2004 MITSUBISHI ENDEAVOR Battery terminals

Fig. 69: Measuring Terminal Voltage Between Special Tool 23
-
Pin Connector Terminal 33 And Ground

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
5. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the measured voltage battery positive voltage (approximately 12
volts) when the brake pedal is depressed and 1 volt or less when the brake
pedal is released?
YES : Go to Step 21 .
NO : Go to Step 16.
STEP 16. Check PCM connector B-19 and stoplight switch connector C-03
for loose, corroded or dama
ged terminals, or terminals
pushed back in the
connector.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Auto, Cruise Control System - Endeavor

Fig. 2: Identifying Normal And Abnormal Characteristic Curve

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. If 0 V is indicated at A, there is a break in the positive terminals from A.
Defect where the voltage changes suddenly (12 V) in the same method
described above.
REAR WINDOW DEFOGGER SWITCH REMOVAL AND INSTALLATION Refer to HEATER CONTROL ASSEMBLY AND A/C SWITCH
.
INSPECTION REAR WINDOW DEFOGGER RELAY CONTINUITY CHECK Fig. 3: Identifying Battery Voltage Specification

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor XLS
2004 BODY & ACCESSORIES Rear Window Defogger - Endeavor

Fig. 28: Identifying Sub Rear Switch Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
DOOR WINDOW REGULATOR CHECK 1. Connect a battery directly to the motor terminals and check that the motor runs
smoothly.
2. Check that the motor runs in the opposite direction when the battery is
connected with the polarity reversed.
3. If defect is found, re
place the window re
gulator as an assembl
y.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

Fig. 29: Identifying Door Window Motor Terminals (Front Door)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
< REAR DOOR > DOOR WINDOW REGULATOR CHECK SPECIFICATION BATTERY CONNECTION
SLIDER POSITION
Connect terminal No. 1 and the
UP

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

Fig. 30: Identifying Door Window Motor Terminals (Rear Door)
negative battery terminal. Connect terminal No. 2 and the
positive battery terminal. Connect terminal No. 2 and the
negative battery terminal. Connect terminal No. 1 and the
positive battery terminal.
DOWN

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Door - Endeavor

11. After repeatedly revving the engine up to 3,000 r/min several times, stop the
engine.
12. Remove the radiator cap after the engine has cooled, and pour in coolant up to
the brim. Reinstall the cap.
13. Add coolant to the radiator condenser tank assembly between the "FULL" and
"LOW" mark if necessary. ENGINE COOLANT CONCENTRATION TEST Refer to RECOMMENDED LUBRICANTS AND LUBRICANT CAPACITIES
.
FAN CONTROL MODULE CHECK 1. Remove the fan control module connector.
2. Turn the ignition switch to the "ON" position, and measure the voltage
between the harness-side connector terminals.
Standard value: Battery positive voltage
CAUTION: Do not overfill the radiator condenser tank
assembly.

2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor

Fig. 44: Measuring Voltage Between Fan Control Module
-Side Connector
Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
6. Turn the A/C switch to the "ON" position.
7. Measure the voltage between the fan control module-side connector terminals
while the fan is running. The voltage should repeat the values 1) and 2) below.
Standard value:
1.8.2+/-2.6 V
2.Battery positive voltage+/-2.6 V
8. If the voltage does not repeatedly change as indicated, replace the radiator fan
motor.
FAN CONTROL RELAY CONTINUITY CHECK
2004 Mitsubishi Endeavor Limited 2004 ENGINE Engine Cooling - Endeavor

Fig. 3: Generator Output Line Voltage Drop Test (Typical)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Always be sure to check following before testing:
Generator installation. Generator drive belt tension. Fusible link. Abnormal noise form generator while engine is running.
2. Tune ignition switch to LOCK (OFF) position.
3. Disconnect ne
gative batter
y cable.
WARNING:Battery posts, terminals and related accessories
contain lead and lead compounds. Wash hands
after handling.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor