2003 LEXUS LS430 lock

Fig. 23: Installing Cover With Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c.INSTALL HOOD LOCK ASSY
a. Appl
y MP grease to the sliding areas of the lock.

Fig. 24: Applying MP Grease To Sliding Areas Of Lock
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Connect the hood lock control cable.
c. Install the hood lock with the 2 bolts and nut.
Torque: 8.0 N.m (82 kgf.cm, 71 in..lbf)
d. Adjust the lock (see ADJUSTMENT
).
e. Install new cap.

Fig. 25: Installing Hood Lock With Bolts And Nut
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
f. w/ Pre-collision safety system:
Install the millimeter wave radar sensor with the 3 bolts.
Torque: 5.5 N.m (56 kgf.cm, 49 in..lbf)
g. w/ Pre-collision safety system:
Connect the connector.
h. w/ Pre-collision safety system:
Connect the negative (-) terminal cable to the battery.
i. w/ Pre-collision safety system:
Initialize both s
ystems (see INITIALIZATION).

Fig. 28: Installing Radiator Grille Garnish To Inside Radiator Grille With New Nuts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
f.INSTALL AUXILIARY CATCH RELEASE LEVER ASSY
a. Install the lever with the 2 bolts.
Torque: 8.0 N.m (82 kgf.cm, 71 in..lbf)
b. Connect the rod and lock the snap as shown in the illustration.

Fig. 40: Prying Armrest Panel Assembly
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d. Passenger's side:
3.REMOVE FRONT DOOR ARMREST BASE PANEL UPPER
a. Using a screwdriver, pry the armrest panel assembly.
HINT:
Tape the screwdriver tip before use.
b. Using a screwdriver, disengage the 2 claws and remove the lock control switch from the armrest
panel assembly.
HINT:
Tape the screwdriver tip before use.
c. Using a screwdriver, disengage the 2 claws and remove the power window switch from the armrest
assembl
y.

Fig. 57: Removing Front Door Frame Sub-Assy Front Lower LH
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
19.REMOVE DOOR OUTSIDE HANDLE COVER ASSY
a. Remove the hole plug.
b. Using a T30 Torx° wrench, loosen the screw and remove the cover with the door lock key cylinder
installed.

Fig. 58: Removing Hole Plug
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
20.REMOVE FRONT DOOR LOCK ASSY LH
a. Disconnect the door lock connector.
b. w/o Door closer:
Using a T30 Torx° wrench, remove the 3 screws and door lock.
c. w/ Door closer:
Using a T30 Torx° wrench, remove the 5 screws and door lock.
HINT:
Remove the door lock through the service hole.
d. Remove the door remote control cable and door inside lockin
g cable.

Fig. 59: Removing Door Remote Control Cable And Door Inside Locking Cable
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
21.REMOVE FRONT DOOR HANDLE ASSY OUTSIDE LH
a. Disconnect the connector.
b. Remove the handle by sliding and pulling it in the direction indicated by the arrow mark in the
illustration.
c. Remove the outside handle pad front and rear.
<0029004c004a0011000300190013001d000300350048005000520059004c0051004a00030032005800570056004c004700480003002b004400510047004f004800030033004400470003002900550052005100570003002400510047000300350048004400
55[

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.