2017 VOLVO V90 Owners Manual

MAINTENANCE AND SERVICE
* Option/accessory.511
Data transmission between car and workshop6
The time required for a booked visit to a Volvo workshop can be shortened by transmitting trou-bleshooting data as soon as the car stops at theworkshop. The data can be transmitted most conveniently by selecting the option
Automatically connect
when I arrive in settings view in the centre dis-
play.
Each time the car slows to a slow enough speed it starts searching for a Wi-Fi network. If anauthorised Volvo network (at a workshop) isfound, a message is displayed or a pop-up win-dow opens in the centre display. (This does notapply when you connect manually, see the sec-tion "Connecting to a workshop manually"below).
Connecting to a workshop automatically
NOTE
To avoid the driver being disturbed by unwan- ted connection inquiries (for example, if thecar is often parked in the neighbourhood of aworkshop with an authorised Volvo network),the connection mode will change to manual ifthe driver declines connection twice within aperiod of 5 days.
Without driver confirmation
This option provides the most convenient way of transmitting troubleshooting data. The car con-nects without the need for the driver to confirm. If the car stops at the workshop and is switched off with the start knob, a message is shown atthe top in the centre display. The car will connectautomatically when the driver

MAINTENANCE AND SERVICE
* Option/accessory.
512
Raise the car
When raising the car it is important that the car jack or the workshop/garage jack is fitted to theintended points on the car

MAINTENANCE AND SERVICE
* Option/accessory.513
The triangles in the plastic cover indicate the locations of the lifting points (marked in red).
If the car is raised with a workshop jack, it must be positioned under one of the four lifting points.Ensure that the workshop jack is positioned sothat the car cannot slide off the jack. Make surethe jack plate is equipped with a rubber pad sothat the car will be stable and not be damaged.Always use axle stands or similar.
Related information
•When changing wheels (p. 495)
• Jack
* (p. 501)

MAINTENANCE AND SERVICE
514
Opening and closing the bonnet
The bonnet can be opened using the handle in the passenger compartment and a handle underthe bonnet.
Open the bonnet
Pull the handle near the foot pedals to release the bonnet from its fully closed posi-tion.
Turn the handle under the bonnet anticlock- wise to release the bonnet from the lockcatches and lift the bonnet.
Warning - bonnet not closed
When the bonnet is released, the warn- ing symbol and the graphics in thedriver display will light up and anacoustic reminder will sound. If the car
starts rolling, an acoustic warning signal willrepeat. For more information on graphics, see section "Door and seatbelt reminder".
NOTE
If the warning symbol is lit or the warning sig- nal is heard despite the bonnet being closedproperly, contact an authorised Volvo work-shop.
Close the bonnet1. Push the bonnet down until it starts to fall from its own weight.
2. When the bonnet stops against the lock catch, push the bonnet to close it completely.
WARNING
Risk of crushing! Ensure that the closing path under the bonnet is not obstructed, otherwisethere is a risk of personal injury.
WARNING
Check that the bonnet locks properly when closed. The bonnet must engage at bothsides audibly.

MAINTENANCE AND SERVICE
515
Bonnet completely closed.
WARNING
Never drive with an open bonnet! If there are any signs that the bonnet is not properly closed whilst driving, stop immedi-ately and close it.
Related information
•Engine compartment overview (p. 515)
• Door and seatbelt reminder (p. 62)
Engine compartment overview
The overview shows some service-related com- ponents.
The appearance of the engine compartment may differ depending on model and engine variant.
Coolant expansion tank
Reservoir for brake and clutch fluid (located on the driver's side)
Washer fluid filler pipe 7
Central electrical unit
Air filter
Engine oil filler pipe
WARNING
Remember that the radiator fan (located at the front of the engine compartment, behindthe radiator) may start automatically someafter the engine has been switched off. Always have the engine cleaned by a work- shop - an authorised Volvo workshop is rec-ommended. There is a risk of fire if the engineis hot.
WARNING
The ignition system works at a very high and hazardous voltage. The car's electrical system must always be in ignition position
0 when
work is being performed in the engine com- partment. Do not touch the spark plugs or ignition coil when the car's electrical system is in ignition position II or when the engine is hot.
Related information
• Opening and closing the bonnet (p. 514)
• Filling washer fluid (p. 529)
• Topping up coolant (p. 518)
• Fuses in engine compartment (p. 537)
• Checking and filling with engine oil (p. 517)
• Ignition positions (p. 385)
7
Fill the washer fluid at regular intervals, e.g. when refuelling.

MAINTENANCE AND SERVICE
516
Engine oil
An approved engine oil must be used in order that the recommended service intervals can beapplied.
Volvo recommends:
IMPORTANT
In order to fulfil the requirements for the engine's service intervals all engines are filledwith a specially adapted synthetic engine oilat the factory. The choice of oil has beenmade very carefully with regard to service life,starting characteristics, fuel consumption andenvironmental impact. An approved engine oil must be used in order that the recommended service intervals canbe applied. Only use a prescribed grade of oilfor both filling and oil change, otherwise thereis a risk of the service life, starting characte-ristics, fuel consumption and environmentalimpact of the car being affected. If engine oil of the prescribed grade and vis- cosity is not used, engine related componentsmay become damaged. Volvo Car Corporationdisclaims any liability for any such damage. Volvo recommends that oil changes are car- ried out at an authorised Volvo workshop.
Volvo uses different systems for warning of low/ high oil level or low oil pressure. Certain enginevariants have an oil pressure sensor, and then thedriver display's warning symbol for low oil pres- sure
is used. Other variants have an oil
level sensor, when the driver is informed via the driver display's warning symbol
and display texts. Certain variants have both systems. Contact a Volvo dealer for more information. Change the engine oil and oil filter in accordance with the intervals specified in the Service andWarranty Booklet. Using oil of a higher than specified grade is per- mitted. If the car is driven in adverse conditions,Volvo recommends using an oil of a higher gradethan the one specified.
Related information
•
Checking and filling with engine oil(p. 517)
• Adverse driving conditions for engine oil(p. 569)
• Engine oil — specifications (p. 567)

MAINTENANCE AND SERVICE
}}
517
Checking and filling with engine oil The oil level is detected with the electronic oil level sensor.
Filler pipe8
.
In some cases, oil may need to be topped up between service intervals. Action with regard to engine oil level does not need to be taken until a message is shown in thedriver display.
WARNING
If this symbol is shown together with the message Engine oil level
Service required, visit a workshop
- an authorised Volvo workshop is
recommended. The oil level may be too high.
IMPORTANT
If this symbol is shown together with a message about low oil level, such as
Engine oil level low
Refill 1 litre for example, then only
fill the volume specified, e.g. 1 litre.
WARNING
Do not spill oil onto the hot exhaust manifold due to the risk of fire.
Check the oil level
1. Open the Car status app from the app view
in the centre display.
2. Press the
Status button to show the oil
level.
Graphics for oil level in the centre display.
The oil level is checked using the electronic oil level gauge in the centre display when the engineis switched off.
NOTE
The system cannot directly detect changes when the oil is filled or drained. The car musthave been driven approx. 30 km and havebeen stationary for 5 minutes with the engineswitched off and on level ground before theoil level indication is correct.
8 Engines with electronic oil level sensor do not have a dipstick.

||
MAINTENANCE AND SERVICE
518
NOTE
If the right conditions for measuring the oil level (time after engine shutdown, the car'sinclination, outside temperature, etc.) are not met, then the message
No value availablewill be shown in the centre display. This does not mean that there is something wrong in
the car's systems.
Related information
• Engine oil (p. 516)
• Engine oil — specifications (p. 567)
• Adverse driving conditions for engine oil (p. 569)
• Ignition positions (p. 385)
• Car status (p. 506)
Topping up coolant
The coolant cools the internal combustion engine to the correct operating temperature. Theheat that is transferred from the engine to thecoolant can be used to heat the passenger com-partment.
When topping up the coolant, follow the instruc- tions on the packaging. Never top up with wateronly. The risk of freezing increases with both toolittle and too much coolant concentrate.
WARNING
Coolant can be very hot. If the coolant requires topping up when the engine is atoperating temperature, unscrew the expan-sion tank cap slowly to gently release theoverpressure.
Coolant expansion tank, left-hand drive car.
Screw off the cap in the plastic cover.
Screw off the cap on the expansion tank and top up with coolant. The coolant level must not exceed the yellow MAX mark inside the
expansion tank.
Reinstall the parts in reverse order.