Page 195 of 818
193
3
3-2. Opening, closing and locking the doors
Operation of each component
C-HR_HV_OM_Europe_OM10720E
Side doors
◆Entry  function  (vehicles  with  a  smart  entry  &  start  system
equipped with entry function) 
Carry the electronic key to enable this function. 
Grip  the  front  door  handle  to 
unlock all the doors.*
Make  sure  to  touch  the  sensor 
on the back of the handle. 
The  doors  cannot  be  unlocked 
for 3 seconds after the doors are 
locked.
Touch  the  lock  sensor  (the 
indentation  on  the  surface  of 
the front door handle) to lock 
all the doors.
Check that the door is securely locked.
*: The door unlock settings can be changed. ( P. 198)
Unlocking and locking the doors from the outside 
         
        
        
     
        
        Page 197 of 818

1953-2. Opening, closing and locking the doors
3
Operation of each component
C-HR_HV_OM_Europe_OM10720E 
■ Security feature 
If  a  door  is  not  opened  within  approximately  30  seconds  after  t he  vehicle  is 
unlocked, the security feature automatically locks the vehicle  again. 
■ When the door cannot be locked by the lock sensor on the surface of the 
front door handle (vehicl es with an entry function) 
■ Door lock buzzer 
If  an  attempt  to  lock  the  doors  using  the  entry  function  or  wir eless  remote 
control is made when a door is not fully closed, a buzzer will  sound  continu- 
ously  for  5  seconds.  Fully  close  the  door  to  stop  the  buzzer,  a nd  lock  the 
doors again. 
■ Setting the alarm (if equipped) 
Lock the doors will set the alarm system. ( P. 147) 
■ If the smart entry & start system or the wireless remote control does not 
operate properly 
● Use the mechanical key to lock and unlock the doors. (P. 746) 
● Replace the key battery with a new one if it is depleted. (P. 645) 
Use your palm to touch the lock sensor. 
         
        
        
     
        
        Page 199 of 818
1973-2. Opening, closing and locking the doors
3
Operation of each component
C-HR_HV_OM_Europe_OM10720E
Move the inside lock button to the lock position. 
Close the door while pulling the door handle. 
The  door  cannot  be  locked  if  the  power  switch  is  in ACCESSORY  o r 
ON mode, or the electronic key is left inside the vehicle.
The key may not be detected correctly and the door may be locke d.
The  door  cannot  be  opened  from 
inside the vehicle when the lock is 
set. 
Unlock 
Lock
These  locks  can  be  set  to  prevent 
children  from  opening  the  rear 
doors.  Push  down  on  each  rear
door switch to lock both rear doors.
Locking the front doors from the outside without a key
Rear door child-protector lock
1
2 
         
        
        
     
        
        Page 200 of 818

1983-2. Opening, closing and locking the doors
C-HR_HV_OM_Europe_OM10720E
■Switching  the  door  unlock  function  (vehicles  with  a  smart  entry & start 
system equipped with entry function) 
It is possible to set which doors the entry function unlocks us ing the wireless 
remote control.  
Turn the power switch off.
Cancel the intrusion sensor of the alarm system to prevent unin tended trig- 
gering of the alarm while c hanging the settings. (if equipped) (P. 151) 
When the indicator light on the key surface is not on, press an d hold   for 
approximately 5 seconds while pressing and holding  . 
The  setting  changes  each  time  an  operation  is  performed,  as  sho wn  below. 
(When changing the setting continuously, release the buttons, w ait for at least 
5 seconds, and repeat step  .) 
For  vehicles  with  an  alarm:  To  prevent  unintended  triggering  of   the  alarm, 
unlock the doors using the wireless remote control and open and  close a door 
once after the settings have been changed. (If a door is not op ened within 30 
seconds after   is pressed, the doors will be locked again and t he alarm will 
automatically be set.) 
In a case that the alarm is triggered, immediately stop the ala rm. (P. 147)
1
2
3
3
Multi-information  
displayUnlocking functionBeep
(Left-hand drive 
vehicles)
Holding  the  driver’s
door  handle  unlocks
only the driver’s door.
Exterior: Beeps 3 times  
Interior: Pings once
(Right-hand drive  
vehicles)
Holding  the  front  pas-
senger’s  door  handle
unlocks all the doors.
Holding  a  door  handle 
unlocks all the doors.
Exterior: Beeps twice
Interior: Pings once 
         
        
        
     
        
        Page 203 of 818
201
3
3-2. Opening, closing and locking the doors
Operation of each component
C-HR_HV_OM_Europe_OM10720E
Back door
◆Entry  function  (vehicles  with  a  smart  entry  &  start  system
equipped with entry function) 
Carry the electronic key to enable this function. 
Press  the  button  to  unlock 
the back door.
The door cannot be unlocked for 
3  seconds  after  the  door  is 
locked.
Press  the  button  to  lock  the 
back door.
Check  that  the  door  is  securely 
locked.
◆Wireless remote control 
 P.   1 9 4
◆Door lock switches 
 P.   1 9 6
The  back  door  can  be  unlocked/locked  and  opened/closed  by 
the following procedures.
Unlocking and locking the back door 
         
        
        
     
        
        Page 209 of 818
207
3
3-2. Opening, closing and locking the doors
Operation of each component
C-HR_HV_OM_Europe_OM10720E
Smar t entr y & start system
●Locks and unlocks the doors (vehicles with an entry function)  
( P. 193) 
● Locks  and  unlocks  the  back  door  (vehicles  with  an  entry  function) 
( P.   2 0 1) 
● Starts the hybrid system (P. 305)
■Antenna location
The  following  operations  can  be  performed  simply  by  carrying 
the  electronic  key  on  your  person,  for  example  in  your  pocket. 
The driver should always carry the electronic key.
Antennas  outside  the  cabin  (vehicles 
with an entry function) 
Antennas inside the cabin
Antenna  outside  the  luggage  compart- 
ment (vehicles with an entry function) 
         
        
        
     
        
        Page 210 of 818

2083-2. Opening, closing and locking the doors
C-HR_HV_OM_Europe_OM10720E 
■ Effective range (areas within which the electronic key is detected) 
When starting the hybrid system or changing power switch modes 
The  system  can  be  operated  when  the  electronic  key  is  inside  th e  vehi- 
cle. 
■ Alarms and warning messages 
A  combination  of  exterior  and  interior  buzzers  as  well  as  warni ng  messages 
shown on the multi-information display are used to prevent thef t of the vehicle 
and  accidents  resulting  from  erroneous  operation.  Take  appropri ate  mea- 
sures based on the displayed message. 
When only an alarm sounds, circumstances and correction procedu res are as 
follows. 
When  locking  or  unlocking  the  doors 
(vehicles with an entry function) 
The  system  can  be  operated  when 
the  electronic  key  is  within  about
0.7 m (2.3 ft.) of an outside front door 
handle  and  the  back  door.  (Only  the 
doors  detecting  the  key  can  be  oper-
ated.)
AlarmSituationCorrection procedure
Exterior  buzzer 
sounds  once  for  5 
seconds 
An  attempt  was  made  to 
lock the vehicle while a door 
was open. 
Close  all  of  the  doors 
and  lock  the  doors 
again.
Interior  buzzer
sounds repeatedly
The  power  switch  was
turned  to  ACCESSORY 
mode while the driver’s door 
was  open  (or  the  driver’s
door  was  opened  while  the 
power  switch  was  in 
ACCESSORY mode).
Turn  the  power  switch
off  and  close  the
driver’s door. 
         
        
        
     
        
        Page 211 of 818

2093-2. Opening, closing and locking the doors
3
Operation of each component
C-HR_HV_OM_Europe_OM10720E 
■ When  “Entry  &  Start  System  Malfunction.  See  Owner’s  Manual.”  is dis- 
played on the multi-information display 
The system may be malfunctioning. Have the vehicle inspected by  any autho- 
rized  Toyota  retailer  or  Toyota  authorized  repairer,  or  any  rel iable  repairer 
immediately. 
■ Battery-saving function 
The battery-saving function will be activated in order to preve nt the electronic 
key battery and the 12-volt battery from being discharged while  the vehicle is 
not operated for a long time. 
● In  the  following  situations,  the  smart  entry  &  start  system  may  take  some 
time to unlock the doors. 
• The  electronic  key  has  been  left  within  approximately  2  m  (6  f t.)  of  the 
outside of the vehicle for 10 minutes or longer. 
• The smart entry & start system has not been used for 5 days or  longer. 
● If  the  smart  entry  &  start  system  has  not  been  used  for  14  days  or  longer, 
the  doors  cannot  be  unlocked  at  any  doors  except  the  driver’s  d oor.  In  this 
case,  hold  the  driver’s  door  handle,  or  use  the  wireless  remote   control  or 
mechanical key to unlock the doors. 
■ Electronic Key Battery-Saving Function 
When  battery-saving  mode  is  set,  battery 
depletion  is  minimized  by  stopping  the 
electronic key from receiving radio waves. 
Press    twice  while  pressing  and 
holding  . Confirm that the electronic 
key indicator flashes 4 times. 
While  the  battery-saving  mode  is  set,  the 
smart  entry  &  start  system  cannot  be 
used. To cancel the function, press any of
the electronic key buttons.