1997 HONDA CIVIC Workshop Manual

Page 1633 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Circuit Diagram (USA)
l|-
RED/BLK
II
I
\?
PABK NG LIGHTSTA LL GHTSL CENSE PLATE L GHTS
RED/ELK
III
I
r
DASH LIGHTSDASH LIGHTSERIGHTNESSCONTROLLER
HIGH BEAMIND CATORLIGHT(r 4w)
REDiGRN
I
BLK
I
G401G4A

Page 1634 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Lighting System
Circuit Diagram (Canada)
UNDER.HOOD FUSEi RELAY BOXBATTERY
BFAKE SYSTEMLIGHTNTEGRATEDCONTROL UNIT
f-7
I
IFED/GRN
REDiGFN
II
o
Yro*, ,,roI LEVEL SW TCH
t | 
lclosed : Floal downl
BLK
I

Page 1635 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Combination Light Switch Test
1.Remove the drivers dashboard lower cover and steering column covers (see section 20)
Disconnect the 4P and 7P connectors from the switch.
Inspect the connector and soc

Page 1636 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Lighting System
Daytime Running Lights Control Unit Input Test (Canadal
2.
3.
LRemove the drivers dashboard lower cover and
knee bolster (see section 20).
Disconnect the connectors from the daytime r

Page 1637 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Headlights/Front Turn
Signal/Parking Lights
Daytime Running Lights Resistor
Test (Canada)
CAUTION: The daytime running lights resistor becomes
very hot when the daytime running lights are on; do not
t

Page 1638 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Headlights
Adjustment
Eoforo adiu3ting th€ h.adlights:
. Park the vehicle on level surface.
. Make sure the tire prgssures are correct.
a The driver or someone who weighs the same should
sit in the

Page 1639 of 2189

HONDA CIVIC 1997 6.G Workshop Manual 99 - 00 models
1. Clean the outer lens so that you can see the center
of the headlights (A).
l,-
2. Park the vehicle in front of a wall or a screen (A).
A
4.
Open the hood.
Turn the horizontal adjust

Page 1640 of 2189

HONDA CIVIC 1997 6.G Workshop Manual Headlights
Adjustment (contdl
Turn the low beams on.
Determine if the headlights are aimed properly.
Vsrtical adiustmsnt:
Measure the height of the headlights (A). The lights
should reflect 52 mm \2.