2003 ASTON MARTIN DB AR1 Q Owners Guide

F - Owner Maintenance
1-F-36
Electrical Start from Another Vehicle
If your DB AR1 will not start due to a discharged battery, it may be started
by connecting the battery from another vehicle to the discharged battery.
Before the vehicle is started in this way, ensure that the donor vehicle has
a 12 volt battery and negative (-), black earth terminal to ensure that the
correct battery polarity is maintained.
WARNING: If the voltage or earth of the donor vehicle is different or not known,
do not attempt starting in the way described.
1. Position the vehicles so that the connecting cable will reach between
the batteries. Ensure that the vehicles do not touch each other.
2. To lessen the risk of an electrical short circuit, remove rings, metal
watch bands and any other jewellery. Wear eye protection when
working near the battery. Turn off all electrical motors and ancillaries
in both vehicles. Switch off all lights except those needed to protect the
vehicles or illuminate the work area. Switch off the ignition and apply
the handbrake.
3. Lift out the boot floor panels to gain access to the battery.
4. Connect the red (+) cable between the red (+) positive terminal of the
two batteries.
5. Connect the black (-) cable between the black (-) negative terminals of
the two batteries.
6. Start the donor vehicle engine and run at about 1500 - 2000 rpm.
7. Start the engine. Allow the engine to run for some minutes until the flat
battery is partially charged. Switch off both vehicles.

F - Owner Maintenance
1-F-37 8. Remove the black (-) negative cable from both batteries and then
remove the red (+) positive cable from both batteries.
9. Refit the boot floor panels and close the boot.
10. Restart the engine and take it for a long road run if possible to recharge
the battery.
11. If necessary, recharge the battery using an appropriate 'trickle' charger.

F - Owner Maintenance
1-F-38
Fuse Boxes
Three fuse/relay boxes are fitted to DB AR1 containing the fuses to protect
electrical and electronic systems of the vehicle. The box locations are
indicated on the diagram above.
The forward left and right fuse boxes are located beneath a plate in the
passenger side footwell. The rear fuse box is located in the boot, close to the
battery.
WARNING: Do not add to or alter the electrical systems of DB AR1 unless fitting
Aston Martin approved options to the manufacturers instructions. Use of
unapproved components, incorrect dismantling, incorrect reassembly or incorrect
replacement of components may create electrical overloads and a fire risk.
WARNING: Do not attempt to repair a blown fuse. This could cause a fire hazard
or serious damage elsewhere in the electrical circuits.
WARNING: Do not install a fuse which exceeds the amperage for each location
listed on the following fuse charts.

F - Owner Maintenance
1-F-39
Fuse Lists
Passenger Footwell Fusebox - Right Hand
F1 5A Passive Anti-Theft Module
F2 20A Cigar Lighter
F3 10A Diagnostic Sockets, Radio, Air Conditioning, Driver's
Door Mirror and Window
F4 5A Seat Switches and Heaters
F5 10A Indicator Flasher
F6 10A Ignition Coils 1-6
F7 10A Interior Lamp Cluster
F8 10A Ignition Coils 7-12
F9 20A RHS Seat Heater Relay, RHS Seat Module
F10 10A Dimmer, Passive Anti-Theft Module, Radio
F11 10A Door Mirrors
F12 5A Diagnostic Sockets
F13 25A Not used
F14 10A Hazard Flasher Unit
F15 20A Wiper Logic Module and Wiper Stalk
F16 30A ABS Control Unit
F17 20A Wiper Motor, Logic Module and Wiper Stalk
F18 30A ABS Control Unit
F19 10A Air Conditioning LH Blower Motor
F20 5A Gearshift Interlock Module, Traction Control Switch,
Interior, Map & Courtesy Lamps
F21 10A Air Conditioning RH Blower Motor
F22 10A Powertrain and Transmission control Modules - Keep
Alive Memory

F - Owner Maintenance
1-F-40
Passenger Footwell Fusebox - Left Hand
F1 15A Accessory Terminal
F2 10A Transmission Control Module, Gearshift Interlock
Module, PRND Switch
F3 5A Headlamp Relay, Instrument Pack, Dimmer Unit
F4 10A Multi Function Unit, Air-Conditioning In-Car Sensor,
Anti-Lock Brakes Control Unit
F5 5A Traction Control Switch, Alternator Regulator, Heated
Front Screen Control
F6 10A Rear Fog Switch, RH Dip Beam
F7 30A Starter Relay
F8 10A LH Dip Beam
F9 20A LHS Seat Heater Relay, LHS Seat Module
F10 40A Heated Front Screen Controller
F11 10A RH Horn
F12 30A LH Rad Cooling Fan
F13 10A LH Horn
F14 30A RH Rad Cooling Fan
F15 30A Primary Powertrain Control Module RHS
F16 10A Multi-Function Unit, Central Locking Module, Air
Conditioning Control Panel, Alarm Sounder
F17 30A Secondary Powertrain Control Module LHS
F18 5A Interior Map Lights, Instrument Pack,
RH Rad Module
F19 10A RH Main Beam
F20 20A Window Lift Cut Out, Accessory Terminal,
Air Conditioning Clutch Relay
F21 10A Instrument Pack, LH Main Beam
F22 25A Front Fog Relay

F - Owner Maintenance
1-F-41 Boot Fusebox
F1 10A Reverse Light Relay
F2 20A Security System & Tilt Sensors
F3 5A +12V Ignition
F4 5A Boot Switch Logic Relay, Security System Control Unit
F5 30A Accessory Terminal
F6 5A RH Fog Lamp, Powertrain Control Modules
F7 20A Fuel Pump 2, Secondary Powertrain Control Module
F8 10A HM Stop Light, LH Stop Light
F9 10A Boot Lamps, Radio Aerial Motor
F10 10A Accessory Socket
F11 20A Not Used
F12 20A Not Used
F13 10A Airbag Control Unit
F14 30A Not Used
F15 20A Fuel Pump 1, Primary Powertrain Control Module
F16 10A Rear Fog Light Relay
F17 10A Manual Gearbox Cooling Pump
F18 10A Accessory Terminal
F19 10A RH Tail, Side, Side Marker and
Number Plate Lamps
F20 20A Premium ICE Amplifier
F21 10A LH Tail, Side, Side Marker and
Number Plate Lamps
F22 20A Manual - Exhaust By-pass System
Automatic - Not Used

F - Owner Maintenance
1-F-42
Bulb and Fuse Replacement
A kit of replacement bulbs, fuses etc. is supplied. Any item used from the kit
should be replaced at the earliest opportunity so that the full kit is always
available.
On vehicles fitted with the space-saver spare wheel the kit is stored in the
wheel insert.
On vehicles without the spare wheel the kit is stored in the insert under the
boot floor covering. The kit contents are market dependant and typically
include:
12V, 5W (Festoon) C5W Number Plate Light
12V, 5W (capless) W5W Side Lights/Side Repeater Lights
12V, 55W H1 Headlight Main and Dip Beam
Note: From August 2002 dip beam bulbs 12V, 55W H1 Philips Blue Vision for all
countries except North America.
12V, 55W H3 Headlight/Fog light (not USA)
12V, 3W W3W Side Markers LH/RH, Front
and Rear
Fuse Extractor Key
Note: Spare bayonet fuses are located in the toolkit

F - Owner Maintenance
1-F-43
Headlight Main Beam Bulb Replacement
1. Lift the bonnet.
2. Turn the lamp rear cap anti-clockwise and release it.
3. Pull off the two electrical leads from the headlight bulb connectors.
4. Pinch the bulb retaining clip and release it.
5. Withdraw the headlight bulb, noting the bulb orientation.
6. Hold the new bulb in a clean cloth or paper towel. Orientate the new
bulb correctly in the headlight bulb holder and secure it with the spring
clip.
7. Connect the two electrical leads.
8. Refit and secure the lamp rear cover.