1986 TOYOTA CAMRY V20 belt

Power Steering Pump
REMOVAL AND INSTALLATION OF POWER
STEERING PUMP (SV21 Series)
Remove and install the parts as shown.
(MAIN POINT OF INSTALLATION)
ADJUST DRIVE BELT TENSION AFTER INSTALLING PS
PUMP
(See page SR±22)
± STEERINGPower Steering (Power Steering Pump)SR±27

(MAIN POINTS OF REMOVAL AND
INSTALLATION)
1. DISCONNECT AND CONNECT PRESSURE LINE
Using SST, disconnect and connect the pressure line.
SST 09631±22020
HINT: When connecting, use a torque wrench with a ful-
crum length of 340 mm (13.39 in.).
3. REMOVE DRIVE BELT
(a) Loosen the adjusting bolt and the through bolt and
push the PS pump forward.
(b) Remove the drive belt. 2. DISCONNECT TIE ROD END RH
(a) Remove the cotter pin and nut.
(b) Using SST, disconnect the tie rod end RH.
SST 09610±55012
4. REMOVE PUMP BRACKET
(a) Remove the adjusting bolt.
(b) Remove the bolt and bracket.
5. REMOVE REAR PUMP STAY
Remove the two bolts and stay.
± STEERINGPower Steering (Power Steering Pump)SR±29

(MAIN POINTS OF REMOVAL AND
INSTALLATION)
1. DISCONNECT AND CONNECT PRESSURE LINE
Using SST, disconnect and connect the pressure line.
SST 09631±22020
HINT: When connecting, use a torque wrench with a ful-
crum length of 340 mm (13.39 in.).
(b) Loosen the through bolt and push the PS pump for-
ward.
(c) Remove the drive belt.
4. REMOVE PS PUMP WITH PRESSURE TUBE
Remove the adjusting bolt and through bolt, then remove
PS pump from the lower side of vehicle body. 2. DISCONNECT TIE ROD END RH
(a) Remove the cotter pin and nut.
(b) Using SST, disconnect the tie rod end RH.
SST 09628±62011
3. REMOVE DRIVE BELT
(a) Loosen the adjusting bolt.
5. REMOVE PRESSURE TUBE
± STEERINGPower Steering (Power Steering Pump)SR±32