2000 Acura RL 3.5 Owner's Manual

Audi
o Syste m

AM/FM/Cassett e Stere o Audi o

Syste m
Your Acura's audio system provides clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your favorite stations.
The cassette system features Dolby B* noise reduction, automatic
sensing of chromium-dioxide (CrO2)

tape, and autoreverse for continuous
play.
* Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing Corpo-
ration. "DOLBY" and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
The anti-theft feature will disable the system if it is disconnected from the
car's battery. To get the system
working again, you must enter a code number (see page 162 ).
3.5 RL without Navigation System
3.5 RL with Navigation System
Comfor t an d Convenienc e Feature s

Audi
o Syste m

3.5 RL without Navigation System

Operatin g th e Radi o

The ignition switch must be inACCESSORY (I) or ON (II) to operate the audio system. Turn thesystem on by pushing the PWR/
VOL knob or the AM/FM button.
Adjust the volume by turning the
knob.
The band and frequency that the ra-
dio was last tuned to is displayed. To
change bands, press the AM/FM but-
ton. On the FM band, ST will be dis-
played if the station is broadcasting
in stereo. ST will flash if you are driv-
ing in an area where the radio signal
is weak. Stereo reproduction on AM
is not available. You can use any of three methods to
find radio stations on the selected
band: TUNE, SEEK, or the Preset

buttons.

TUN E — Use the TUNE knob to
tune the radio to a desired frequency.
Turn the TUNE knob to the right to tune to a higher frequency, or to the
left to tune to a lower frequency.
Turn the knob right or left until the
display reaches the desired frequen-

cy.

SEE K — The SEEK function
searches the band for a station with
a strong signal. To activate it, push ei-
ther of the SEEK/SKIP buttons (— or +). Push the + button to scan up
from the current frequency, and the — button to scan down. It stops
when it finds a station with a strong
signal.
Prese
t — You can store the
frequencies of your favorite radio stations in the six preset buttons.
Each button will store one frequency

on the AM band, and two

frequencies on the FM band.

CONTINUED
Comfor t an d Convenienc e Feature s

Audi
o Syste m
To store a frequency: 1. Select the desired band, AM or
FM. FM1 and FM2 let you storetwo frequencies with each Preset
button.

2. Use the TUNE or SEEK function

to tune the radio to a desired station.

3. Pick the Preset button you want

for that station. Press the button
and hold it until you hear a beep.

4. Repeat steps 1 to 3 to store a total

of six stations on AM and twelve
on FM.

Once a station's frequency is stored,
simply press and release the proper
Preset button to tune to it.
The preset frequencies will be lost if your car's battery goes dead, is
disconnected, or the radio fuse is
removed. PWR/VO
L
KNO B
SEEK/SKIP
BUTTON S
PRESE T BUTTON S
Comfor t an d Convenienc e Feature s
AM/F
M

BUTTO NSTERE
O
INDICATO RTUN
E
KNO B

Audi
o Syste m

AUTO SELECT — If you are
traveling far from home and can no
longer receive the stations you
preset, you can use the Auto Select
feature to find stations in the local
area.

To activate Auto Select, press the
A. SELECT button. A. SELECT will appear in the display, and the system
will go into scan mode for several seconds. It automatically scans both
bands, looking for stations with strong signals. It stores the frequen-
cies of six AM stations and twelve
FM stations in the preset buttons.
You can then use the preset buttons to select those stations.
If you are in a remote area, Auto
Select may not find six strong AM
stations or twelve strong FM stations.
If this happens, you will see a "0"
displayed when you press any preset
button that does not have a station
stored.
AUT
O SELEC T INDICATO R

AM/F M BUTTO N
AUT
O SELEC T BUTTO N
SEEK/SKI P
BUTTON S
PRESE T BUTTON S
With Auto Select on, you cannot manually store any frequencies in
the preset buttons. If you do not like
the stations found by Auto Select,
you can use the TUNE and SEEK
functions to find other stations. Auto Select does not erase the
frequencies that you preset pre-
viously. When you return home, turn off Auto Select by pressing the A. SELECT button. The preset
buttons will then select the fre-
quencies you originally set.
Comfor t an d Convenienc e Feature s
TUN
E
KNO B

Audi
o Syste m

Adjustin g th e Soun d
Balance /Fader — These two
controls adjust the strength of the sound coming from each speaker.
The Balance control adjusts the side- to-side strength, while the Fadercontrol adjusts the front-to-back

strength.

To adjust the fader, push on the BASS/FADER control knob to get it
to pop out. Pull it out slightly farther, and adjust the front-to-back sound to
your liking. Push the knob back in
when you are done so you cannot change the setting by accidentally
bumping it.
To adjust the balance, push on the
TREBLE/BALANCE control knob to get it to pop out. Pull it out slightly
farther, and adjust the side-to-side sound to your liking. Push the knob
back in when you are done so you
cannot change the setting by
accidentally bumping it. BASS/FADE
R
CONTRO L
TREBLE/BALANC
E

CONTRO L

Treble/Bas s — Use these controls
to adjust the tone to your liking.
To adjust the Treble level, push on the TREBLE/BALANCE control
knob to get it to pop out. Without
pulling it out farther, turn the knob
to adjust the treble level. Push the
knob back in when you are done so
you cannot change the setting by accidentally bumping it. To adjust the Bass level, push on the
BASS/FADER control knob to get it
to pop out. Without pulling it out
farther, turn the knob to adjust the
bass level. Push the knob back in
when you are done so you cannot change the setting by accidentally

bumping it.

Comfor t an d Convenienc e Feature s

Audi
o Syste m

Audi o Syste m Lightin g
You can use the instrument panel brightness control dial to adjust the il-
lumination of the audio system (see
page 66 ). The audio system illuminates when the parking lights
are on, even if the radio is turned off.

Radi o Frequencie s an d Reception

For information, See page 149 .
Operatin
g th e Cassett e Playe r
The ignition switch must be in
ACCESSORY (I) or ON (II). Make sure the tape opening on the
cassette is facing to the right, then
insert the cassette most of the way
into the slot. The system will pull it
in the rest of the way, and begin to

play.

The tape direction indicator will light to show you which side of the cassette is playing. The indicates
the side you inserted facing upward is now playing. If you want to play
the other side, press the PROG/PLAY button.
Dolby B noise reduction turns on
when you insert a cassette. The indicator will light in the dis-
play. If the tape was not recorded
with Dolby B noise reduction, turn it off by pressing the button.When the system reaches the end of
the tape, it will automatically reversedirection and play the other side. If
you want to remove the cassette from the drive, press the EJECT
button.
If you turn the system off while a
tape is playing, either with the PWR/
VOL knob or by turning off the ignition, the cassette will remain in
the drive. When you turn the system
back on, the tape will begin playing
where it left off.
To switch to the radio or CD changer while listening to a tape,
press the AM/FM or CD/TAPE but-
ton. To change back to the cassette
player, press the CD/TAPE button.

Comfor t an d Convenienc e Feature s

Audi
o Syste m

Tap e Searc h Function s

With a cassette playing, you can use the FF, REW, TMS, or REPEAT
function to find a desired program.
FF /REW — Fast Forward and Re-
wind move the tape rapidly. To re-
wind the tape, push the REW button.
You will see REW in the display. To fast forward the tape, push the FFbutton. You will see FF displayed.Press the PROG/PLAY button to
take the system out of rewind or fast
forward. When the system reaches the end of the tape, it reversesdirection and begins to play if in fast
forward, or it begins to play if in

rewind.

Comfor t an d Convenienc e Feature s
AM/F
M BUTTO N

PWR/VO L KNO B
CASSETT
E SLO T
TMS INDICATO R
DOLB Y INDICATO R
TAP E
DIRECTIO N
INDICATO R
EJEC
T

BUTTO N

REPEA T

INDICATO R
TM S

BUTTO N

REPEA
T

BUTTO N
PROG/PLA Y
BUTTO N
REWIN D
BUTTO N DOLB
Y BUTTO N
FAS T FORWAR D
BUTTO N
CD/TAP
E BUTTO N

Audi
o Syste m

TM S — The Tape Music Search
Function allows you to find the begin-
ning of a song or passage. To acti-
vate TMS, press the TMS button.
You will see TMS displayed. To find the beginning of the song or passagecurrently playing, push the REW but-
ton. You will see REW flashing in the display as the tape rewinds. To find
the beginning of the next song, push
the FF button. You will see FF
flashing in the display as the tape
fast forwards. When the system
finds the beginning of a song or pas- sage, it goes back to PLAY mode.
Press the TMS button again to turn
it off.

CONTINUED

Comfor t an d Convenienc e Feature s
CASSETT
E SLO T
TM S INDICATO R

EJECT

BUTTO N

REPEA T
INDICATO R

REPEA T

BUTTO N
TM S BUTTO N
FAS T FORWAR D
BUTTO N
REWIN
D
BUTTO NPWR/VO
L KNO B

TAP E

DIRECTIO N

INDICATO R