1999 Lexus ES300 Owner's Manuals (in English)

STARTING AND DRIVING
269
(c) Using the º2º and ºLº positions
The º2º and ºLº positions are used for strong engine
braking as described previously.
With the selector lever in º2º or ºLº, you can start the
vehicle in motion as with the lever in ºDº.
With the selector lever in º2º, the vehicle will start in the
first gear and automatically shift to the second gear.
With the selector lever in ºLº, the transmission is
engaged in the first gear.
NOTICE
Be careful not to overrev the engine. Watch thetachometer to keep engine rpm from going intothe red zone. The approximate maximumallowable speed for each position is givenabove for your reference.
º2º 128 km/h (80 mph) . . .
ºLº 70 km/h (43 mph) . . .
Do not continue hill climbing or hard towing for
a long time in the º2º or ºLº position. This maycause severe automatic transmission damagefrom overheating. To prevent such damage,
ºDº position should be used in hill climbing orhard towing.

STARTING AND DRIVING
270
(d) Backing up
31E010

1Brake pedal 2ºRº (Reverse) position
1. Bring the vehicle to a complete stop.
2. With the brake pedal held down with your foot, shift
the selector lever to the ºRº position.
NOTICE
Never shift into reverse while the vehicle ismoving.

STARTING AND DRIVING
271
(e) Parking
31E011±1

1Brake pedal 2Parking brake pedal
3ºPº (Park) position
1. Bring the vehicle to a complete stop.
2. Depress the parking brake fully to securely apply the
parking brake.
3. With the brake pedal held down with your foot, shift
the selector lever to the ºPº position.
CAUTION
While the vehicle is moving, never attempt to move the
selector lever into ºPº under any circumstances.
Serious mechanical damage and loss of vehicle control
may result.

STARTING AND DRIVING
272
(f) Good driving practice
If the transmission repeatedly upshifts and
downshifts between the third and overdrive gears
when climbing a gentle slope, turn off the overdrive
switch. Be sure to turn the switch on immediately
after climbing the slope.
 When towing a trailer, in order to maintain efficient
engine braking and electrical charging performance,
do not use overdrive.
CAUTION
Always keep your foot on the brake pedal while stopped
with the engine running. This prevents the vehicle from
creeping.
NOTICE
Do not hold the vehicle on an upgrade with the accelerator pedal. This can cause thetransmission to overheat. Always use the brakepedal or parking brake.
(g) Rocking your vehicle if stuck
CAUTION
If your vehicle becomes stuck in snow, mud, sand, etc.,
then you may attempt to rock the vehicle free by moving
it forward and backward. Do not attempt this procedure
if people or objects are anywhere near the vehicle.
During the rocking operation the vehicle may suddenly
move forward or back as it becomes un±stuck, causing
injury or damage to nearby people or objects.

STARTING AND DRIVING
273
NOTICE
If you rock your vehicle, observe the followingprecautions to prevent damage to thetransmission and other parts.
Do not depress the accelerator pedal whileshifting the selector lever or before thetransmission is completely shifted to forwardor reverse gear.
Do not race the engine and avoid spinning thewheels.
If your vehicle remains stuck after rocking thevehicle several times, consider other wayssuch as towing.
(h) If you cannot shift the selector lever out of ºPº position
If you cannot shift the selector lever from ºPº position
even though the brake pedal is depressed, use the shift
lock override button. For instructions, see ºIf you cannot
shift automatic transmission selector leverº on page
346.

STARTING AND DRIVING
274
CRUISE CONTROL
The cruise control allows you to cruise the vehicle
at a desired speed over 40 km/h (25 mph) with your
foot off the accelerator pedal.
Your cruising speed can be maintained although a slight
speed change may occur when driving up or down a
gradient, within the limits of engine performance. On
steeper hills, a great speed change will occur so it is
better to drive without the cruise control.
CAUTION
To help maintain maximum control of your vehicle,
do not use the cruise control when driving in heavy
or varying traffic, or on slippery (rainy, icy or
snow±covered) or winding roads.
 Avoid vehicle speed increases when driving
downhill. If the vehicle speed is too fast in relation to
the cruise control set speed, cancel the cruise
control then downshift the transmission to use
engine braking to slow down.

STARTING AND DRIVING
275
Turning on the system
31L013
To operate the cruise control, push the main switch. This
turns the system on. The indicator light in the instrument
cluster shows that you can now set your desired cruising
speed. Another push on the switch will turn the system
completely off.
When the ignition key is turned off, the main switch is
also automatically turned off. To use the cruise control
again, push the main switch again to turn it on.
CAUTION
To avoid accidental cruise control engagement, keep
the main switch off when not using the cruise control.

STARTING AND DRIVING
276
Setting at a desired speed
31L014
The transmission must be in ºDº before you set the
cruise control speed.
Bring the vehicle to the desired speed, press the control
lever downward in the ºSET/COASTº direction and
release it. This sets the vehicle at that speed. Now you
may take your foot off the accelerator pedal. If you need
acceleration ± for example, when passing ± depress the
accelerator pedal enough for the vehicle to exceed the
set speed. When you release the accelerator pedal, the
vehicle will return to the speed set prior to the
acceleration.Cancelling the preset speed
You can cancel the preset speed by either of the
following:
a. Pulling the control lever in the ºCANCELº direction.
b. Depressing the brake pedal.
If the vehicle speed falls below about 40 km/h (25 mph),
the preset speed will be automatically cancelled.
If the vehicle speed drops 16 km/h (10 mph) below the
preset speed, the preset speed will also automatically be
cancelled.
If the preset speed automatically cancels out for other
than these reasons, have your vehicle checked by your
Lexus dealer at the earliest opportunity.