2008 AUDI A4 AVANT Owners Manual

Emergency situations -
----------------=-=---
Rear hook up
These s te p s app ly fo r w in chi ng the vehi cle on to a car
c arr ier w ith the re a r f ir st.
- Have the vehic le ali gne d cent ered wi th the ca r carr ier
r a mp.
- Attach the win ch hook to t he
rear to wline eye
=> pa ge 334, fig. 237 .
- On ce th e ca r is po sit io ned on t he car ca rrie r, ha ve safety
c hain (s ) a ttach ed t o the
fron t towline eye => pag e 333an d
ti ghte ned .
[ i] Tips
Chec k carefu lly to ma ke sure the veh icle is hoo ked up securel y
b ef ore mov ing the ca r up the ca r ca rrier r amp. •
Lifting the vehicle
Important safety precautions
Be aware of the following hazards before l ift ing the vehic le w ith a
w ork sho p ho is t or f lo or jack :
• The vehicle should never be lifted or jacked up from underneath
the engine oil pan, the transmission housing , the front or rear axle
or the body side members . This could lead to serious damage.
• Use lifting equipment with padded contact surfaces to avoid
damage to the underbody or chassis frame.
• Alternatively, cover the contact surfaces on workshop hoist or
floor ja ck with rubber pads before lifting.
• Before driving over a workshop hoist , check that the vehicle
weight does not exceed the permissible lifting capacity of the hoist. •
Before driving over a workshop hoist , ensure that there is suffi ­
cient clearance between the hoist and low parts of the vehicle .
& WARNING
To reduce the risk of serious injury and vehicle damage:
• Always lift the vehicle only at the special workshop hoist and
floor jack lift points illustrated
=> fig . 239 and => fig . 240 .
• Failure to lift the vehicle at these points could cause the vehicle
to tilt or fall from a lift if there is a change in vehicle weight distri­
bution and balance . This might happen, for example, when heavy
components such as the engine block or transmission are
removed .
• When removing such heavy components, anchor vehicle to
hoist or add corresponding weights to maintain the center of
gravity . Otherwise , the vehicle might tilt or slip off the hoist ,
causing serious personal injury .
•
Do-it -yourself service

lll9....__E_ m_ e_ r
-' g==-- e_n _c_ y,__ s_ i_ t _u _a _ t_ i_o _n _ s _____________________________________________ _
Lifting points for workshop hoist or floor jack
If you must lift your vehicle with a floor jack to work
underneath, be sure the vehicle is safely supported on
stands designed for this purpose.
Lifting points, front and rear
~ w 00 CD
Fig. 239 Driver's side:
front lifting point
behind forward wheel
well
Fig . 240 Driver's side:
rear lifting point ahead
of rear wheel well
The positions of the front and rear lifting points are indicated by
small
raised triangular markings below the door sill on either side . The lifting points themselves are located on the floor pan reinforce­
ment ribs running along the length of the car.
Lifting with vehicle jack
Refer to=> page 321. •
Lifting with workshop hoist and with floor
jack
- Use lifting equipment with padded contact surfaces to
avoid damage to the underbody or chassis frame.
- Alternatively, cover the contact surfaces on workshop hoist or floor jack with rubber pads before lifting.
- Read and heed WARNING ::}
& in "Important safety
precautions" on page
335.
-Locate the proper lifting points ~ page 336, fig. 239 and
=} page 336, fig. 240 .
- Adjust the lifting arms of the workshop hoist or floor jack to align with the lifting points.

Emergency situations -----------------=-=----
Do-it -yourself service

-~
... ,

~­
) -
\\ ­
ca.........._
o.\'?:>
\.~ 0:.. 'I

ffl,...__G_ e_ n_ e_r_a _ l_ i
_ n_ f_ o_ rm_ a
_ t_io _ n _______________________________________________ _
General information
Explanation of technical data
Some of the technical data listed in this manual require
further explanation.
The technical da ta for your vehicle are listed in the charts starting
on => page 343. This chapter p rovides general information, notes
and restrictions which apply to these data. •
Vehicle identification
The key data ore given on the vehicle identification
number (VIN) plate and the vehicle data sticker.
Fig . 241 Vehicle Identi­
fication Number (VIN)
plate: location on
driver's side dash
panel Fig
. 242 The vehicle
identification label
-
inside the luggage
compartment
The Vehicle Identification Number (VIN}
is located on the driver's side so that it is visible from the outside
through the windshield -
see:::::, fig. 241.
The vehicle identification label
is located in the luggage compartment in the spare wheel well.
The
label => fig. 242 shows the following vehicle data:
G) Production control no.
0 Vehicle identification no .
© Type code number
© Type designation/engine output in Kilowatts
© Engine and transmission code letter
© Pain t no./lnt erior
0 Optional equipment no.'s
Vehicle data 2 to 7 are also found in your Maintenance
& Warranty
booklet .
..,.

_________________________________________________ G_ e_ n_ e_r _a _l_ i_n _f_o _ r_ m_ a_ t
_ i
_ o _ n
__ __
T he sa fe ty co mplia nce s ticke r
is your assurance t hat your new vehicle complies with a ll applicable
Federa l Motor Vehic le Safety Standards which were in effect at the
t ime the veh ic le was manufactured . You can find t his st icker on the
left door jamb. It shows the mon th and year of production and the
vehic le identification number of your vehic le (perforation) as well as
the Gross Veh icle Weight Rating (GVWR) and the Gross Axle Weight
Rating (GAWRl.
Th e high volt ag e wa rning la bel
is located on the lock carrier .
The spark ignition syste m mee ts all requirement s of the Canadi an
Interf ere nc e-C au si ng Equipm ent Regulati ons. •
Weights
Gross Veh icle Weight R ating
The G ross Veh ic le Weight Rat ing (GVWR), and the Gross Ax le Weight
Rating (GAWR) for front and rear are listed on a sticker on the left
door jamb .
The Gross Vehicle Weight Rating includes the we ight of the basic
vehic le plus fu ll fuel tank, oil and coolant, plus maximum load,
whic h inc ludes passenger weight ( 150 lbs/68 kg per designated
seating position) and luggage weight.
Gr oss Axle Weight Ra ting
The Gross Ax le Weight Rating is the maximum load that can be
app lied at each axle of the
veh ic le =:> & .
Vehicl e cap acit y w eight
The vehicle capacity weight (max. load) is listed either on the
driver's side 8 -pillar or inside the fuel fi ller f lap .
Controls and equip­
ment Safety first Vehicle operation
Roof
weight
The maximum permissible roof we ight is
165 lb (75 kg ). The roof
weight is made up of the weight of the roof rack system and the
weight of the object being
transported =:> page 117, "L oading the
roof rack".
LJ}. WARNING
• The actual Gr oss Axle Weight R atin g at the front and re ar ax les
s hould not ex ceed the permi ssible w eight s, and th eir combination
mu st not e xceed the Gr oss Vehicle Weight R atin g.
• Exceeding pe rmi ssible weight ratin gs can re sult in vehicle
d am age , acc ident s and per son al inju ry.
0 Note
• The vehicle capacity weight figures apply when the load is
distr ibuted even ly in t he ve hicle (passengers and l uggage). When
transporting a heavy load in the luggage compartment, carry the
load as near to the rear axle as possib le so that the vehic le's
handling is not impaired .
• Do not exceed the maxim um permissib le axle loads or the
maximum gross vehic le weight. Always remember that the vehic le's
handling wi ll be affected by the extra load . Therefore, adjust your
speed according ly.
• Always observe local reg ulations. •
Dimensions
The specifications refer to the basic mode l. Differences may occur
depending on the mode l type and options ordered, for example, tire
sizes.
..,
Vehicle care Do-it-yourself service Technical data

llffl __ G_ e_n_ e_ r_
a _l _i_n _f _o _ r_ m_ a_ t_ i_ o _ n ________________________________________________ _
0 Note
When driving up steep ramps, on rough roads, over curbs, etc. it is
important to remember that some parts of your vehic le, such as
spo ilers or exhaust system components, may be c lose to the
ground . Be careful not to damage them .•