2001 TOYOTA SEQUOIA charging

PP3WZ±02
PP±28
± PREPARATIONCHARGING
86 Author: Date:
2005 SEQUOIA (RM1146U)
CHARGING
SST (Special Service Tools)
09285±76010Injection Pump Camshaft Bearing
Cone Replacer
09820±00021Alternator Rear Bearing Puller
09820±00031Alternator Rear Bearing Replacer
09820±63011Alternator Pulley Set Nut
Wrench Set
09950±40011Puller B Set
(09951±04020)Hanger 200
(09952±04010)Slide Arm
(09953±04020)Center Bolt 150
(09954±04010)Arm 25
(09955±04071)Claw No.7
(09958±04011)Holder
09950±60010Replacer Set

± PREPARATIONCHARGING
PP±29
87 Author: Date:
2005 SEQUOIA (RM1146U)
(09951±00250)Replacer 25
(09951±00470)Replacer 47
09950±70010Handle Set
(09951±07100)Handle 100

PP3X0±02
PP±30
± PREPARATIONCHARGING
88 Author: Date:
2005 SEQUOIA (RM1146U)
RECOMMENDED TOOLS
09082±00050TOYOTA Electrical Tester Set.
(09082±00040)TOYOTA Electrical Tester.

PP1DB±03
± PREPARATIONCHARGING
PP±31
89 Author: Date:
2005 SEQUOIA (RM1146U)
EQUIPMENT
Ammeter(A)
Torque wrench
Vernier calipersRotor (Slip ring)

PP3JZ±01
PP±80
± PREPARATIONAIR CONDITIONING
138 Author: Date:
2005 SEQUOIA (RM1146U)
AIR CONDITIONING
SST (Special Service Tools)
07110±58060Air Conditioner Service Tool Set
(07117±58060)Refrigerant Drain Service Valve
(07117±58070)T±Joint
(07117±58080)Quick Disconnect AdapterHigh pressure side
(07117±58090)Quick Disconnect AdapterLow pressure side
(07117±88060)Refrigerant Charging HoseHigh pressure side
(Color: Red)
(07117±88070)Refrigerant Charging HoseLow pressure side
(Color: Blue)
(07117±88080)Refrigerant Charging HoseUtility
(Color: Green)
07112±66040Magnetic Clutch Remover
07112±76060Magnetic Clutch Stopper
07116±38360Gas Leak Detector Assembly
09870±00015A/C Quick Joint Puller No.1Suction tube

SS0PM±07
SS±22
± SERVICE SPECIFICATIONSCHARGING
164 Author: Date:
2005 SEQUOIA (RM1146U)
CHARGING
SERVICE DATA
BatterySpecific gravity at 20°C (68°F)
Voltage at 20°C (68°F)1.25 to 1.29
12.5 to 12.9 V
GeneratorRated output
Rotor coil resistance at 20°C (68°F)
Slip ring diameter STD
Minimum
Brush exposed length STD
Minimum12V 130A
1.5 to 1.9 W
14.2 to 14.4 mm (0.559 to 0.567 in.)
14.0 mm (0.551 in.)
10.5 mm (0.413 in.)
4.5 mm (0.177 in.)
Charging circuitWithout load STD amperage
STD voltage
With load STD amperage10 A or less
13.2 to 14.0 V
30 A or less

SS0PN±07
± SERVICE SPECIFICATIONSCHARGING
SS±23
165 Author: Date:
2005 SEQUOIA (RM1146U)
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Bearing retainer x Drive end frame2.62723 in.´lbf
Rectifier end frame x Drive end frame5.85951 in.´lbf
Generator pulley x Rotor110.31,12581
Brush holder x Rectifier end frame1.81816 in.´lbf
Rear end cover x Rectifier end frame4.64741 in.´lbf
Generator x Cylinder block Bolt
Nut 10 mm
Nut 8 mm39
39
15.5400
440
15829
29
11

F13970
ECU±IG Instrument
Panel J/B:
± DIAGNOSTICSTIRE PRESSURE WARNING SYSTEM
DI±879
1073 Author: Date:
2005 SEQUOIA (RM1146U)
INSPECTION PROCEDURE
NOTICE:
It is necessary to register an ID code after replacing the tire pressure monitor valve sub±assy and/or
the tire pressure monitor ECU (see page DI±805).
1 Inspect battery.
CHECK:
Check the battery voltage.
OK:
Voltage: 11 to 14 V
NG Check and repair charging system.
(See page CH±1)
OK
2 Inspect fuse (ECU±IG).
PREPARATION:
Remove the ECU±IG fuse from the instrument panel J/B.
CHECK:
Check continuity of the ECU±IG fuse.
OK:
Continuity
NG Check for a short in all harness and connector
connected to fuse and replace fuse.
OK