1999 Lexus ES300 Owner's Manuals (in English)

STARTING AND DRIVING
285
CAUTION
Do not rely excessively on the vehicle skid control
system. Even if the vehicle skid control system is
operating, it is not that your vehicle is absolutely
safe. Reckless driving will result in an unexpected
accident. Always keep safety driving in mind. If the
slip indicator light flashes, sounding an alarm,
special care should be taken while driving.
 Only use tires of specified size. The size,
manufacturer, brand and tread pattern for all 4 tires
should be the same. If you use the tires other than
specified, or different type or size, the vehicle skid
control system may not function correctly. When
replacing the tires or wheels, contact your Lexus
dealer.

STARTING AND DRIVING
286
BRAKE SYSTEM
The tandem master cylinder brake system is a hydraulic
system with two separate sub±systems. If either
sub±system should fail, the other will still work.
However, the pedal will be harder to press, and your
stopping distance will be longer. Also, the brake system
warning light may come on.
CAUTION
Do not drive your vehicle with only a single brake
system. Have your brakes fixed immediately.
Brake booster
The brake booster uses engine vacuum to power±assist
the brakes. If the engine should quit while you are
driving, you can bring the vehicle to a stop with normal
pedal pressure. There is enough reserve vacuum for
one or two stops but no more!

STARTING AND DRIVING
287
CAUTION
Do not pump the brake pedal if the engine stalls.
Each push on the pedal uses up your vacuum
reserve.
 Even if the power assist is completely lost, the brakes
will still work. But you will have to push the pedal
hard ± much harder than normal. And your braking
distance will be longer.

STARTING AND DRIVING
288
Anti±lock brake system
The anti±lock brake system is designed to
automatically help prevent lock±up of the wheels
during a sudden brake or braking on slippery road
surfaces. This assists in providing directional
stability and steering performance of the vehicle
under these circumstances.
The anti±lock brake system becomes operative after the
vehicle has accelerated to a speed in excess of
approximately 10 km/h (6 mph). It stops operating when
the vehicle decelerates to a speed below approximately
5 km/h (3 mph).
You may hear a sound in the engine compartment for a
few seconds when the engine is started or just after the
vehicle is started. This means that the anti±lock brake
system is in the self±check mode, and does not indicate
a malfunction.
Effective way to press the ABS brake pedal: When the
anti±lock brake system function is in action, you may feel the
brake pedal pulsating and hear a noise. In this situation, to
let the anti±lock brake system work for you, just hold the
brake pedal down more firmly. Do not pump the brake in a
panic stop. Pumping the brake pedal makes the stopping
distance longer.

STARTING AND DRIVING
289
The brake pedal pulsation caused by the anti±lock brake
system may indicate hazardous road surface
conditions. Although the anti±lock brake system assists
in providing vehicle control, it is still important to drive
with all due care, because the anti±lock brake system
cannot overcome the laws of physics that act on your
vehicle:

Braking capability is dependent on tire friction with the
road surface. 
Even though the anti±lock brake system is operating,
a driver cannot maintain full control on certain
slippery road surfaces, when cornering at high
speeds, or in violent maneuvers.
 Avoid high speeds on wet roads. The anti±lock brake
system cannot eliminate the risk of hydroplaning and
loss of tire friction.
Always maintain a safe distance from the vehicle in front
of you. Compared with vehicles not fitted with an
anti±lock brake system, your vehicle may require a
longer stopping distance in the following cases:
 Driving on rough, gravel or snow±covered roads.
 Driving with tire chains installed.
 Driving on roads where the road surface is pitted or
has other differences in surface height.

STARTING AND DRIVING
290ºABSº warning light
31E015

STARTING AND DRIVING
291
This light comes on when the ignition key is turned
to the ºONº position. After about a few seconds, the
light will go off.
If either of the following conditions occurs, this indicates
a malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle.

The light does not come on as described above, or
remains on.
 The light comes on while driving.
Even if the anti±lock brake system should fail, the brake
system will still operate conventionally. But when the
ºABSº warning light is on (and the brake system warning
light is off), anti±lock brake system is not assisting brake
performance so that the wheels could lock up during a
sudden brake or braking on slippery road surfaces.
Have your vehicle checked by your Lexus dealer as
soon as possible.
Drum±in±disc type parking brake system
Your vehicle has a drum±in±disc type parking brake
system. This type of brake system needs
bedding±down of the brake shoes periodically or
whenever the parking brake shoes and/or drums are
replaced.
Have your Lexus dealer perform the bedding±down.

STARTING AND DRIVING
292
BRAKE PAD WEAR LIMITINDICATORS
31E016
The brake pad wear limit indicators on your disc
brakes give a warning noise when the brake pads
are worn to the extent that replacement is required.
If you hear a squealing or scraping noise while driving,
have the brake pads checked and replaced by your
Lexus dealer as soon as possible. Expensive rotor
damage can result if the pads are not replaced when
needed.TYPES OF TIRES
Determine what kind of tires your vehicle is originally
equipped with.