2006 BMW MOTORRAD K 1200 S lock

Press bulb4into socket 5
and turn it clockwise to in-
stall.
Turn bulb socket 3clock-
wise to install it in the bulb
housing. Seat the bulb housing in
holders
2.
Install screw 1.
Installing the seat ( 54)
Replacing front turn
indicator bulbs
If it is not standing firmly,
the motorcycle could
topple in the course of the
operations described below.
Always make sure that the
motorcycle is stable and
firmly supported.
Make sure the ground is
level and firm and place the
motorcycle on its stand.
Switch off the ignition.
Remove screw 1.
7115zMaintenance

Pull the bulb housing out
of the mirror housing at the
threaded-fastener side.
Remove the bulb holder2
from the bulb housing by
turning it counter-clockwise. Remove bulb
3from the
bulb holder.
Replace the defective bulb
Front flashing turn in-
dicator bulbs
W16W / 12 V / 16 W
Install bulb 3in bulb sock-
et 2.
Turn the bulb socket clock-
wise to install it in the bulb
housing. Seat the bulb housing in the
mirror shell.
Install screw
1.
7116zMaintenance

Replacing rear turn
indicator bulbs
If it is not standing firmly,
the motorcycle could
topple in the course of the
operations described below.
Always make sure that the
motorcycle is stable and
firmly supported.
Make sure the ground is
level and firm and place the
motorcycle on its stand.
Switch off the ignition.
Remove screw 1. Pull the glass out of the
turn-indicator housing at the
threaded-fastener side.
Press bulb
2into fitting 3
and remove by turning it
counter-clockwise. Replace the defective bulb.
Rear flashing turn in-
dicator bulbs
R10W / 12 V / 10 W
Press bulb 2into socket 3
and turn it clockwise to in-
stall.
7117zMaintenance

Run the engine of the donor
vehicle during jump-starting.
Begin by connecting one
end of the red jump lead
to the positive terminal of
the discharged battery and
the other end to the pos-
itive terminal of the donor
battery.
Then connect one end of
the black jump lead to the
negative terminal of the
donor battery, and the other
end to the negative terminal
of the discharged battery.
Start the engine of the
vehicle with the discharged
battery in the usual way; if
the engine does not start,
wait a few minutes before
repeating the attempt
in order to protect the
starter motor and the donor
battery.
Allow both engines to idle
for a few minutes beforedisconnecting the jump
leads.
Disconnect the jump lead
from the negative termin-
als first, then disconnect the
second lead from the posit-
ive terminals.
Installing battery-
compartment cover
( 121)
BatteryMaintenance instructionsCorrect upkeep, recharging
and storage will prolong the
life of the battery and are es-
sential if warranty claims are
to be considered.
Compliance with the points
below is important in order to
maximise battery life:
Keep the surface of the bat-
tery clean and dry
Do not open the battery
Do not top up with water Be sure to read and com-
ply with the instructions for
charging the battery on the
following pages
Do not turn the battery up-
side down
If the battery is not dis-
connected, the on-board
electronics (e.g. clock, etc.)
gradually drain the battery.
This can cause the battery
to run flat. If this happens,
warranty claims will not be ac-
cepted.
If the motorcycle is to be out
of use for more than four
weeks, disconnect the battery
or connect a suitable trickle
charger to the battery.
BMW Motorrad has de-
veloped a trickle-charger
specially designed for com-
patibility with the electronics
of your motorcycle. Using this
charger, you can keep the
7119zMaintenance

Installing battery-
compartment cover
( 121)
Switch on the ignition.
Fully open the throttle once
or twice.
The engine management
system registers the
throttle-valve position.
Set the clock ( 42)
7123zMaintenance

Riding specificationsTop speed>200 km/hClutchClutch typeMultiplate clutch running in oil bathTransmissionGearbox typeClaw-shift 6-speed cassette gearbox, integ-
rated into engine block
9137zTechnical data

A
Abbreviations and symbols, 6
Anti-theft alarm, 17
B
BatteryCharging battery when
connected, 120
Charging battery when
disconnected, 121
Installation, 121, 122
Removal, 121, 122
Technical data, 141
Warning, battery charge
current, 26
Brake fluid Checking level, front, 94
Checking level, rear, 95
Brake pads Checking front, 92
Checking rear, 93
Brakes Technical data, 140
Breakdown assistance kit, 85 Bulbs
General instructions, 108
Replacing brake-light
bulbs, 113
Replacing front turn
indicator bulbs, 115
Replacing high-beam
headlight bulb, 111
Replacing low-beam
headlight bulb, 109
Replacing parking-light
bulb, 113
Replacing rear light
bulbs, 113
Replacing rear turn indicator
bulbs, 117
Technical data, 142
Warning, bulb failure, 27
C
Case Adapting, 84
Adjusting, 82
Closing, 82
Installing, 84 Opening, 82
Removing, 83
Checklist, 66
Clock, 20 Adjusting, 42
Clutch Fluid reservoir, 11, 13
Technical data, 137
Confirmation of maintenance work, 149
E
Electrics Technical data, 141
Emergency off switch (kill switch), 16, 48
Engine Technical data, 134
Temperature gauge, 20, 21
Warning, engine electron-
ics, 25
Engine oil Checking level, 89
Draining, 91
Technical data, 136
11156zIndex

M
MaintenanceGeneral instructions, 88
Intervals, 147
Multifunction display, 17, 20
O
Odometer and tripmeters, 20 Operation, 41
Pushbutton, 15
Resetting tripmeter, 42
Selecting readings, 41
On-board computer Ambient temperature, 45
Average consumption, 46
Average speed, 45
Oil level, 47
Pushbutton, 15
Range, 47
Reset average consump-
tion, 46
Resetting average
speed, 46
Selecting readings, 44 P
Power socket, 11, 13
Pre-ride check, 67
R
Rear-wheel stand
Installing, 107
Refuelling, 71
Reserve Warning, 24
Residual range, 42
Restoring to use, 129
Rev. counter, 17
Rims Test, 97
Running gear
Technical data, 139
S
Seat Installation, 54
Lock, 11, 13
Removal, 53
Service, 146
Service Card, 147 Side stand
Starting the engine, 66
Spark plugs, 142
Speedometer, 17
Spring preload, rear Adjusting, 11, 13, 57
Starter, 16
Steering lock, 39
Suspension damping, rear Adjusting, 11, 13, 58
T
Technical data Battery, 141
Brakes, 140
Bulbs, 142
Clutch, 137
Electrics, 141
Engine, 134
Engine oil, 136
Final drive, 139
Frame, 143
Fuel, 135
Running gear, 139
Spark plugs, 142
11158zIndex