2003 ASTON MARTIN DB AR1 Q Owners Guide

B - Controls
1-B-21
Electric Window Switches
On either side of the gear selector lever are two identical
rocker switches to control the movement of the electric
windows.
With the ignition on and the doors closed, press and hold
the down (hollow) arrow to lower the window.
Press and hold the up (solid) arrow to raise the window.
Note: The electric window will only operate if the door is
closed.
Electric Window 'One Touch Down' Feature
Briefly press and release the down (hollow) arrow to lower the window fully.
Pressing the button again will stop downward window movement.
WARNINGS: Clear all obstructions before raising the window. When leaving the
vehicle, remove the ignition keys. Misuse of window switches, especially by
children, can cause injury.
Note: If battery power to the electric windows has been interrupted for any
reason, they will fail to operate correctly until reset using the procedure described
in 'Owner Maintenance'.

B - Controls
1-B-22
Cigar Lighter and Ashtray
The cigar lighter is located to the left of the ashtray and may be used when
the ignition switch is in positions I or II. It is heated by pushing down until
it clicks. The lighter will pop up when ready for use.
WARNING: The cigar lighter is heated to "Red Heat" when in use. Take care to
avoid burns and do not allow children to play with the lighter.
The ashtray may be removed for cleaning by sliding back the lid and pulling
the tray upwards. After cleaning it should be replaced and pushed down
until the locating springs click into position.

B - Controls
1-B-23
Bonnet (Hood) and Boot (Trunk)
Bonnet (Hood) Release
The bonnet release lever is situated
on the outside of the left hand front
footwell. Pull the lever to release the
bonnet latches. The bonnet will be
released and will rise until captured
by the bonnet safety catch.
Bonnet (Hood) Safety Catch
The bonnet safety catch is located under the
bonnet rear edge on the drivers side of the car
(left side on left hand drive, right side on right
hand drive).
Push down slightly on the bonnet rear edge
whilst pushing forward on the bonnet safety
catch to release it. Lift the bonnet until fully
open. The bonnet is held open by two gas
struts.

B - Controls
1-B-24
Closing the Bonnet (Hood)
To close the bonnet, hold near the centre of the rear edge and lower until
approximately 18 inches (450 mm) from the latch mechanisms and then
release it. After closing the bonnet, ensure that both left and right hand
latches have fully engaged by pulling up at either side of the bonnet rear
edge.
WARNING: Before closing the bonnet, ensure that no one is obstructing the
closing area and that hands and clothing are clear. Remove tools, cleaning cloths,
etc. from the engine compartment.
Boot (Trunk) Release
There are four methods for opening the boot.
1. The boot lid may be released at any time using the right hand button on
the key fob.
ASTON MARTIN

B - Controls
1-B-25 2. The boot may be opened from outside the car
using the ignition key when the alarm system is
switched off. Lift up the Aston Martin badge to
access the boot lock.
3. The boot may be opened by pressing the boot
release switch located on the center console at
any time when the alarm system is switched off
and the ignition is switched on.
4. The boot may be opened from inside by
pulling the luminous emergency release handle.
The handle will latch on the edge of its housing.
To retract the handle, pull, lift and release so that
it may withdraw into the housing.
Boot (Trunk) Closing
Close the boot gently and press down the lid until the lock engages.
Slamming of the boot lid may damage the lock mechanism or the boot seals.

B - Controls
1-B-26
Accessory Socket
The accessory socket is mounted in the centre armrest beside the boot open
switch and may be used to power any 12 volt vehicle accessory requiring a
current of less than 15 amps.
The accessory socket is only live when the ignition key is inserted and the
switch is turned to position I or II.
WARNING: Damage to the electrical circuits will result if more than 15 amps is
drawn from the accessory socket.
Only connect accessories which are designed for use in a motor vehicle.
Read the manufacturer's instructions and ensure that you do not connect any
device which would exceed the current rating of the accessory socket.

B - Controls
1-B-27
Interior Lights
The interior light assembly is mounted in the front windscreen header rail
and contains two 'eyeball' lamps and the front interior lamp. The 'eyeball'
lamps are controlled by the outer switches on the lamp assembly and may
be rotated to illuminate the driver or passenger seat areas.
The centre switch on the lamp assembly controls the operation of the front
and rear interior lights as follows:
Front and rear interior lights on
Front and rear interior lights off
Front and rear interior lights come on when a door is opened and
remain on for approximately 12 seconds after a door is closed with
the ignition off.
12 sec

B - Controls
1-B-28