2005 Lexus IS300 Basic Functions / LEXUS 2005 IS300 OWNER'S MANUAL (OM53489U)

OCCUPANT RESTRAINT SYSTEMS
96
Seat adjustment precautions
CAUTION
Do not adjust the seat while the vehicle is moving as
the seat may unexpectedly move and cause the
driver to lose control of the vehicle.
 Be careful that the seat does not hit a passenger,
luggage or the rear seat.
NOTICE
Do not operate the control switch in more than one
dimension at a time. It may cause electrical overload.
Adjusting front seats
SV16001

1Seat position control switch, seat cushion angle and
height control switch
2Seatback angle control switch
04 06.30

OCCUPANT RESTRAINT SYSTEMS
97
Adjusting seat position
SV16002
Move the control switch in the desired direction.
Releasing the switch will stop the seat in that position. Do not
place anything under the seat, as this might interfere with the
seat movement.
Adjusting seatback angle
SV16003
Move the control switch in the desired direction.
Releasing the switch will stop the seatback in that position.
CAUTION
Avoid reclining the seatback any more than needed. The
seat belts provide maximum protection in a frontal or
rear collision when the driver and the front passenger
are sitting up straight and well back in the seats. If
he/she is reclined, the lap belt may slide past his/her
hips and apply restraint forces directly to the abdomen
or your neck may contact the shoulder belt. In the event
of a frontal collision, the more the seat is reclined, the
greater the risk of death or personal injuly.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
98
Adjusting seat cushion angle and height
SV16063
Move the control switch in the desired direction.
Releasing the switch will stop the seat cushion in that position.
Folding down front passenger's seatback
SV16080
Return the seatback to the up±right position. Pull up the
side levers and fold the seatback down.
SV16081
You can use the front passenger's seatback as a temporary
table only when the vehicle is stopped.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
99
CAUTION
To avoid serious injury:
Do not set up the seatback table while the vehicle is
moving.
 Do not sit on the folded seatback.
 Make sure the front passenger's seat is securely
locked in sliding position when you set the front pas-
senger's seat as a temporary table.
NOTICE
To prevent damage to the seat, avoid putting heavy
loads on the temporary table.
FRONT SEATS
(MANUAL TYPE)
Front seat precautions
Driver seat
CAUTION
The SRS driver airbag deploys with considerable force,
and can cause death or serious injury especially if the
driver is very close to the airbag. The National Highway
Traffic Safety Administration (ªNHTSAº) advises:
Since the risk zone for driver airbag is the first 50Ð75
mm (2Ð3 in.) of inflation, placing yourself 250 mm (10
in.) from your driver airbag provides you with a clear
margin of safety. This distance is measured from the
center of the steering wheel to your breastbone. If you
sit less than 250 mm (10 in.) away now, you can change
your driving position in several ways:
 Move your seat to the rear as far as you can while still
reaching the pedals comfortably.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
100
Slightly recline the back of the seat. Although vehicle
designs vary, many drivers can achieve the 250 mm
(10 in.) distance, even with the driver seat all the way
forward, simply by reclining the back of the seat
somewhat. If reclining the back of your seat makes it
hard to see the road, raise yourself by using a firm,
non±slippery cushion, or raise the seat if your vehicle
has that feature.
 If your steering wheel is adjustable, tilt it downward.
This points the airbag toward your chest instead of
your head and neck.
The seat should be adjusted as recommended by
NHTSA above, while still maintaining control of the foot
pedals, steering wheel, and your view of the instrument
panel controls.
Front passenger seat
CAUTION
The SRS front passenger airbag also deploys with
considerable force, and can cause death or serious
injury especially if the front passenger is very close to
the airbag. The front passenger seat should be as far
from the airbag as possible with the seatback adjusted,
so the front passenger sits upright.
Front seats
CAUTION
The SRS side airbags are installed in the driver and front
passenger seats. Observe the following precautions.
 Do not lean against the front door when the vehicle
is in use, since the side airbag inflates with
considerable speed and force. Otherwise, you may
be killed or severely injured.
 Do not use seat accessories which cover the area
where the side air bags inflate. Such accessories may
prevent the side airbags from activating correctly,
causing death or serious injury.
 Do not modify or replace the seats or upholstery of
the seats equipped with side airbags. Such change
may prevent the side airbag system from activating
correctly, disable the system, or cause the side
airbags to inflate accidentally, resulting in death or
serious injury.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
101
Seat adjustment precautions
CAUTION
Do not adjust the seat while the vehicle is moving as
the seat may unexpectedly move and cause the
driver to lose control of the vehicle.
 Be careful that the seat does not hit a passenger,
luggage or the rear seat.
 After adjusting the seat position, release the lever
and try sliding the seat forward and backward to
make sure it is locked in position.
 After adjusting the seatback, push your body against
the seat to make sure it is locked in position.
 Do not put objects under the seats. Otherwise, the
objects may interfere with the seat±lock mechanism
or unexpectedly push up the seat position adjusting
lever and the seat may suddenly move, causing the
driver to lose control of the vehicle.
 While adjusting the seat, do not put your hands under
the seat or near the moving parts. Otherwise, your
hands or fingers may be caught and injured.
Adjusting front seats
SS16001

1Seat position lock release lever
2Seat cushion front edge angle adjusting knob
3Seat cushion height adjusting knob
4Seatback angle lock release lever
04 06.30

OCCUPANT RESTRAINT SYSTEMS
102
Adjusting seat position
SS16003
Hold the center of the lever and pull it up. Then slide the
seat to the desired position with slight body pressure and
release the lever.
Adjusting seatback angle
SS16005
Lean forward and pull the lever up. Then lean back to the
desired angle and release the lever.
CAUTION
Avoid reclining the seatback any more than needed. The
seat belts provide maximum protection in a frontal or
rear collision when the driver and the front passenger
are sitting up straight and well back in the seats. If
he/she is reclined, the lap belt may slide past his/her
hips and apply restraint forces directly to the abdomen
or your neck may contact the shoulder belt. In the event
of a frontal collision, the more the seat is reclined, the
greater the risk of death or personal injury.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
103
Adjusting seat cushion height
SS16007
Turn the knob either way.
Adjusting seat cushion front edge angle
SS16009
Turn the knob either way.
04 06.30