2001 TOYOTA SEQUOIA oil

AC3IB±02
I21380
I21383
AC±74
± AIR CONDITIONINGREAR A/C EXPANSION VALVE
3801 Author: Date:
2005 SEQUOIA (RM1146U)
REAR A/C EXPANSION VALVE
REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION
SYSTEM
HINT:
At the time of installation, refer to the following:

Evacuate air from the refrigeration system.

Charge the system with refrigerant and inspect for leak-
age of refrigerant.
Specified amount:
Dual A/C: 1050 ± 50 g (37.03 ± 1.76 oz.)
2. DRAIN ENGINE COOLANT FROM RADIATOR
HINT:
It is not necessary to drain out all coolant.
3. REMOVE REAR SEAT OUTER BELT FLOOR AN-
CHORS
4. REMOVE BACKDOOR SCUFF PLATE
5. REMOVE REAR DOOR SCUFF PLATE RH
6. REMOVE UPPER BACK DOOR GARNISH
7. REMOVE REAR WINDOW SIDE GARNISH RH
8. REMOVE REAR QUARTER TRIM PANEL RH
9. REMOVE QUARTER PILLAR GARNISH RH
10. DISCONNECT LIQUID AND SUCTION TUBES
Remove the 2 bolts and disconnect both tubes.
Torque: 5.4 N´m (55 kgf´cm, 48 in.´lbf)
NOTICE:
Cap the openings immediately to keep moisture or dirt out
of the system.
HINT:
At the time of installation, refer to the following:
Lubricate 2 new O±rings with compressor oil and install them
to the tubes.
11. REMOVE AIR DUCT
(a) Remove the 3 clips and cover.
(b) Remove the 2 air ducts.
(c) Disconnect the connectors and wire harness clamps.

I21799
I21384
I21387
Nut A:
Nut B:
± AIR CONDITIONINGREAR A/C EXPANSION VALVE
AC±75
3802 Author: Date:
2005 SEQUOIA (RM1146U)
12. REMOVE EXPANSION VALVE
(a) Remove the 4 screws and 2 brackets.
(b) Pry out the packing.
HINT:
At the time of installation, refer to the following:
Do not refuse the packing.
(c) Using a hexagon wrench (5.0 mm (0.20 in.)), remove the
2 bolts.
Torque: 5.4 N´m (55 kgf´cm, 48 in.´lbf)
(d) Remove the 3 bolts.
(e) Lift the A/C unit until the tube and accessary can be re-
moved.
(f) Remove the tube and accessary.
(g) Remove the holder and disconnect the heat sensing
tube.
(h) Loosen the 2 nuts and remove the expansion valve.
Torque:
Nut A: 13 N´m (135 kgf´cm, 10 in.´lbf)
Nut B: 22 N´m (235 kgf´cm, 16 in.´lbf)
HINT:
At the time of installation, refer to the following:
Lubricate 2 new O±rings with compressor oil and install them
to the expansion valve.

AC1LT±05
I21452
± AIR CONDITIONINGPRESSURE SWITCH
AC±93
3820 Author: Date:
2005 SEQUOIA (RM1146U)
REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION
SYSTEM
HINT:
At the time of installation, refer to the following:

Evacuate air from the refrigeration system.

Charge the system with refrigerant and inspect for leak-
age of refrigerant.
Specified amount:
Single A/C: 750 ± 50 g (26.45 ± 1.76 oz.)
Dual A/C: 1050 ± 50 g (37.03 ± 1.76 oz.)
2. REMOVE PRESSURE SWITCH FROM LIQUID TUBE
Disconnect the connector and remove the pressure switch.
Torque: 10 N´m (100 kgf´cm, 7 ft´lbf)
HINT:

Being careful not to deform the tube, lock the switch
mounted on the tube with an open end wrench and re-
move the switch.

At the time of installation, refer to the following:
Lubricate a new O±ring with the compressor oil and install
it to the switch.

05_SEQUOIA_U (L/O 0408)
vi
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Important health and safety
information about your Toyota
CAUTION

WARNING: Engine exhaust, some of its constitu-
ents, and a wide variety of automobile compo-
nents contain or emit chemicals known to the
State of California to cause cancer and birth de-
fects and other reproductive harm. In addition,
oils, fuels and fluids contained in vehicles as
well as waste produced by component wear con-
tain or emit chemicals known to the State of
California to cause cancer and birth defects or
other reproductive harm.

Battery posts, terminals and related accessories
contain lead and lead compounds. Wash your
hands after handling. Used engine oil contains
chemicals that have caused cancer in laboratory
animals. Always protect your skin by washing
thoroughly with soap and water.
Accessories, spare parts and
modification of your Toyota
A wide variety of non±genuine spare parts and accesso-
ries for Toyota vehicles are currently available in the
market. You should know that Toyota does not warrant
these products and is not responsible for their perfor-
mance, repair, or replacement, or for any damage they
may cause to, or adverse effect they may have on,
your Toyota vehicle.
This vehicle should not be modified with non±genuine
Toyota products. Modification with non±genuine Toyota
products could affect its performance, safety or durabili-
ty, and may even violate governmental regulations. In
addition, damage or performance problems resulting from
the modification may not be covered under warranty.

05_SEQUOIA_U (L/O 0408)
8
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
1. Service reminder indicators and
indicator lights
2. Oil pressure gauge
3. Tachometer4. Speedometer
5. Fuel gauge
6. Engine coolant temperature gauge7. Trip meter reset knob
8. Odometer and two trip meters
9. Height control indicator lights
10. Volt meter
Instrument cluster overview

Ty p e A

05_SEQUOIA_U (L/O 0408)
9
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
1. Service reminder indicators and
indicator lights
2. Oil pressure gauge
3. Tachometer4. Speedometer
5. Fuel gauge
6. Engine coolant temperature gauge7. Trip meter reset knob
8. Odometer and two trip meters
9. Height control indicator lights
10. Volt meter
Ty p e B

05_SEQUOIA_U (L/O 0408)
10
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
or
Driver 's seat belt reminder light*
1
Discharge warning light*
1
Low fuel level warning light*
1
Brake system warning light*
1
Malfunction indicator lamp*
1
Anti±lock brake system warning light*
1
Automatic transmission fluid temperature
warning light (four±wheel drive models)*
1
SRS warning light*
1
Open door warning light*
1
Low windshield washer fluid level warning
light*
1
Front passenger 's seat belt reminder light*
1
Vehicle stability control system/traction control
system (two±wheel drive models) or active
traction control system (four±wheel drive
models) warning light
*
1
Low tire pressure warning light*
1
Engine oil replacement reminder light*
1
Indicator symbols on the instrument panel

05_SEQUOIA_U (L/O 0408)
24
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
3. Put in a new transmitter battery with
positive (+) side up.
Close the transmitter case securely.
NOTICE

Make sure the positive side and
negative side of the transmitter bat-
tery are faced correctly.

Do not replace the battery with wet
hands. Water may cause unexpected
rust.

Do not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.

Be careful not to bend the electrode
when inserting the transmitter bat-
tery and that dust or oils do not
adhere to the transmitter case.

Close the transmitter case securely.
After replacing the battery, check that the
transmitter operates properly. If the trans-
mitter still does not operate properly, con-
tact your Toyota dealer.
LOCKING AND UNLOCKING WITH KEY
Insert the key into the keyhole and turn
it.
To lock: Turn the key forward.
To unlock: Turn the key backward.
All the side doors and back door lock and
unlock simultaneously with either front
door. In the driver 's door lock, turning the
key once will unlock the driver's door and
twice in succession will unlock all the side
doors and back door simultaneously.
Side doorsÐ