1999 Lexus ES300 Owner's Manuals (in English)

COMFORT ADJUSTMENT
165
CAUTION
Never put a rear±facing child restraint system on the
front seat. In the event of an accident, the force of the
rapid inflation of the airbag can cause death or
serious injury if a rear±facing child restraint system
is put on the front seat.
 Unless it is unavoidable, do not put a forward±facing
child restraint system on the front seat.
A forward±facing child restraint system should be
put on the front seat only when it is unavoidable.
Always move the seat as far back as possible,
because the force of a deploying airbag could cause
death or serious injury to the child. Do not allow the
child to lean over the front door or around the front
door even if the child is seated in a child restraint
system. It is dangerous if the side airbag inflates, and
the impact could cause death or serious injury to the
child.
 After installing the child restraint system, make sure
it is secured in place according to the manufacturer's
instructions. If it is not restrained securely, it may
cause death or serious injury to the child in the event
of a sudden stop or accident.

COMFORT ADJUSTMENT
166When not using the child restraint system, keep it
secured with the seat belt or place it in the trunk or
somewhere other than in the passenger compartment.
This will prevent it from injuring passengers in the event
of a sudden stop or accident.
Your vehicle has anchors for securing the top strap of a
child restraint system. The anchor nuts are welded
beneath the sheet metal to permit installation of an
anchor bracket for a child restraint system.
To install an anchor bracket, use an 8 mm X 30 mm X
1.25 mm coarse thread metric bolt and a 15 mm (0.6 in.)
spacer. Note that the bolts accompanying many child
restraint systems are not metric. You can damage the
anchor nuts on your vehicle if you force bolts with
different thread into the anchor nuts.
For instructions about how to install the anchor bracket,
see ºTop strap anchors and locationsº.
If your child restraint system does not provide any of the
necessary parts, you can purchase the following items
from your Lexus dealer.

CRS installation kit (Part No. 04731±22012)
± contains 1 bolt, 3 types of spacer and 1 locking clip.
 Bolt (Part No. 91511±60830)

COMFORT ADJUSTMENT
167
Types of child restraint system
Child restraint systems are classified into the following
3 types depending on the child's age and size.
(A) Infant seat
(B) Convertible seat
(C) Booster seat
Install the child restraint system following the
instructions provided by its manufacturer.
(A) Infant seat
16E103a

COMFORT ADJUSTMENT
168(B) Convertible seat
16E104±2
(C) Booster seat
16E105±3

COMFORT ADJUSTMENT
169
INSTALLATION WITH 3±POINT TYPE SEAT BELT
(A) Infant seat installation
16E103a
An infant seat is used in rear±facing position only.

COMFORT ADJUSTMENT
170
16E100a
CAUTION
Never put a rear±facing child restraint system in the
front seat because the force of the rapid inflation of the
front passenger airbag can cause death or serious
injury to the child.

COMFORT ADJUSTMENT
171
16E106±2
1. Run the lap and shoulder belt through or around the
infant seat following the instructions provided by its
manufacturer and inserting the tab into the buckle taking
care not to twist the belt. Keep the lap portion of the belt
tight.

COMFORT ADJUSTMENT
172
CAUTION
After inserting the tab, make sure the tab and buckle
are locked and that the lap and shoulder portions of
the belt are not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally,
immediately contact your Lexus dealer. Do not use
the seat until the seat belt is fixed. It cannot protect
your child from injury.
16E107±2
2. Fully extend the shoulder belt to put it in the lock
mode. When the belt is then retracted even slightly, it
cannot be extended.
To hold the infant seat securely, make sure the belt is in
the lock mode before letting the belt retract.