2004 MITSUBISHI ENDEAVOR engine

SPARK PLUG TEST 1. Remove the spark plug and connect to the ignition coil.
Fig. 5: Removing Spark Plug

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Ground the spark plug outer electrode (body), and crank the engine.
Check that there is an electrical dischar
ge between the electrodes at this time.

2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

Fig. 6: Checking Spark Plug

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
SPARK PLUG CHECK AND CLEANING Check the plug gap and replace if the limit is exceeded.
Standard value: 0.7 - 0.8 mm (0.028 - 0.031 inch)
Limit: 1.2 mm (0.047 inch)
CAUTION:
Do not attempt to adjust the gap of the iridium
plug. Cleaning of the iridium plug may result in
damage to the iridium tips. Therefore, if carbon
deposits must be removed, use a plug cleaner
and complete cleaning within 20 seconds to
protect the electrode. Do not use a wire brush.

2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

Fig. 7: Locating Iridium Tip

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CAMSHAFT POSITION SENSOR CHECK Refer to DTC P0340: CAMSHAFT POSITION SENSOR CIRCUIT
.
CRANKSHAFT POSITION SENSOR CHECK Refer to DTC P0335: CRANKSHAFT POSITION SENSOR CIRCUIT
.

2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

IGNITION COI
L
REMOVAL AND INSTALLATION Fig. 8: Removing And Installing Ignition Coil

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CAMSHAFT POSITION SENSOR REMOVAL AND INSTALLATION
2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

Fig. 9: Removing And Installing Camshaft Position Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CRANKSHAFT POSITION SENSOR REMOVAL AND INSTALLATION Pre-removal and Post-installation Operation
Timin
g Belt Lower Cover Removal and Installation
(Refer to TIMING BELT
).

2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

Fig. 10: Removing And Installing Crankshaft Position Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
KNOCK SENSOR REMOVAL AND INSTALLATION Pre-removal and Post-installation Operation
Intake Manifold Removal and Installation (Refer to REMOVAL AND INSTALLATION
).

2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

Fig. 11: Removing And Installing Knock Sensor

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
REMOVAL SERVICE POINT << A >> KNOCK SENSOR REMOVAL Use s
pecial tool MD998773 to remove the knock sensor.

2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor

Fig. 12: Removing Knock Sensor Using Special Tool (MD998773)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSTALLATION SERVICE POINT >>A<< KNOCK SENSOR INSTALLATION Use special tool MD998773 to install the knock sensor. SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS
2004 Mitsubishi Endeavor Limited 2004 ENGINE Ignition System - Endeavor