Page 3020 of 3039
20.
21. NOTE:
Note the fitted position of each bolt, mark the washers and sub-frame before removal to aid assembly.
CAUTION:
Make sure the wheel knuckle is supported. Failure to follow these instructions may result in damage to the vehicle.
NOTE:
Note the fitted position of each bolt, mark the washers and sub-frame before removal to aid assembly.
22. General Equipment: Powertrain Jack
Page 3022 of 3039
1. CAUTION: Only tighten the bolts finger-tight at this stage.
2. CAUTION: Tighten the bolts in the sequence shown.
Torque:
Bolt 1 63 Nm Bolt 2 63 Nm Bolt 1 63 Nm
3. Torque: 12 Nm www.JagDocs.com
Page 3025 of 3039
10. Remove the special tool.
Special Tool(s): 502-005
11.
Torque:
Stage 1: 100 Nm Stage 2: 270°
12. CAUTION:
Make sure each bolt aligns with the removal markings.
Torque: 175 Nm
Page 3026 of 3039
13. CAUTION:
Make sure each bolt aligns with the removal markings.
Torque: 175 Nm
14.
15.
NOTE: Repeat the step for the other side.
Torque: 175 Nm
Torque: 43 Nm
Page 3036 of 3039
14.
15. WARNING: Install the M12 subframe bolts prior to
removing axle support.
NOTE: LH illustration shown, RH is similar.
Torque: 133 Nm
Page 3037 of 3039
Installation
16.
17.
CAUTION: Make sure that new bolts are installed.
General Equipment: Powertrain Jack Torque:
Stage 1:80 Nm Stage 2:240°
1. To install, reverse the removal procedure.
2. Refer to: Brake System Bleeding (206-00 Brake System - General Information, General Procedures).
3. Refer to: Camber and Caster Adjustment (204-00 Suspension System - General Information, General Procedures). www.JagDocs.com
