2005 NISSAN X-TRAIL warning

oil level adblue reset coolant temperature wheel alignment brake rotor key battery

Page 4153 of 4555

NISSAN X-TRAIL 2005 Service Repair Manual COMBINATION METERS
DI-5
C
D
E
F
G
H
I
J
L
MA
B
DI

TACHOMETER
The tachometer indicates engine speed in revolutions per minute (rpm).
ECM provides an engine speed signal to combination meter for tacho

COMBINATION METERS
DI-5
C
D
E
F
G
H
I
J
L
MA
B
DI

TACHOMETER
The tachometer indicates engine speed in revolutions per minute (rpm).
ECM provides an engine speed signal to combination meter for tachometer with CAN communication line.
SPEEDOMETER
ESP/TCS/ABS control unit (with ESP) or ABS actuator and electric unit (without ESP) provides a vehicle
speed signal to the combination meter for the speedometer with CAN communication line.
FUEL GAUGE
The fuel gauge indicates the approximate fuel level in the fuel tank.
The fuel gauge is regulated by a variable ground signal supplied
from grounds B8 and B18 (LHD models)
from grounds B107 and B119 (RHD models)
through terminal 1 and 4 of the fuel level sensor unit
through terminal 3 and 1 of the sub fuel level sensor unit and
to combination meter terminal 8 for the fuel gauge.
AMBIENT TEMPERATURE INDICATOR
The ambient temperature is indicated by the signal from ambient sensor.
Combination meter inputs voltage conversed from resistance which ambient sensor detects.
Indication range is between −30 and 55 °C (−22 and 131 °F). When ambient air temperature is less than −30
°C (−22 °F) or more than 55 °C (131 °F), display shows “---°C”. When indicated temperature becomes less
than 3 °C (37 °F), ambient temperature indicator flashes as a sign of warning.
Without Auto A/C
Power is supplied
through combination meter terminal 27
to ambient sensor terminal 1.
Ground is supplied
to combination meter terminal 28
through ambient sensor terminal 2.
Signal is supplied
through ambient sensor terminal 1
to combination meter terminal 27.
With Auto A/C
Power is supplied
through auto amp terminal 9
to ambient sensor terminal 1.
Ground is supplied
to combination meter terminal 28 and auto amp terminal 24
through ambient sensor terminal 2.
And combination meter receives ambient sensor signal from ambient sensor
through ambient sensor terminal 1
to combination meter terminal 27.
NOTE:
Combination meter distinguishes whether or not the combination meter terminal 29 receives voltage (auto A/C
recognition signal) from auto amp terminal 28. If the terminal receives, combination meter discerns as auto A/
C.
Indication When Turning Ignition Switch OFF
In a case that temperature detected by ambient sensor is higher than indicated temperature before turn-
ing ignition switch OFF.
–In a case of more than 3.5 hours after turning ignition switch OFF, temperature detected by ambient sen-
sor is indicated when turning ignition switch ON.