Page 1612 of 1897
SF0LK-01
B02379
B02380
- SFIFUEL PRESSURE REGULATOR
SF-17
1126 Author: Date:
2001 AVALON (RM808U)
REMOVAL
1. REMOVE FUEL PUMP ASSEMBLY FROM FUEL TANK
(See page SF-1 1)
2. REMOVE FUEL FILTER
(a) Remove the screw, and pull out the fuel filter.
Torque: 2.0 N´m (20 kgf´cm, 17 in.´lbf)
(b) Remove the O-ring from the fuel filter.
HINT:
At the time of installation, please refer to the following items. Ap-
ply a light coat of gasoline to a new O-ring, and install it to the
fuel filter.
3. REMOVE FUEL PRESSURE REGULATOR
(a) Remove the screw, and pull out the pressure regulator.
Torque: 2.0 N´m (20 kgf´cm, 17 in.´lbf)
(b) Remove the O-ring from the pressure regulator.
HINT:
At the time of installation, please refer to the following items. Ap-
ply a light coat of gasoline to a new O-ring, and install it to the
pressure regulator.
Page 1619 of 1897
A10838
TOYOTA Hand-Held Tester
DLC3
SF0LD-02
B09075
S05359
Fuel Tube Connector
SF-6
- SFIFUEL PUMP
111 5 Author: Date:
2001 AVALON (RM808U)
FUEL PUMP
ON-VEHICLE INSPECTION
1. CHECK FUEL PUMP OPERATION
(a) Connect a TOYOTA hand-held tester to the DLC3.
(b) Turn the ignition switch ON and TOYOTA hand-held tes-
ter main switch ON.
NOTICE:
Do not start the engine.
(c) Select the active test mode on the TOYOTA hand-held
tester.
(d) Please refer to the TOYOTA hand-held tester operator's
manual for further details.
(e) If you have no TOYOTA hand-held tester, connect the
positive (+) and negative (-) leads from the battery to the
fuel pump connector (See step 7).
(f) Check that there is pressure in the fuel inlet hose from the
fuel filter.
HINT:
If there is fuel pressure, you will hear the sound of fuel flowing.
If there is no pressure, check these parts:
Fusible link
Fuses
EFI main relay
Fuel pump
ECM
Wiring connections
(g) Turn the ignition switch to LOCK.
(h) Disconnect the TOYOTA hand- held tester from the
DLC3.
2. CHECK FUEL PRESSURE
(a) Check the battery positive voltage is above 12 V.
(b) Disconnect the negative (-) terminal cable from the bat-
tery.
(c) Purchase the new No.1 fuel pipe and take out the fuel
tube connector from its pipe.
Part No. 23801-20070
Page 1620 of 1897
B09076
Fuel Hose
Clamp
B09077
B09078
SST
SST
Retainer
No.1 Fuel
Fuel tube
Connector (Hose)
Pipe
SST
(Hose)SST
- SFIFUEL PUMP
SF-7
111 6 Author: Date:
2001 AVALON (RM808U)
(d) Remove the fuel hose clamp.
(e) Disconnect the No.1 fuel pipe (fuel tube connector) from
the fuel filter outlet.
CAUTION:
Perform disconnecting operations of the fuel tube
connector (quick type) after observing the precau-
tions (See page SF-1).
As there is retained pressure in the fuel pipe line, pre-
vent it from splashing inside the engine compart-
ment.
(f) Install SST (pressure gauge) as shown in the illustration
by using SST and fuel tube connector.
SST 09268-41047, 09268-45014
(g) Wipe off any splattered gasoline.
(h) Reconnect the TOYOTA hand-held tester to the DLC3
(See step 1).
(i) Reconnect the negative (-) terminal cable to the battery.
(j) Measure the fuel pressure.
Fuel pressure:
301 - 347 kPa (3.1 - 3.5 kgf/cm
2, 44 - 50 psi)
If pressure is high, replace the fuel pressure regulator.
If pressure is low, check these parts:
Fuel hoses and connections
Fuel pump
Fuel filter
Fuel pressure regulator
(k) Disconnect the TOYOTA hand- held tester from the
DLC3.
(l) Start the engine.
(m) Measure the fuel pressure at idle.
Fuel pressure:
301 - 347 kPa (3.1 - 3.5 kgf/cm
2, 44 - 50 psi)
(n) Stop the engine.
(o) Check that the fuel pressure remains as specified for 5
minutes after the engine has stopped.
Fuel pressure:
147 kPa (1.5 kgf/cm
2, 21 psi) or more
If pressure is not as specified, check the fuel pump, pressure
regulator and/or injectors.
Page 1621 of 1897
B09079
B09076
Fuel Hose
Clamp
S04508
Ohmmeter
4
5
S04509
4
5
Battery SF-8
- SFIFUEL PUMP
111 7 Author: Date:
2001 AVALON (RM808U)
(p) After checking fuel pressure, disconnect the negative (-)
terminal cable from the battery and carefully remove the
SST and fuel tube connector to prevent gasoline from
splashing.
SST 09268-41047, 09268-45014
(q) Reconnect the No.1 fuel pipe (fuel tube connector).
CAUTION:
Perform connecting operations of the tube connector
(quick type) after observing the precautions (See page
SF-1).
(r) Surely install the hose clamp to the fuel filter with ºclickº
sound.
(s) After installing the clamp, check that the clamp is fixed by
pulling up to the clamp.
(t) Reconnect the negative (-) terminal cable to the battery.
(u) Check for fuel leaks.
3. REMOVE REAR SEAT CUSHION
4. REMOVE FLOOR SERVICE HOLE COVER
5. DISCONNECT FUEL PUMP & SENDER GAUGE CON-
NECTOR
6. INSPECT FUEL PUMP RESISTANCE
Using an ohmmeter, measure the resistance between terminals
4 and 5.
Resistance: 0.2 - 3.0 W at 20°C (68°F)
If the resistance is not as specified, replace the fuel pump.
7. INSPECT FUEL PUMP OPERATION
Connect the positive (+) lead from the battery to terminal 4 of
the connector, and the negative (-) lead to terminal 5. Check
that the fuel pump operates.
NOTICE:
These tests must be done quickly (within 10 seconds)
to prevent the coil burning out.
Keep the fuel pump as far away from the battery as
possible.
Always do the switching at the battery side.
Page 1624 of 1897
SF0LF-01
S04583
B02519
Vinyl Bag
- SFIFUEL PUMP
SF-1 1
1120 Author: Date:
2001 AVALON (RM808U)
REMOVAL
CAUTION:
Do not smoke or work near an open flame when working on
the fuel pump.
1. REMOVE REAR SEAT CUSHION
2. REMOVE FLOOR SERVICE HOLE COVER
(a) Take out the floor carpet.
(b) Remove the 5 screws and service hole cover.
HINT:
At the time of installation, please refer to the following items.
Check for fuel leakage.
3. DISCONNECT FUEL PUMP & SENDER GAUGE CON-
NECTOR
NOTICE:
Do not lift the fuel pump up with the wire harness picking.
4. REMOVE NO.1 FUEL TANK PROTECTOR
Remove the 2 bolts and No.1 fuel tank protector.
Torque: 4 N´m (40 kgf´cm, 35 in.´lbf)
5. DISCONNECT FUEL TUBE (FUEL TUBE CONNEC-
TOR)
CAUTION:
Perform disconnecting and connecting operations of
the fuel tube connector (quick type) after observing
the precautions (See page SF-1).
As there is retained pressure in the fuel pipe line, pre-
vent it from splashing inside the vehicle compart-
ment.
6. REMOVE FUEL PUMP ASSEMBLY FROM FUEL TANK
(a) Remove the 6 bolts and fuel tank vent tube set plate.
Torque: 4 N´m (40 kgf´cm, 35 in.´lbf)
(b) Pull out the fuel pump assembly.
(c) Remove the gasket from the pump assembly.
NOTICE:
Do not damage the fuel pump filter.
Be careful that the arm of the sender gauge should
not bent.
HINT:
At the time of installation, please refer to the following items.
Install a new gasket to the pump assembly.
Page 1632 of 1897
SF073-04
B09080
PS Pressure Tube
19.5 (200, 14)39 (400, 19)
Throttle Position
Sensor Connector
Accelerator Cable
IAC Valve Connector
Water Bypass
Hose
Vacuum Hose
Gasket PCV Hose
Air Intake Chamber
Assembly
43 (440, 32)
Throttle Body Bracket
No.1 Engine
Hanger
Ground Cable
Ground Cable
Ground Strap
VSV Connector for No.2 ACIS Purge Hose
Air Assist Hose and Pipe
19.5 (200, 14)
Retainer
Injector Connector Delivery Pipe10 (100, 7)
Spacer
O-Ring
Grommet
Injector
Insulator
O-RingV-Bank Cover
Brake Booster
Vacuum HoseVSV Connector
for No.1 ACIS
VSV Connector
for EVAP
DLC1
Fuel Hose Clamp
Fuel Inlet Hose
N´m (kgf´cm, ft´lbf): Specified
Non-reusable partAir Cleaner Hose
w/ Resonator
Throttle Cable
SF-20
- SFIINJECTOR
1129 Author: Date:
2001 AVALON (RM808U)
COMPONENTS
Page 1634 of 1897
B06483
SST
(Wire)
Battery
B06482
SF-24
- SFIINJECTOR
1133 Author: Date:
2001 AVALON (RM808U)
(j) If you have no TOYOTA hand-held tester, connect the
positive (+) and negative (-) leads from the battery to the
fuel pump connector (See page SF-6).
(k) Connect SST (wire) to the injector and battery for 15 se-
conds, and measure the injection volume with a gra-
duated cylinder. Test each injector 2 or 3 times.
SST 09842-30070
Volume: 60 - 73 cm
3 (3.4 - 4.5 cu in.) per 15 sec.
Difference between each injector:
13 cm
3 (0.8 cu in.) or less
If the injection volume is not as specified, replace the injector.
2. INSPECT LEAKAGE
(a) In the condition above, disconnect the test probes of SST
(wire) from the battery and check the fuel leakage from
the injector.
SST 09842-30070
Fuel drop: 1 drop or less per 12 minutes
(b) Turn the ignition switch OFF.
(c) Disconnect the negative (-) terminal cable from the bat-
tery.
(d) Remove the SST and fuel tube connector.
SST 09268-41047, 09842-30070
CAUTION:
Perform disconnecting operations of the fuel tube
connector (quick type) after observing the precau-
tions (See page SF-1).
As there is retained pressure in the fuel pipe line, pre-
vent it from splashing inside the engine compart-
ment.
(e) Disconnect the TOYOTA hand- held tester from the
DLC3.
Page 1638 of 1897
SF0ZR-02
A10518
5 mm
Hexagon
Wrench
S04505
B06613
B09076
Fuel Hose
Clamp
B09077
- SFIINJECTOR
SF-21
1130 Author: Date:
2001 AVALON (RM808U)
REMOVAL
1. REMOVE V-BANK COVER
(a) Using a 5 mm hexagon wrench, remove the 3 cap nuts.
(b) Loosen the V-bank cover fastener counterclockwise.
(c) Remove the V-bank cover.
2. REMOVE AIR CLEANER HOSE WITH RESONATOR
3. REMOVE AIR INTAKE CHAMBER ASSEMBLY
(See page EM-31)
4. DISCONNECT INJECTOR CONNECTORS
5. REMOVE AIR ASSIST HOSES AND PIPE
6. DISCONNECT NO.1 FUEL PIPE
(a) Remove the fuel hose clamp.
(b) Disconnect the No.1 fuel pipe (fuel tube connector) from
the fuel filter outlet.
CAUTION:
Perform disconnecting operations of the fuel tube
connector (quick type) after observing the precau-
tions (See page SF-1).
As there is retained pressure in the fuel pipe line, pre-
vent it from splashing inside the engine compart-
ment.
