2010 JAGUAR XFR Bolt

7.
















8.
9.
10. Torque: 25 Nm

















NOTE: Tighten the bolts in the indicated sequence.

Torque: 12 Nm













CAUTIONS:


If a new cylinder head has been installed then new
tappets must be installed.


If the cylinder head is being removed without a new
component being installed, the tappets must be installed in
their original positions.
Lubricate the valve tappets with clean engine oil.







Torque: 10 Nm

20.



































21. CAUTION: Discard the bolts.



































NOTE: Discard the gasket.

3. CAUTION: Make sure that new cylinder head bolts are
installed.
Torque: 20 Nm






























4. Torque: 35 Nm

5.
6. CAUTION: Discard the bolt.

NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.












7.
8.

9.
10.

11.
12.
























































CAUTION: Discard the bolts.

NOTES:


Discard the gasket.


Make sure that the position of the spacers is noted
before removal of the manifold. www.JagDocs.com

3. NOTE: If a new cylinder head is installed use the
special tools in the illustration.
Special Tool(s): 303-1444-02












4. CAUTION: Make sure that new bolts are installed.
NOTE: Install the spacers in the noted position.
Torque: 10 Nm










5. Remove the special tool.
6. CAUTION: Make sure that new bolts are installed.
NOTE: Install the spacers in the noted position.
Torque: 10 Nm

7.

8.

9.
10. Torque: 18 Nm



































Torque: 100 Nm

















WARNING: Make sure that a new bolt is installed.


NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 35 Nm

5.
6.
All vehicles

7.
CAUTION: Discard the bolt.

Torque: 35 Nm













Torque: 100 Nm



















Torque: 12 Nm