2022 LEXUS NX300h Owners Manual

WARNING

2Remove the valve cap from the valve of the punctured tire.
3Extend the hose. Remove the air release cap from the hose.
Attach the sticker enclosed with the bottle on the specified locations.(See step 10.)
The air release cap may be used later. Therefore keep it in a safe place.
4 Connect the hose to the valve of the flat tire.
Screw the end of hose clockwise as far as possible.
WARNINGCheck the following.

WARNING

9Connect the bottle to the compressor.
As shown in the illustration, insert the bottle securely into the compressor until the
upper side of the mark on the bottle is aligned with the upper end of the notch.
10 Attach the sticker provided with the tire puncture repair kit to a position easily
seen from the driver
s seat.
A
U.S.A.
9-4.Ifatireisflat658

BCanadaWARNINGDo not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located, such as the pad of the steering wheel, it may prevent the SRS airbag from operating properly.
11 Check the specified tire inflation pressure.
Tire inflation pressure is specified on the label as shown.
12 Start the hybrid system.
13 To inject the sealant and inflate the tire, turn the compressor switch on.
WARNINGObserve the following precautions.

WARNING

WARNINGAfter inflation of the tire has completed, the sealant may splatter when the hose isdisconnected or some air is let out of the tire.
16 Install the valve cap onto the valve of the emergency repaired tire.
17 Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and dirty the interior of the
vehicle or ones clothes.
18 Temporarily store the bottle in the luggage compartment while it is connected
to the compressor.
19 To spread the liquid sealant evenly within the tire, immediately drive safety for
about 3 miles (5 km) below 50 mph (80 km/h).
WARNINGObserve the following precautions when driving to spread the sealant evenly.

21Turn the compressor switch on and wait for several seconds, then turn it off.
Check the tire inflation pressure.
A
If the tire inflation pressure is below 19 psi (130 kPa, 1.3 kgf/cm 2
or bar): The
puncture cannot be repaired. Contact your Lexus dealer.
B
If the tire inflation pressure is between 19 psi (130 kPa, 1.3 kgf/cm 2
or bar) and a
point below the specified level: The tire can be repaired. Proceed to step 22.
C
If the tire inflation pressure is at the specified level: Proceed to step 23.
Even if the tire inflation pressure is at the recommended level, the tire pressure warning light may come on/flash.
22 Turn the compressor switch on to inflate the tire until the specified tire inflation
pressure is reached. Drive for about 3 miles (5 km) and then perform step 20.
23 Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and dirty the interior of the
vehicle or ones clothes.
9-4.Ifatireisflat662