2001 TOYOTA SEQUOIA child restraint

05_SEQUOIA_U (L/O 0408)
120
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
1. Sit the child on a booster seat. Run
the lap and shoulder belt through or
around the booster seat and across the
child following the instructions provided
by its manufacturer and insert the tab
into the buckle taking care not to twist
the belt.
Make sure the shoulder belt is correctly
across the child's shoulder and that the
lap belt is positioned as low as possible
on the child's hips. See ªSeat beltsº on
page 72 in this Section for details.
CAUTION

Always make sure the shoulder belt
is positioned across the center of
child's shoulder. The belt should be
kept away from child's neck, but
not falling off child's shoulder.
Otherwise, the child may be killed
or seriously injured in case of sud-
den braking or a collision.

Both high±positioned lap belts and
loose±fitting belts could cause
death or serious injuries due to
sliding under the lap belt during a
collision or other unintended event.
Keep the lap belt positioned as low
on a child's hips as possible.

For child's safety, do not place the
shoulder belt under child's arm.

After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.

Do not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.

If the seat belt does not function
normally, it cannot protect your
child from death or serious injury.
Contact your Toyota dealer immedi-
ately. Do not install the child
restraint system on the seat until
the seat belt is fixed.

05_SEQUOIA_U (L/O 0408)
121
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
2. To remove the child restraint system,
press the buckle release button and
allow the belt to retract.Follow the procedure below for a child
restraint system that requires the use
of a top strap.
Anchor brackets
Use one anchor bracket on the rear of
second seats and two anchor brackets on
the floor as shown above to attach the top
strap.
Anchor bracket is installed for each sec-
ond seating position.
Ð U sin g a to p st rap
(for bench type second seats)

05_SEQUOIA_U (L/O 0408)
122
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
TO USE THE ANCHOR BRACKETS:
1. Remove the head restraint.Outside position
Center position
2. Fix the child restraint system with
the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see ªChild restraintº on
page 107 in this Section.
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
Follow all the installation instructions
provided by its manufacturer.

05_SEQUOIA_U (L/O 0408)
123
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
3. Replace the head restraint.Follow the procedure below for a child
restraint system that requires the use
of a top strap.
Anchor brackets
Use the anchor brackets on the floor as
shown above to attach the top strap.
Anchor bracket is installed for each sec-
ond seat.
Ð U sin g a to p st rap
(for separate type second
seats)

05_SEQUOIA_U (L/O 0408)
124
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
TO USE THE ANCHOR BRACKETS:
1. Remove the head restraint.2. Fix the child restraint system with
the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see ªChild restraintº on
page 107 in this Section.
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
Follow all the installation instructions
provided by its manufacturer.
3. Replace the head restraint.

05_SEQUOIA_U (L/O 0408)
125
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
Anchor brackets Symbol mark
Use the anchor brackets on the back of
the third seats to attach the top strap.
Anchor bracket is installed for right side
and center seating positions.
This symbol indicates the locations of
user ready anchor bracket.TO USE THE ANCHOR BRACKET (right
side):
1. Remove the head restraint.
Ð U sin g a to p st rap
(for third seats)

05_SEQUOIA_U (L/O 0408)
126
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
2. Fix the child restraint system with
the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see ªChild restraintº on
page 107 in this Section.
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
Follow all the installation instructions
provided by its manufacturer.
3. Replace the head restraint.TO USE THE ANCHOR BRACKET
(center):
1. Remove the head restraint.

05_SEQUOIA_U (L/O 0408)
127
2005 SEQUOIA from Aug. '04 Prod. (OM34424U)
The removed head restraint can be
stored in the auxiliary box on the rear
left side panel. For details, see ªHead
restraintsº on page 66 in this Section.
Store the head restraint in the auxiliary
box when it is not in use.
2. Fix the child restraint system with
the seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see ªChild restraintº on
page 107 in this section.