2020 Alfa Romeo 4C Owner handbook (in English)

95
INFLATION PROCEDURE
Proceed as follows:
107)
❒ engage the handbrake, unscrew the
tyre valve cap, take out filler hose
1 fig. 80 and tighten ring nut 2 on the tyre
valve;
80A0L0078
❒ make sure that switch 1 fig. 81 for the
compressor is in position 0 (off), start the
engine, insert the plug into the cigar
lighter socket on the central tunnel
(see fig. 82) and switch on the
compressor by bringing switch 1 fig. 81
to I (on);
82A0L0080
❒ inflate the tyre to the pressure
indicated in the “Wheels” paragraph in the
“Technical data” chapter. In order to
obtain a precise reading, check the
pressure on pressure gauge 1 fig. 81 with
the compressor off;
❒ if after 5 minutes it is impossible to
reach at least 1.8 bar,
❒ disconnect the compressor from the
valve and power socket, then move the
car forwards approximately 10 metres in
order to distribute the sealant inside the
tyre evenly, then repeat the inflation
operation;
❒ if you still cannot obtain a pressure of
at least 1.8 bar within 5 minutes from the
compressor switching on, do not drive off
and contact a dedicated Alfa Romeo
Dealership;
❒ after driving for about 10 minutes
stop and check the tyre pressure again;
remember to engage the handbrake;
❒ if a pressure value of at least 1.8 bar
is detected, restore the correct pressure
(with the engine running and the
handbrake engaged), resume driving and
drive with great care to a dedicated Alfa
Romeo Dealership.
108) 109) 110)
81A0L0079
1
A

IN AN EMERGENCY
96
CHECKING AND RESTORING TYRE
PRESSURE
The compressor can also be used to
check and, if necessary, restore the tyre
pressure.
Release quick connector 1 fig. 83 and
connect it directly to the valve of the tyre
to be inflated.
83A0L0081
REPLACING THE BOTTLE
Proceed as follows:
❒ release connector 1 fig. 84 and
disconnect tube 2;
❒ turn the bottle anticlockwise to
replace and raise it;
❒ fit the new cylinder and turn it
clockwise;
❒ insert connector 1 and tube 2 in
position.
84A0L0082
102)Indicate the presence of the
stationary car in accordance with current
regulations: hazard warning lights,
warning triangle, etc. Those on board
should get out of the vehicle and wait for
the wheel to be repaired away from the
threat posed by the traffic. If parked on a
slope or rough surface, chock the wheels
with wedges or other suitable devices
(for the correct procedure for parking the
car safely, refer to the “Parking”
paragraph in the “Starting and driving”
chapter).
103)A repair is not possible if the wheel
rim is damaged (groove is deformed,
causing air to escape). Do not remove
foreign bodies (screws or nails) from the
tyre.
104)Give the booklet to the technicians
who will be handling the tyre that was
treated using the “Fix&Go Automatic” kit.
105)Do not operate the compressor for
longer than 20 consecutive minutes.
Risk of overheating. The kit is not suitable
for definitive repairs, so the repaired
tyres may only be used temporarily.
IMPORTANT

97
JUMP STARTING
STARTING THE ENGINE
Contact the dedicated Alfa Romeo
Dealership immediately if the
Ywarning light stays on constantly on the
instrument panel .
JUMP STARTING
If the battery is flat, start the engine
using an auxiliary battery with the same
capacity or a little higher than the flat
one.
111) 13)
Proceed as follows to start the vehicle:
❒ connect the positive terminals (+ sign
near the terminal) of the two batteries
with a jump lead fig. 85;
85A0L0116
106)As required by current regulations,
the information on chemical substances
for the protection of human health and
the environment and on the safe use of
the sealing fluid are on the packaging
label. Compliance with the indications on
the label is an essential condition to
ensure the safety and the effectiveness
of the product. Remember to carefully
read the label before use; the user of the
product is responsible for any damages
caused by improper use. The sealing fluid
has an expiry date. Replace the bottle if
the sealant has expired.
107)Wear the protective gloves
provided with the kit.
108)Apply the adhesive label where it
can be easily seen by the driver as a
reminder that the tyre has been treated
with the quick repair kit. Drive carefully,
especially on corners. Do not exceed
80 km/h. Avoid sudden acceleration or
braking.
109)If the pressure has fallen below 1.8
bar, do not drive any further: the Fix&Go
Automatic quick tyre repair kit cannot
guarantee proper hold because the tyre is
too damaged. Contact a dedicated Alfa
Romeo Dealership.
110)Always indicate that the tyre was
repaired using the quick tyre repair kit.
Give the leaflet to the personnel charged
with handling the tyre treated with the
tyre repair kit.
12)Punctures caused by foreign bodies
can be repaired if the damage does not
exceed 4 mm on the tread and on the
shoulder of the tyre. Do not use the repair
kit if the tyre was damaged as a result of
being used when underinflated.
WARNING
3)Dispose of the bottle and the sealant
properly. Have them disposed of in
compliance with national and local
regulations.
WARNING

IN AN EMERGENCY
98
❒ with a second cable, connect the
negative terminal (–) of the auxiliary
battery to an earthing point
Eon the
engine or the transmission of the car to
be started;
❒ start the engine; when the engine has
started, remove the leads, reversing the
order above.
If after a few attempts the engine does
not start, do not persist but contact a
dedicated Alfa Romeo Dealership.
IMPORTANT Do not connect the negative
terminals of the two batteries directly!
If the auxiliary battery is installed on
another car, check that there is no
accidental contact between metallic
parts of the two cars.
BUMP STARTING
Never, under any circumstances, jump
start the engine by pushing, towing or
coasting downhill.
FUEL CUT-OFF SYSTEM
OPERATION
This intervenes in the case of an impact
causing:
❒ the fuel supply cut-off with the engine
consequently switching off;
❒ automatic door lock release;
activation of all lights inside the car;
❒ the switching on of the hazard
warning lights.
The digital warning light and the
dedicated message on the display
indicate the intervention of the system.
Carefully check the vehicle for fuel leaks,
for instance in the engine compartment,
under the vehicle or near the tank area.
112)
111)This procedure must be performed
by qualified personnel as incorrect
actions may cause high-intensity
electrical discharge. Furthermore,
battery fluid is poisonous and corrosive:
avoid contact with skin and eyes. Keep
naked flames and lighted cigarettes away
from the battery and do not cause sparks.
IMPORTANT
13)Never use a fast battery charger to
start the engine as this could damage the
electronic systems and the ignition and
engine supply control units.
WARNING

99
After a collision, turn the ignition key to
STOP to prevent the battery from
running down.
To restore the correct operation of the
car, proceed as follows:
❒ bring the left exterior light control
stalk to central position (neutral);
❒ turn the ignition key to MAR;
❒ activate the right direction indicator;
❒ deactivate the right direction
indicator;
❒ activate the left direction indicator;
❒ deactivate the left direction indicator;
❒ activate the right direction indicator;
❒ deactivate the right direction
indicator;
❒ activate the left direction indicator;
❒ deactivate the left direction indicator;
❒ ignition key turned to the OFF
position;
❒ turn the ignition key to MAR.TOWING THE VEHICLE
The tow hook provided with the car is
located in the tool box in the luggage
compartment.
The tow hook attachment is only
available at the front end of the car.
ATTACHING THE TOW RING
Take tow hook 1 fig. 86 and tighten it
fully onto the threaded pin.
113) 114) 115)
86A0L0107
112)If, after an impact, you smell fuel or
notice leaks from the fuel system, do not
reactivate the system to avoid the risk of
fire.
IMPORTANT

IN AN EMERGENCY
100
113)Before towing, turn the ignition key
to the MAR position and then to STOP
without removing it. The steering column
will automatically lock when the key is
removed and the wheels cannot be
steered. Also check that the transmission
is in neutral (N).
114) When towing, remember that the
assistance of the brake servo is absent.
Consequently, more force is required at
the pedal in order to brake. Do not use
flexible cables when towing and avoid
jerky movements. Make sure not to
damage parts in contact with the car
while towing.
When towing the vehicle, you must
comply with all specific traffic
regulations and adopt an appropriate
driving behaviour.
Do not start the engine while towing the
car. Before tightening the ring, clean the
threaded housing thoroughly. Make sure
that the ring is fully fastened in the
housing before towing the vehicle.
IMPORTANT115) The tow hook should be used only
for emergencies on the road. You are
allowed to tow the vehicle for short
distances using an appropriate device in
accordance with the highway code (a rigid
bar), to move the vehicle on the road in
readiness for towing or transporting via a
breakdown vehicle.
Tow hooks MUST NOT be used to tow
vehicles off the road or where there are
obstacles and/or for towing operations
using cables or other non-rigid devices.
In compliance with the above conditions,
towing must take place with the two
vehicles (one towing, the other towed)
aligned as much as possible along the
same centre line.

SERVICING AND CARE
SCHEDULED SERVICING ................................................................................. 102
SCHEDULED SERVICING PLAN ................................................................... 103
REGULAR INSPECTIONS ................................................................................. 105
DEMANDING USE OF THE CAR .................................................................... 105
CHECKING LEVELS ............................................................................................. 106
IF THE BATTERY IS FLAT ................................................................................ 106
AIR CLEANER .......................................................................................................... 112
WINDSCREEN WIPERS ..................................................................................... 112
NOZZLES .................................................................................................................. 113
BATTERY ................................................................................................................... 113
LIFTING THE CAR ................................................................................................. 114
BODYWORK ............................................................................................................ 115
INTERIORS ............................................................................................................... 117
Correct servicing permits the performance of the
car to be maintained over time, as well as limited running costs
and safeguarding the efficiency of the safety systems.
This chapter will tell you how.

SERVICING AND CARE
102
SCHEDULED SERVICING
Correct servicing is crucial for
guaranteeing a long life for the vehicle
under the best conditions.
This is why Alfa Romeo has programmed
a series of checks and servicing
operations every 20,000 km.
Check the items on the Scheduled
Servicing Plan (e.g. periodically check
level of liquids, tyre pressure, etc.)
before 20,000 km and then between the
services deadlines.
Scheduled Servicing is offered by the
dedicated Alfa Romeo Dealership at
predefined intervals. If, during each
operation, in addition to the ones
scheduled, the need arises for further
replacements or repairs, these may be
carried out with the owner’s explicit
agreement only.
IMPORTANT NOTES
2000 km before the maintenance is due,
a dedicated message appears on the
display, along with warning light.
Scheduled Servicing interventions are
set out by the Manufacturer. Failure to
have them carried out may invalidate the
warranty.
It is advisable to inform the dedicated
Alfa Romeo Dealership of any small
operating irregularities without waiting
for the next service.