2005 CITROEN C6 warning

Downloaded from www.Manualslib.com manuals search engine AXLES
SUSPENSION
STEERING
129
A < B = Positive figure: + = TOE-IN
A > B = Negative figure: - = TOE-OUTNOTE
VALUES FOR CHECKING AND ADJUSTING AXLE GEOMETRIES
IMPERATIVE: Respect the safety and cleanliness requirements.
Tools.
[1]Gauge for measuring radius of wheels (5 bolts): 9801-T
[2]Gauge for height under bodyshell: 2305-T
WARNING: «Check and adjust the axle geometries at referenceheight».
Conditions for checking and adjusting.
Check the tyre pressures.
Place the vehicle on a 4 column lift.
Check and adjust if necessary the vehicle heights (see corresponding
operation).
Steering rack locked at its zero point (see corresponding operation).
Switch off the ignition before removing the tools from the wheels.
Lower the vehicle.
Start the engine.
Put the vehicle in the high position.
Put the vehicle in the normal height position (driving height).
Stop the engine.
Switch on the ignition.
Check and adjust the front and rear axle geometries at reference
height.
WARNING: Do not switch off the ignition during checking and
adusting of the front and rear axle geometries.
NOTE:Front of vehicle (following the arrow).
B3CP02UC
Angl-C6-page121-169-2005 4/02/05 17:31 Page 129

Downloaded from www.Manualslib.com manuals search engine AXLES
SUSPENSION
STEERING
132
VALUES FOR CHECKING AND ADJUSTING AXLE GEOMETRIES
Warning: During measuring of PARKING heights: Switch off the ignition
Front and rear PARKING heights(ignition switched off)
Rear axle Front axle
PARKING heights: (values given AS A GUIDE only)
Front LH: K1 = 175 ± 6 mmFront RH: K2 = 175 ± 6 mmRear LH: K3 = 131 ± 6 mmRear RH: K4 = 131 ± 6 mmB3CP0ARD
B3CP0ATD
Angl-C6-page121-169-2005 4/02/05 17:31 Page 132

Downloaded from www.Manualslib.com manuals search engine 155
AXLES
SUSPENSION
STEERING
Tools.
[1]Pliers for clic clips: 4121-T
[2] LEXIAdiagnostic tool: 4171-T
[3] PROXIAdiagnostic tool: 4165-T
Draining.
Start the engine.
Place the vehicle in the low position.
Stop the engine.
Raise and support the vehicle, wheels hanging.
WARNING: The LDS fluid reservoir is pressurised.
Open the cap of the LDSfluid reservoir.
Remove:
- The front RH wheel.
- The front RH splash-shield.
Remove the clip (1) using tool [1].
Uncouple the hose (2)from the LDSfluid reservoir.
Drain the LDSfluid reservoir.
IMPERATIVE: Any LDS fluid recovered must not be re-used.
B3FP7HED
DRAINING, FILLING AND BLEEDING THE HYDRAULIC SUSPENSION/STEERING CIRCUIT
Angl-C6-page121-169-2005 4/02/05 17:31 Page 155

Downloaded from www.Manualslib.com manuals search engine 170
BRAKES
3.0i 24S 2,7 24S
ES9A DT17BTED4
23,8 / 19,8/20,2/AFU (1)
254 / TEVES / AMCT / AFT(2)
TRW / C II 40 + 45 WE - 30-12 PE / 40 et 45
330
30/28
JURID-966 (with wear warning lamps)
TRW / C38 HR-PEX / 38
302
22/20
GALFER / G4555
BRAKE SPECIFICATIONS
Master cylinder/diameter/travel
Amplifier/supplier/type
FTSupplier/type/piston diameter
Disc diameter Ventilated
Disc thickness/min. thickness
Brake pad grade
Caliper/supplier/type/piston diameter
RRDisc diameter Ventilated
Disc thickness/min. thickness
Brake pad grade
Engine plate(1) AFU= Emergency braking assistance.
(2) AFT =Automatic lighting of hazard lamps under emergency braking.
Angl-C6-PAGE170-194-2005 4/02/05 17:35 Page 170

Downloaded from www.Manualslib.com manuals search engine 173
BRAKES
C5FP0T8C
BRAKING SYSTEM: GENERAL SPECIFICATIONS
(1)Electrically-controlled parking brake system(FSE)
(2)Parking brake cables
(3)Cable for manual unlocking of the electric parking brake (FSE).
WARNING: It is forbidden to open the electric parking brake system in After Sales. If a
malfunctioning of the electric parking brake is diagnosed, it is necessary to replace it.
Changing of the parking brake cables does not necessitate opening of the electric parking
brake system (see corresponding operation).
(4)Handle for manual unlocking of the electric parking brake (FSE)
(5)Switch for the electric parking brake (FSE)
If it is impossible to release the electric parking brake, a handle (4)located in the front central
armrest will mechanically unlock the electric parking brake.
Parking brake
B3FP7GDD
Angl-C6-PAGE170-194-2005 4/02/05 17:35 Page 173

Downloaded from www.Manualslib.com manuals search engine 179
BRAKES
GENERAL FEATURES OF ELECTRIC PARKING BRAKE
Presentation.
(6)Electric parking brake control
"a" Parking brake warning lamp
Functioning of the electric parking brake.
To apply the parking brake:
Prior conditions:
- Vehicle stationary or not.
- Ignition switched on.
- Engine running or not.
Pull and release the control (6).
NOTE: The parking brake can be activated when the vehicle is moving, at whatever speed, but
only if the control (6)is kept pulled, the parking brake being deactivated as soon as the control (6)
is released.
NOTE:The electric parking brake has an"anti-lock"system for limiting the locking of the wheels
and guaranteeing vehicle stability if the parking brake is actioned while the vehicle is moving.
To release the parking brake:
Prior conditions:
- Vehicle stationary.
- Gear lever in positionP.
- Ignition switched on.
- Engine running.
Press on the brake pedal.
Pull and release the control (6).
Parking brake warning lamp:
Condition for the warning lamp "a" coming on:
- Electric parking brake activated or incorrectly deactivated.
- Malfunctioning of the electric parking brake.
B3FP7HWDC5FP0W3D
Angl-C6-PAGE170-194-2005 4/02/05 17:35 Page 179

Downloaded from www.Manualslib.com manuals search engine 180
BRAKES
GENERAL FEATURES OF ELECTRIC PARKING BRAKE
Presentation.
(1)Handle for manual unlocking of the electric parking brake (FSE)
(2)Cable for manual unlocking of the electric parking brake
(3)Rear RH cable of the electric parking brake
(4)Electric parking brake system (FSE)
(5)Rear LH cable of the electric parking brake
(6) Electric parking brake control
"a"Parking brake warning lamp
Normal functioning of the electric parking brake.
Applying the parking brake.
Prior conditions:
- Vehicle stationary or not.
- Ignition switched on.
- Engine running or not.
Pull and release the control (6).
B3FP7HWDC5FP0W3D
Angl-C6-PAGE170-194-2005 4/02/05 17:35 Page 180

Downloaded from www.Manualslib.com manuals search engine 181
BRAKES
GENERAL FEATURES OF ELECTRIC PARKING BRAKE
NOTE:The parking brake can be activated when the vehicle is moving, at whatever speed, but only if
the control (6)is kept pulled, the parking brake being deactivated as soon as the control (6)is released.
NOTE: The electric parking brake has an "anti-lock"system for limiting the locking of the wheels and
guaranteeing vehicle stability if the parking brake is actioned while the vehicle is moving.
Releasing the parking brake.
Prior conditions:
- Vehicle stationary.
- Gear lever in position P.
- Ignition switched on.
- Engine running.
Press on the brake pedal.
Pull and release the control (6).
Parking brake warning lamp.
Condition for the warning lamp "a"coming on:
- Electric parking brake activated or incorrectly deactivated.
- Malfunctioning of the electric parking brake.
B3FP7HWDC5FP0W3D
Angl-C6-PAGE170-194-2005 4/02/05 17:35 Page 181