3. Move down the head restraint.
AYGO WE 99E37E11 02.18

OCCUPANT RESTRAINT SYSTEMS109
MS13070
The rear seat is equipped with a fixing
bar for use exclusively with child re-
straint systems that conform to ISO
specifications.
The bars are installed in the clearance
between the seat cushion and seatback of
both rear seats.
Child restraint systems usingquasi−ISO
specifications can be fixed to these exclu-
sively with fixing bars. In this case, it is
not necessary to fix the child restraint
system with a seat belt on the vehicle.
NOTICE
Ask the manufacturer of the child re-
straint system if the child restraint
system is approved for this model.
MS13071b
CHILD RESTRAINT SYSTEM
INSTALLATION
1. Widen the gap between the seat
cushion and seatback slightly and
confirm the position of the exclusive
fixing bars below the tag on the
seatback.
2. Latch the buckles onto the exclusive
fixing bars. If necessary, also move
the front seats forward.
For installation details, refer to the instruc-
tion manual supplied with each product.
AYGO WE 99E37E11 02.18
—Installation with ISOFIX rigid
anchor (ISOFIX child restraint
system) (with rear seat)

11 0OCCUPANT RESTRAINT SYSTEMS
CAUTION
DWhen using the exclusive fixing bar
for the child restraint system, be
sure that there are no irregular ob-
jects around the bars or that the
seat belt is not caught.
DPush and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
DDo not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in the event of
sudden braking, sudden swerving or
an accident.
AYGO WE 99E37E11 02.18