2001 TOYOTA SEQUOIA window

IN0KK±01
IN±20
± INTRODUCTIONFOR ALL OF VEHICLES
20 Author: Date:
2005 SEQUOIA (RM1146U)
INITIALIZATION
NOTICE:
When disconnecting the battery terminal, initialize the following systems after the terminal is recon-
nected.
System NameSee Step No.
Back Door Power Window Control SystemStep 1
INITIALIZE BACK DOOR POWER WINDOW CONTROL SYSTEM
NOTICE:
Resetting the power window regulator motor (initializing the pulse sensor) is necessary if: 1) the bat-
tery terminal cable is disconnected; 2) the back door ECU, wire harness, power window regulator
switch, power window regulator assembly and power window regulator motor are replaced or re-
moved/installed; or 3) the P/W fuse is replaced or removed. If resetting is not performed, the master
switch assembly will not be able to operate the AUTO operation function, jam protection function and
remote operation function.
(a) Turn the ignition switch ON.
(b) Open the power window halfway by pressing the power window switch.
(c) Fully pull up on the switch until the power window is fully closed and continue to hold the switch for
at least 1 second.
(d) Check that the AUTO UP/DOWN function operates normally.
If the AUTO UP/DOWN function operates normally, reset operations are complete. If abnormal, follow the
steps (e) to (g) below.
(e) Disconnect the negative battery terminal cable for 10 seconds.
(f) Connect the battery terminal cable.
(g) Perform the steps (a) to (d) again.

B02389
B02390
HEAT METHOD: When the problem seems to occur when the suspect area is heated. 2
NOTICE:3 WATER SPRINKLING METHOD:
(1)
(2)
4 OTHER: When a malfunction seems to occur when electrical load is excessive.When the malfunction seems to occur on a rainy day or in a
high±humidity condition. Heat the component that is the likely cause of the malfunction
with a hair dryer or similar object. Check to see if the malfunction
occurs.
Sprinkle water onto the vehicle and check to see if the malfunc-
tion occurs.
Turn on all electrical loads including the heater blower, head
lights, rear window defogger, etc. and check to see if the mal-
function occurs.ON HINT:
If a vehicle is subject to water leakage, the leaked water may
contaminate the ECU. When testing a vehicle with a water leak-
age problem, special caution must be taken.
Malfunc-
tion
Do not heat to more than 60 °C (140 °F). (Temperature
is limited not to damage the components.)
Do not apply heat directly to parts in the ECU. (1)
(2)
Never sprinkle water directly into the engine compart-
ment, but indirectly change the temperature and hu-
midity by applying water spray onto the radiator front
surface.
Never apply water directly onto the electronic compo-
nents. NOTICE: IN±30
± INTRODUCTIONHOW TO TROUBLESHOOT ECU CONTROLLED
SYSTEMS
30 Author: Date:
2005 SEQUOIA (RM1146U)

± INTRODUCTIONTERMS
IN±43
43 Author: Date:
2005 SEQUOIA (RM1146U) OEM
Original Equipment Manufacturing
OHCOverhead Camshaft
OHVOverhead Valve
OPTOption
ORVROn±board Refilling Vapor Recovery
O/SOversize
P & BVProportioning And Bypass Valve
PCSPower Control System
PCVPositive Crankcase Ventilation
PKBParking Brake
PPSProgressive Power Steering
PSPower Steering
PTOPower Take±Off
P/WPower Window
R & PRack And Pinion
RAMRandom Access Memory
R/BRelay Block
RBSRecirculating Ball Type Steering
R/FReinforcement
RFSRigid Front Suspension
RHRight±Hand
RHDRight±Hand Drive
RLYRelay
ROMRead Only Memory
RRRear
RRSRigid Front Suspension
RWDRear±Wheel Drive
SDNSedan
SENSensor
SICSStarting Injection Control System
SOCState Of Charge
SOHCSingle Overhead Camshaft
SPECSpecification
SPISingle Point Injection
SRSSupplemental Restraint System
SSMSpecial Service Materials
SSTSpecial Service Tools
STDStandard
STJCold±Start Fuel Injection
SWSwitch
SYSSystem
T/ATransaxle
TACHTachometer
TBIThrottle Body Electronic Fuel Injection
TCTurbocharger
TCCSTOYOTA Computer±Controlled System
TCVTiming Control Valve
TDCTop Dead Center
TEMP.Temperature
TEMSTOYOTA Electronic Modulated Suspension
TFTTOYOTA Free±Tronic
TISTotal Information System For Vehicle Development

PP0O2±06
± PREPARATIONBODY ELECTRICAL
PP±73
131 Author: Date:
2005 SEQUOIA (RM1146U)
EQUIPMENT
Voltmeter
Ammeter
Ohmmeter
Test lead
ThermometerEngine coolant temperature sender gauge, Engine oil level warn-
ing switch, Seat heater
SyphonBrake fluid level warning switch
Oil bathEngine oil level warning switch
Bulb (1.4 W)Defogger switch
Bulb (3.4 W)Fuel sender gauge, Engine coolant temperature receiver gauge,
Seat belt warning relay
Dry cell batteryFuel sender gauge, Power mirror
Heat lightSeat heater
Hexagon wrench (6 mm)Power seat
Torque wrench
Masking tapeRear window defogger wire
Tin foilRear window defogger wire

PP0T6±12
PP±74
± PREPARATIONBODY ELECTRICAL
132 Author: Date:
2005 SEQUOIA (RM1146U)
SSM (Special Service Materials)
08888±88888DuPont Paste No. 4817 or
equivalentRear window defogger

SS0OL±14
SS±48
± SERVICE SPECIFICATIONSBODY
190 Author: Date:
2005 SEQUOIA (RM1146U)
BODY
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
FRONT BUMPER±±±
Side support x Body3.03027 in.´lbf
Front bumper reinforcement x Body5051037
Front bumper cover x Body7.07162 in.´lbf
REAR BUMPER±±±
Rear bumper reinforcement x Body9597070
Rear bumper side support x Rear bumper reinforcement1919514
Back step reinforcement x Rear bumper side support1919514
Rear bumper cover x Body7.07162 in.´lbf
Rear bumper cover x Rear bumper extension5.05043 in.´lbf
HOOD±±±
Hood hinge x Hood1313310
Hood lock x Hood7.88069 in.´lbf
HOOD SUPPORT±±±
Hood support x Body2222416
Hood support x Hood2222416
FRONT DOOR±±±
Door hinge x Body2323517
Door hinge x Door panel2323517
Door check x Door panel3030622
Door lock striker x Body2323517
Outside rear view mirror x Door panel8.08271 in.´lbf
Door glass x Window regulator sub±assembly8.08271 in.´lbf
Window regulator sub±assembly x Door panel8.08271 in.´lbf
Door lock x Door panel5.05144 in.´lbf
Outside handle with lock cylinder x Door panel5.55649 in.´lbf
Outside handle x Lock cylinder5.55649 in.´lbf
REAR DOOR±±±
Door hinge x Body2323017
Door hinge x Door panel2323017
Door check x Door panel3030622
Door lock striker x Body2323017
Window regulator x Door panel8.08271 in.´lbf
Door lock x Door panel Bolt:5.55649 in.´lbf
Door lock x Door panel Screw:5.05144 in.´lbf
Outside handle x Door panel5.55649 in.´lbf
BACK DOOR±±±
Back door hinge x Body19.519914.4
Back door hinge x Door panel19.519914.4
Door lock striker x Body27275.519.9
Guide bracket x Door panel8.08271 in.´lbf
Back door glass x Door panel8.08271 in.´lbf

± SERVICE SPECIFICATIONSBODY
SS±49
191 Author: Date:
2005 SEQUOIA (RM1146U) Power window regulator x Door panel
5.55649 in.´lbf
Back door lock x Door panel8.08271 in.´lbf
FRONT WIPER AND WASHER±±±
Wiper link x Body5.55649 in.´lbf
Wiper motor x Wiper link5.55649 in.´lbf
Wiper arm x Wiper link2020415
REAR WIPER AND WASHER±±±
Rear wiper motor x Body5.55649 in.´lbf
Wiper arm x Rear wiper motor5.55649 in.´lbf
BODY OUTSIDE MOULDING±±±
Rear bumper cover x Rear bumper extension5.05043 in.´lbf
WINDSHIELD±±±
Inner rear view mirror set torx screw2.52522 in.´lbf
SLIDING ROOF±±±
Sliding roof housing x Body5.55649 in.´lbf
INSTRUMENT PANEL±±±
Front passenger airbag assembly x Instrument panel5.05144 in.´lbf
Front passenger airbag assembly x Instrument panel reinforcement2020415
Steering wheel x Steering wheel pad8.89078 in.´lbf
Box panel sub±assembly x Floor panel4040830
FRONT SEAT (Power Adjuster Type)±±±
w/ Side airbag:
Seatback cover bracket x Seat frame assembly5.55649 in.´lbf
Armrest x Seat frame assembly3738027
Front seat x Body3738027
FRONT SEAT (Manual Adjuster Type)±±±
w/ Side airbag:
Seatback cover bracket x Seat frame assembly5.55649 in.´lbf
Armrest x Seat frame assembly3738027
Front seat x Body3738027
REAR NO.1 SEAT (Separate Type)±±±
Rear seat cushion hinge x Body3738027
LH rear seat lock x Seat cushion frame4344032
Rear seat reclining adjuster x Seat cushion frame4344032
Rear seat reclining adjuster x Seatback frame4344032
RH rear seat lock x Seat cushion frame6465347
REAR NO. 1 SEAT (Split Type LH)±±±
Rear seat cushion hinge x Body4344032
Rear No. 1 seat outer adjuster x Seat cushion frame4344032
Rear No. 1 seat outer adjuster x Seatback frame4344032
Rear No. 1 seat inner adjuster x Seat cushion frame4344032
Rear No. 1 seat inner adjuster x Seatback frame4243031
Rear seat shoulder belt guide x Seatback frame3738027
REAR NO.1 SEAT (Split Type RH)±±±
Rear seat cushion hinge x Body3738027
Rear seat lock x Seat cushion frame4344032

DID7M±01
± DIAGNOSTICSENGINE
DI±1
195 Author: Date:
2005 SEQUOIA (RM1146U)
ENGINE
PRECAUTION
NOTICE:

When disconnecting the battery terminal, initialize the following system after the terminal is re-
connected.
System NameSee Page
Back Door Power Window Control SystemBE±77

Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission as-
sembly, engine assembly or ECM (See page DI±543).
HINT:
Initialization can not be completed by only removing the battery.