Insert the master key in the key cylinder.
Driver's door: Open " Close 7 times Ignition switch: LOCK " ON 6 times
Remove the master key.START
END
*1
*2within
15 secs.
within
20 secs.
All doors closed. No key in the key cylinder.
± BODY ELECTRICALENGINE IMMOBILISER SYSTEM
BE±141
3545 Author: Date:
2005 SEQUOIA (RM1146U)
3. ERASURE OF TRANSPONDER KEY CODE
Do this operation to erase transponder key registration from the transponder key computer.
HINT:
Delete all other master and sub±key codes leaving the master key code to use the operation. When using
the key which was used before deletion, it is necessary to register the code again.
*1: Insert the master cylinder into the key cylinder.
Turn the ignition switch to LOCK " ON 6 times within 15 seconds.
*2: Open and close driver's door 7 times and remove the master key within 20 seconds after completion of
the previous operation.
HINT:
When any operation time described above is over, registration mode completes.
When the next procedure is performed while the timer is working, the timer completes counting time,
then the next timer starts.
4. ECU COMMUNICATION ID REGISTRATION
NOTICE:
The ECU communication ID should be registered when the transponder key ECU and/or the
ECM is replaced, in order to match these ECM COMMUNICATION ID.
The engine cannot be started unless the ECM COMMUNICATION ID matches.
(a) Register the ECU communication ID.
(1) After the transponder key ECU and/or the ECM is replaced, turn the ignition switch ON (the en-
gine is not running).
(2) Short the Tc and CG terminals of the DLC3 and leave it as it is for 30 minutes.
(3) Check that the engine starts.
