1999 GMC C-SERIES Owners Manual

yellowblue
2-23 Eaton Fuller Transmission with Clutch
Brake (Option)
Some vehicles have an optional clutch brake. It engages
when you push your clutch pedal all the way to the
floor. Use it when you shift into first or reverse gear.
Press the clutch pedal as far as it will go and then make
your shift. If the engagement isn't smooth when you
engage the clutch, press the clutch pedal in and then
immediately re
-engage it. Use the clutch brake only
with the engine idling and the vehicle standing still.
If you have this feature, see the Eaton Fuller
Transmission Driver Instructions Manual before
operating your vehicle.
Eaton Fuller Transmission with
Countershaft Brake (If Equipped)
The countershaft brake is used when you shift from a
standing start into FIRST (1) or REVERSE (R). You
will find this feature on vehicles with gasoline engines
and Eaton Fuller 9 or 10
-speed transmissions.
See the Eaton Fuller Transmissions Driver
Instructions Manual.
Parking
CAUTION:
If you don't park your vehicle properly, it can
roll. If you've left the engine running, it can move
very quickly. You or others could be injured.
To be sure your vehicle won't move, even when
you're on level ground, follow the steps below.
Two-Speed Rear Axle
1. With the engine running, shift the two-speed rear
axle into low. To be sure it's in low, you'll need to
move the vehicle in gear just a little.
2. Hold the regular brake pedal down with your
right foot.
3. Apply the parking brake.
4. Shift the transmission to NEUTRAL (N) or
PARK (P).
ProCarManuals.com

yellowblue
2-24 Hydraulic Brakes
If your vehicle has hydraulic brakes, it has a parking
brake lever or an electric/hydraulic parking brake. The
lever is below the instrument panel to the left of the
steering column. The electric/hydraulic parking brake
knob is to the right of the steering column.
Your vehicle may also be equipped with an automatic
transmission which has a shift lever. This lever will have
a PARK (P) position on the shift indicator. When the
PARK (P) position is selected with the shift lever, the
parking brake is automatically applied.
Propshaft Brake Burnish Procedure
It is recommended that the propshaft-mounted parking
brake be burnished as part of the new vehicle break
-in.
The parking brake will work best after it has been
burnished following these instructions.
Make 10 stops, using the parking brake hand lever, from
20 mph (32 km/h) about 2 1/2 miles (4 km) apart.
Between stops, drive the vehicle at 20 mph (32 km/h).
Lever Operated Parking Brake
To apply the parking brake,
pull the lever all the way up.
The PARK BRAKE light
will come on when the
parking brake is applied.
Then shift the transmission
to NEUTRAL (N) or
PARK (P).
The vehicle must be stopped when applying the parking
brake, except while burnishing the parking brake linings
(see ªPropshaft Brake Burnish Procedureº in the Index).
You can easily adjust the parking brake by turning the
knob on the lever. Turning it clockwise makes the brake
grip more tightly. It will also make the lever seem harder
to pull up. Turning the knob counterclockwise makes the
parking brake apply less firmly. Adjust the parking
brake only when the lever is down (released).
ProCarManuals.com

yellowblue
2-25
If your parking brake doesn't hold the vehicle when
applied, see your GM Truck dealer who can adjust your
parking brake properly.
To release the parking
brake, first push down the
regular brake pedal. Then,
push the parking brake lever
all the way down and shift
the automatic transmission
to NEUTRAL (N).
The PARK BRAKE light will remain illuminated if the
parking brake is not fully released.
NOTICE:
Driving with the parking brake on can overheat
the parts in the system. You may have to replace
them, and you could also damage other parts of
your vehicle.
Electric/Hydraulic Parking Brake
(If Equipped)
CAUTION:
It will take a few seconds for the parking brake
to fully apply, and even longer when it is cold
outside. Do not leave your vehicle until the
parking brake applies fully. Without the parking
brake applied, your vehicle is free to move. It
could hit someone or something.
ProCarManuals.com

yellowblue
2-26
If your vehicle has this
system, you will have a
knob to the right of the
steering column.
To apply the parking brake, pull the knob toward you.
Then shift the transmission to NEUTRAL (N) or
PARK (P).
Push the knob in to release the parking brake. The
ignition must be in RUN and the shift lever out of
PARK (P) in order to release the parking brake.
The parking brake will automatically apply if the
ignition is turned off and in PARK (P) and will also
apply (will not release) if the vehicle's battery is dead
or disconnected.The PARK BRAKE light may flash while the parking
brake is being applied or released. This is normal for
this system.
If your vehicle needs towing or the parking brake will
not release, the towing operator will need to disconnect
the propshaft before towing your vehicle. See ªTowing
Your Vehicleº in the Index.
Air Brake (If Equipped)
CAUTION:
When the yellow SYSTEM PARK and the red
TRAILER AIR SUPPLY knobs are both pushed
in, your rig will be free to move. It could strike
someone or something. When both of these knobs
are pushed in, either hold the regular brake
pedal down or, if you have it, pull out the blue
TRACTOR PARKING knob, to keep your rig
from moving.
ProCarManuals.com

yellowblue
2-27
If your vehicle has air
brakes, you will have this
control. Pulling it out
applies the parking brake.
The PARK BRAKE light
will come on when the air
parking brake is applied.
Vehicles built for use as tractors or towing vehicles have
one or two more air brake controls. They look like this:To charge a trailer's air brake system:
1. Move your tractor into the proper position. Apply the
parking brake by pulling the yellow SYSTEM PARK
knob out.
2. Hook up the trailer air system properly.
3. Get into the tractor. Push and hold down the regular
brake pedal.
4. Push in both the yellow SYSTEM PARK and the red
TRAILER AIR SUPPLY knobs. This will charge
your trailer's air system.
If you have the blue TRACTOR PARKING knob,
pull it out to set the tractor brakes while the air system
is charging.
After a few minutes, the trailer system should be fully
charged. When it is, the air pressure gage will show
about 125 to 135 psi (862 to 931 kPa) and you may hear
the ªpop offº valve operate.
For driving with a trailer, the yellow, red and blue
(if equipped) knobs all must be pushed in. It's the same
when you're not pulling a trailer except that the red
TRAILER AIR SUPPLY knob must be out.
ProCarManuals.com

yellowblue
2-28
CAUTION:
If you apply any one of the air brake parking
controls while the vehicle is moving, your rig will
stop suddenly. If you are not ready for this, you
or others could be injured. Don't apply any one
of these controls while you're driving, unless you
have to make an emergency stop.
If the air pressure drops below 60 to 70 psi (413 to
482 kPa), the PRIMARY BRAKE light will come on. If
the air pressure drops to 40 to 45 psi (275 to 309 kPa), the
yellow knob will automatically pop out and apply the
spring brakes. If you ever have a complete loss of air so
that your air brakes automatically apply, there is a way that
the tow operator can release the parking brakes to tow the
vehicle. See ªTowing Your Vehicleº in the Index.
CAUTION:
If your vehicle is left in gear, the engine can
start if the vehicle starts to roll. This can easily
happen if you have the diesel engine. Shift the
transmission into NEUTRAL (N) before you
leave the vehicle.
ProCarManuals.com

yellowblue
2-29
Parking Over Things That Burn
CAUTION:
Things that can burn could touch hot exhaust
parts under your vehicle and ignite. Don't park
over papers, leaves, dry grass or other things that
can burn.
Engine Exhaust
CAUTION:
Engine exhaust can kill. It contains the gas
carbon monoxide (CO), which you can't see or
smell. It can cause unconsciousness and death.
You might have exhaust coming in if:

Your exhaust system sounds strange
or different.

Your vehicle gets rusty underneath.

Your vehicle was damaged in a collision.

Your vehicle was damaged when driving
over high points on the road or over
road debris.

Repairs weren't done correctly.

Your vehicle or exhaust system had been
modified improperly.
If you ever suspect exhaust is coming into
your vehicle:

Drive it only with all the windows down to
blow out any CO; and

Have your vehicle fixed immediately.
ProCarManuals.com

yellowblue
2-30
Running Your Engine While You're
Parked (Automatic Transmission)
It's better not to park with the engine running. But if
ever you have to, here are some things to know.
CAUTION:
Idling the engine with the climate control system
off could allow dangerous exhaust into
your vehicle (see the earlier Caution under
ªEngine Exhaustº).
Also, idling in a closed-in place can let deadly
carbon monoxide (CO) into your vehicle even if
the fan switch is at the highest setting. One place
this can happen is a garage. Exhaust
-- with
CO
-- can come in easily. NEVER park in a
garage with the engine running.
Another closed-in place can be a blizzard.
(See ªBlizzardº in the Index.)
CAUTION:
It can be dangerous to get out of your vehicle
without the parking brake firmly set. Your
vehicle can roll. If you've left the engine running,
the vehicle can move suddenly. You or others
could be injured. To be sure your vehicle won't
move, even when you're on fairly level ground,
always set your parking brake.
Follow the proper steps to be sure your vehicle
won't move.
Windows
Manual Windows
Turn the hand crank on each door to raise or lower
the window.
ProCarManuals.com