2022 LEXUS NX300h Owners Manual

Operationofthetirepressurewarningsystem
Your vehicle is equipped with a tire pressure warning system that uses tire pressure
warning valves and transmitters to detect low tire inflation pressure before serious
problems arise.
The tire pressure warning system of this vehicle adopts a 2-type warning system.

RTire chains, etc. are equipped.
R If a window tint that affects the radio wave signals is installed.
R If there is a lot of snow or ice on the vehicle, particularly around the wheels or wheel
housings
R If the tire inflation pressure is extremely higher than the specified level.
R If tires not equipped with tire pressure warning valves and transmitters are used.
R If the ID code on the tire pressure warning valves and transmitters is not registered
in the tire pressure warning computer.

NOTICE

7Select [Continue@.
A message indicating that wheel position registration is being performed will be
displayed on the multi-information display. "---" will be displayed for the tire inflation
pressure of each tire and wheel position registration will begin.
8 Drive straight (with occasional left and right turns) at approximately 25 mph
(40 km/h) or more for approximately 10 to 30 minutes.
When wheel position registration is complete, a message indicating that registration
has been completed and the inflation pressure of each tire will be displayed on the
multi-information display.
Even if it is not possible to drive continuously at approximately 40 km/h (25 mph) or
more, registration can be completed by driving for a long time. However, if registration does not complete after driving for 1 hour or more, park the vehicle in a safe place and
leave it with the power switch in ON for approximately 15 minutes or more, and then perform the driving procedure again.
Even if it is not possible to drive continuously at approximately 25 mph (40 km/h) or
more, registration can be completed by driving for a long time. However, if registration does not complete after driving for 1 hour or more, park the vehicle in a safe place and
leave it with the power switch in ON for approximately 15 minutes or more, and then perform the driving procedure again.INFORMATION

RIf wheel position registration does not complete after driving for 1 hour or more,
park the vehicle in a safe place for approximately 15 minutes and then drive the
vehicle again.

6Select [OK@.
The tire pressure warning light will slowly blink 3 times.
After setting the tire inflation pressure, a message
indicating that setting has been completed will be
displayed on the multi-information display.INFORMATION

3Select on the center display.
4 Select [Vehicle customize@.
5 Select [Tire pressure@.
6 Select [Set current air pressure@.
7 Select [Continue@.
The tire pressure warning light will slowly blink 3
times and a message indicating that tire inflation
pressure is being set will be displayed on the mul-
ti-information display.
After setting the tire inflation pressure, a message
indicating that setting has been completed will be
displayed on the multi-information display.INFORMATION

INFORMATION