FRONT AXLE Drive Shaft
0 0 0 0 3 4 2 1
0 0 0 0 3 4 2 2
0 0 0 0 3 4 2 3 (5) Use the special tool
crimp the B.J. boot band
Caution
(1) Hold the drive and use the
special tool to crimp the B.J.
(2) Crimp the B.J. boot special tool
‘touches the stopper.
(6) Check that the crimped width (B) within the stand&d
value.
Standard value (B): 2.4 2.8 in.)
than 2.8 mm
Readjust the dimension of the
value calculated by the
and repeat step (5).
5.5 mm in.)
Example: If (B) is 2.9 mm in.), is 2.6
mm
in.).
in.)>
R e m o v e t h e B . J . b o o t
d i m e n s i o n ( W ) o f s t e p
calculated by the following
a new B.J. boot band to to
(5). 5.5 mm in.)
Example: If is 2.3 is
3.2 mm
in.).
(7) Check that the B.J. boot is secured If,
the band is secured incorrectly, repeat steps (4) t o (6)
to replace it.
(8) Apply the specified amount ‘of
the
Specified grease: Repair 95 ‘oz.) ,
(9) Install the B.J. boot to adjust the clearance ( C)
the B.J. boot end and the stepped of B.J.
housing is within the standard
value (C): 0.1 1.55 mm in.)
(lO)Adjust the opening dimension to the standard value
as mentioned at the step (3).
Standard value (W): 3.2 mm
TSB Revision
F R O N T A X L E __ ,
Protrudingportion
B.J. boot band
the B.J. boot band (large) along, the
portion, and install it so that,, there is
the other side.
the special tool to crimp the B.J.
in the same way as the step
I
section
Bearing
that the crimped width (E) is within the
value.
Standard value (E): 2.4 2.8
Readjust the dimension of (10) to
the value calculated equation,’
and repeat step (12).
5.8 mm in.)
Example: If (E) is 2.9 mm in.), is 2.9
mm
in.):
in.)>
Remove the B.J. boot band, readjust the
dimension (W) of step (10) to the value
calculated by equation, and use
a new B.J. boot band to repeat steps (11) to.
5.8 mm in.)
Example: If (E) is 2.3 is 3.5
mm
in.).
that the boot band is correctly.
is secured incorrectly, repeat steps (13) to replace
it.
SPIDER ASSEMBLY’ INSTALLATION
Install the spider assembly to the shaft from the d irection
of the
s e c t i o n .
CENTER BEARING INSTALLATION
