2023 FORD MAVERICK light

[x] Cancel search: light

Page 283 of 556

FORD MAVERICK 2023  Owners Manual DRIVING IN SPECIAL
CONDITIONS
DRIVING THROUGH MUD ANDWATER
Mud
Be cautious of sudden changes in vehiclespeed or direction when you are driving inmud. Even all-wheel drive and four-wheeldrive vehicles

Page 284 of 556

FORD MAVERICK 2023  Owners Manual Note:Do not rock your vehicle if the engineis not at normal operating temperature, asdamage to the transmission could occur.
Note:Do not rock your vehicle for morethan a minute, as damage to thetransm

Page 288 of 556

FORD MAVERICK 2023  Owners Manual 1.Exit the vehicle immediately.
2.Advise emergency assistance that anelectric or hybrid-electric vehicle isinvolved.
3.As with any vehicle fire, do not inhalesmoke, vapors or gas from the vehicle,as t

Page 303 of 556

FORD MAVERICK 2023  Owners Manual Protected ComponentRatingItem
Not used.—46
Heated seats.20 A47
Trailer tow lighting modulebattery charge.30 A48
Anti-lock brake controlpump.60 A49
Cooling fan.60 A50
Moonroof.30 A51
Powertrain contr

Page 304 of 556

FORD MAVERICK 2023  Owners Manual Protected ComponentRatingItem
Port fuel injectors.15 A70
Rear of console power point.20 A71
Media bin power point.20 A72
USB charger - floor console- rear.5 A73
Not used.—74
Windshield wiper motor.3

Page 319 of 556

FORD MAVERICK 2023  Owners Manual 7.Install a new air filter element.  Becareful not to crimp the filter elementedges between the air filter housingand cover.  This could cause filterdamage and allow unfiltered air toenter the engine

Page 321 of 556

FORD MAVERICK 2023  Owners Manual The battery warning lamp flashes threetimes to confirm that the reset issuccessful.
Battery Management System (If
Equipped)
The system monitors battery conditionsand takes actions to extend battery li

Page 322 of 556

FORD MAVERICK 2023  Owners Manual Note:Before reconnecting the battery,make sure the ignition remains switched off.
Note:Make sure to fully tighten the batterycables.
If you disconnect or replace the vehiclebattery, you must reset the