Page 17 of 100
About EyeSight
13
EyeSight
warning
light
S01859
SI-DRIVE indicator lights X-mode indicator
lightCustomization display
Brake system warning light (red)
Lane Departure Warning
OFF indicator light
Pre-Collision Braking System
OFF indicator lightEyeSight temporary
stop indicator Set vehicle speed display READY indicatorSET indicator Steering wheel indicatorLane indicator (right) Lane indicator (left)
Following distance setting
indicator Lead vehicle indicator
Selector indicator /
shift position indicator
Conventional
Cruise Control
indicator
Adaptive Cruise
Control indicator
Page 18 of 100
About EyeSight
14
●CRUISE indicator
These indicators are displayed when the main cruise control is pushed.
: Adaptive Cruise Control (Adaptive Cruise Control indicator)
: Conventional Cruise Control (Conventional Cruise Control indicator)
* Refer to page 28.
●SET indicator [Adaptive Cruise Control/Conventional Cruise Control]
is displayed when cruise control is set. When the vehicle stops, the indicator will blink
until the cruise control is cancelled.
* Refer to page 29.
●READY indicator
is displayed when Adaptive Cruise Control can be set.
* Refer to page 28.
●Lead vehicle indicator
xWhen Adaptive Cruise Control is set, this indicator will be displayed when a vehicle in
front has been detected.
xThis indicator and the following distance setting indicator will blink in the following cases.
- The Lead Vehicle Start Alert is active.
- The Pre-Collision Braking System is active.
- The “brake more” warning is active.
- Pre-Collision Throttle Management is active.
xThese indicators also flash if, after Adaptive Cruise Control is set, it is automatically can-
celed because a vehicle in front of your vehicle is now out of the detectable range of the
EyeSight cameras.
* Refer to page 30.
●Following distance setting indicator
(Following distance setting) Indicates the following distance setting that was set with
the following distance setting switch.
This indicator blinks in the following cases.
- The “brake more” warning is active.
- The Pre-Collision Braking System is active.
- Pre-Collision Throttle Management is active.
* Refer to page 36.
●Set vehicle speed display
Displays the set vehicle speed.
* Refer to page 28.
●SI-DRIVE* mode indicator
Indicates the current SI-DRIVE mode.*SI-DRIVE refers to SUBARU Intelligent Drive.
* Refer to page 19.
Page 19 of 100
About EyeSight
15
●Selector indicator/shift position indicator
xDisplays the selector lever position or the selected gear position.
xFor turbo models, when the Adaptive Cruise Control / Conventional Cruise Control is set
while S# (Sports Sharp mode) of SI-DRIVE is selected, the display switches from the gear
position to the D position.
●Lane indicator
xWhen the Lane Departure Warning is activated, both the left and right indicators flash
simultaneously.
xWhen the Lane Sway Warning is activated, the left and right indicators flash alternately.
* Refer to pages 58 and 61.
●Steering wheel indicator
Flashes when the Lane Departure Warning or Lane Sway Warning is active.
* Refer to pages 58 and 61.
●EyeSight temporary stop indicator
xIf a malfunction occurs in the EyeSight system, the Pre-Collision Braking System OFF
indicator light and the Lane Departure Warning OFF indicator light illuminate and a sym-
bol from “E1” to “E3” will be displayed on the meter display. However, when the main
cruise control is in the OFF position, the symbol will not be displayed.
xWhen it is displayed, none of the EyeSight functions can be used except for Conventional
Cruise Control.
* Refer to page 77.
●Customization display
The settings of the alarm volume, the lead vehicle acquisition sound and the lead vehicle
start alert function can be customized when all of the following conditions are met: the
engine is running, the main cruise control is in the OFF position and the selector lever is in
the P position.
* Refer to page 79.
●EyeSight warning light
xThis indicator illuminates or flashes when a malfunction occurs in the EyeSight system.
xIt also illuminates when the ignition switch is turned to the ON position and then it turns off
approximately 5 seconds after the engine starts.
xWhen it is illuminated or flashing, none of the EyeSight functions can be used (including
Adaptive Cruise Control and the Pre-Collision Braking System, etc.).
* Refer to page 76.
●Brake system warning light (red)
If the brake system warning light illuminates during driving while the parking brake is fully
released, turn off the Pre-Collision Braking System. Also, do not use Adaptive Cruise Con-
trol or Conventional Cruise Control.
*Refer to the vehicle Owner’s Manual for details.
Page 20 of 100
About EyeSight
16
●Lane Departure Warning OFF indicator light
xThis indicator illuminates when the Lane Departure Warning and Lane Sway Warning are
off.
xIt also illuminates when the ignition switch is turned to the ON position, and then turns off
approximately 7 seconds after the engine starts.
* Refer to page 60.
●Pre-Collision Braking System OFF indicator light
xIlluminates when the Pre-Collision Braking System and Pre-Collision Throttle
Management are off.
xIt also illuminates when the ignition switch is turned to the ON position, and then turns off
approximately 7 seconds after the engine starts.
* Refer to pages 51 and 57.
■Multi function display
●
Your own vehicle speed indicator
Indicates your own vehicle speed with a red indicator.
●Set vehicle speed indicator
Indicates the set vehicle speed.
* Refer to page 29.
Set vehicle speed display
Your own vehicle
indicator
Your own vehicle
speed indicatorLead vehicle
indicator
Lead vehicle
distance indicator
S00885
Page 21 of 100
About EyeSight
17
●Your own vehicle indicator
When the brake pedal is depressed or the brake control function is active, the brake light on
the indicator illuminates in red.
●Lead vehicle indicator
While the Adaptive Cruise Control is set to on, this indicator is displayed when a vehicle is
detected in front.
* Refer to page 30.
●Lead vehicle distance indicator
While the Adaptive Cruise Control is set to on, the distance to the vehicle in front is visually
displayed when following the vehicle in front.
NOTE
For Canada models, if an EyeSight warning or malfunction is detected, a
corresponding message will be displayed on the multi function display.
However for USA models, only a malfunction message will be displayed.
* Refer to page 81.
Page 22 of 100
About EyeSight
18
■Steering wheel switches
● (CRUISE) switch
xSwitches cruise control* on/off.
* Refer to page 28.
xWhen this switch is pressed and “ ” or “ ” appears on the instrument panel, the
main cruise control is on.
*Adaptive Cruise Control and Conventional Cruise Control
●SET/- switch
xCan be used to set cruise control*.
xCan be used to reduce the set vehicle speed (when cruise control* is currently set).
* Adaptive Cruise Control and Conventional Cruise Control
●RES/+ switch
xAfter cruise control* is canceled, this switch can be used to resume the cruise control
function at the vehicle speed that was previously set.
xCan be used to increase set vehicle speed (when cruise control
* is currently set).
*Adaptive Cruise Control and Conventional Cruise Control
Switch layout
S00812
SwitchSwitch(CRUISE) switch
(INFO)/SET switch(Following distance
setting) switch
CANCEL switch
RES/+ switch
SET/- switch
S/I switch
S switch
I switch S#/I switch
Page 23 of 100
About EyeSight
19
●CANCEL switch
Cancels cruise control*.
*Adaptive Cruise Control and Conventional Cruise Control
* Refer to pages 37 and 71.
● (Following distance setting) switch
xCan be used to switch the set following distance in 3 stages: Far, Medium and Close (only
when Adaptive Cruise Control is set).
* Refer to page 36.
xWhen the (CRUISE) switch is on, press and hold this switch for approximately 2
seconds or longer to select Adaptive Cruise Control or Conventional Cruise Control.
●SI-DRIVE* switch
Selects the tracking characteristics linked with the SI-DRIVE (only when adaptive cruise
control is set).
*SI-DRIVE refers to SUBARU Intelligent Drive.
▼Turbo model
- S/I switch
xSwitches between I (Intelligent mode) and S (Sports mode) every time it’s pressed.
xWhile S# (Sports Sharp mode) is selected, press the switch to change to S (Sports
mode).
- S#/I switch
xPress the switch to change to S# (Sports Sharp mode).
xWhile S# (Sports Sharp mode) is selected, press the switch will change to I (Intelligent
mode).
▼Except for turbo model
- S switch
xPress this switch to change to S (Sports mode).
- I switch
xPress this switch to change to I (Intelligent mode).
●SI-DRIVE cooperative control
The characteristics of adaptive cruise control will vary depending on the SI-DRIVE mode
selection.
I (Intelligent mode) selected Tracks the vehicle in front speed with smooth motions.
S (Sports mode) selectedVehicle in front tracking performance is given priority,
resulting in tracking with frequent changes in speed.
S# (Sports Sharp mode)
selected The same vehicle in front tracking as S (Sports mode) is
performed. The S# (Sports Sharp) response is provided
when the driver operates the accelerator pedal.
Page 24 of 100
About EyeSight
20
● switch/ switch
The screen displayed on the multi function display can be switched.
● (Info)/SET switch
The pop up screen displayed on the multi function display can be displayed again.
* Refer to page 81.
■ Pre-Collision Braking System OFF switch
Press and hold this switch for approximately 2
seconds or longer to turn off the Pre-Collision
Braking System and Pre-Collision Throttle
Management.
When these functions are off, the Pre-
Collision Braking System OFF indicator light
on the instrument panel illuminates.
Press and hold the switch again to turn on the
Pre-Collision Braking System and Pre-
Collision Throttle Management. This turns off
the Pre-Collision Braking System OFF indica-
tor light.
* Refer to page 51.
■ Lane Departure Warning OFF switch
Press and hold this switch for approximately 2
seconds or longer to turn off the Lane
Departure Warning and Lane Sway Warning
functions.
When these functions are off, the Lane
Departure Warning OFF indicator light on the
instrument panel illuminates.
Press and hold the switch again to turn on the
Lane Departure Warning and Lane Sway
Warning functions. This turns off the Lane
Departure Warning OFF indicator light.
* Refer to page 60.
S00813
S00814
