2016 NISSAN NOTE key

FUEL FILLER LID OPENERDLK-179
< REMOVAL AND INSTALLATION > [WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G H
I
J
L
M A
B
DLK
N
O P
2. Remove fuel filler lid screws (A) and fuel filler lid (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close and lock/unlock operation.
FUEL FILLER OPENER CABLE
FUEL FILLER OPENER CABLE : Removal and InstallationINFOID:0000000012430136
REMOVAL
1. Remove hood lock/fuel filler lid lock release handle. Refer to DLK-167, "HOOD LOCK RELEASE HAN-
DLE : Removal and Installation".
2. Disconnect fuel filler lid opener cable (2) from hood lock/fuel filler lid lock release handle (1).
3. Remove dash side finisher (LH). Refer to INT-24, "
DASH SIDE FINISHER : Removal and Installation".
4. Remove center pillar lower finisher (LH). Refer to INT-25, "
CENTER PILLAR LOWER FINISHER :
Removal and Installation".
5. Remove luggage side lower finisher (LH). Refer to INT-34, "
LUGGAGE SIDE LOWER FINISHER :
Removal and Installation".
6. Disconnect fuel filler lid opener cable (1) by pulling downward and then sliding cable end to the side to remove from fuel filler
lid lock assembly (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close, lock/unlock operation.
FUEL FILLER LID LOCK
ALKIA3199ZZ
JMKIA7999ZZ
JMKIA8139ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

DLK-180
< REMOVAL AND INSTALLATION >[WITH INTELLIGENT KEY SYSTEM]
FUEL FILLER LID OPENER
FUEL FILLER LID LOCK : Removal and Installation
INFOID:0000000012430137
REMOVAL
1. Fully open fuel filler lid.
2. Remove luggage side lower finisher (LH). Refer to INT-34, "
LUGGAGE SIDE LOWER FINISHER :
Removal and Installation".
3. Disconnect the harness connector from the fuel filler lid lock assemby.
4. Release pawls (A) and remove fuel filler lid lock assembly (1). CAUTION:
Be careful not to damage gasket (2) when removing.
5. Disconnect fuel filler lid opener cable (1) by pulling downward and then sliding cable end to the side to remove from fuel filler
lid lock assembly (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler li d assembly open/close, lock/unlock operation.
JMKIA8138ZZ
JMKIA8139ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

DOOR SWITCHDLK-181
< REMOVAL AND INSTALLATION > [WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G H
I
J
L
M A
B
DLK
N
O P
DOOR SWITCH
Removal and InstallationINFOID:0000000012430138
REMOVAL
1. Remove the door switch bolt (A).
2. Disconnect the harness connector and remove door switch (1).
INSTALLATION
Installation is in the reverse order of removal.
JMKIA2173ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

DLK-182
< REMOVAL AND INSTALLATION >[WITH INTELLIGENT KEY SYSTEM]
INSIDE KEY ANTENNA
INSIDE KEY ANTENNA
INSTRUMENT CENTER
INSTRUMENT CENTER : Re
moval and InstallationINFOID:0000000012430139
REMOVAL
1. Remove center console lower. Refer to IP-20, "Removal and Installation".
2. Disconnect the harness connector from t he inside key antenna (instrument center).
3. Remove screws (A) and the inside key antenna (instrument cen- ter) (1).
INSTALLATION
Installation is in the reverse order of removal.
CONSOLE
CONSOLE : Removal and InstallationINFOID:0000000012430140
REMOVAL
1. Remove center console assembly. Refer to IP-18, "Removal and Installation".
2. Disconnect the harness connector from the inside key antenna (console).
3. Release clips (A) and remove inside key antenna (console) (1).
INSTALLATION
Installation is in the reverse order of removal.
LUGGAGE ROOM
LUGGAGE ROOM : Removal and InstallationINFOID:0000000012430141
REMOVAL
1. Remove rear seat cushion. Refer to SE-26, "SEAT CUSHION : Removal and Installation".
2. Disconnect the harness connector from the inside key antenna (luggage room).
JMKIA7948ZZ
JMKIA7950ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

INSIDE KEY ANTENNADLK-183
< REMOVAL AND INSTALLATION > [WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G H
I
J
L
M A
B
DLK
N
O P
3. Release clips (A) and remove inside key antenna (luggage room) (1).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3208ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

DLK-184
< REMOVAL AND INSTALLATION >[WITH INTELLIGENT KEY SYSTEM]
OUTSIDE KEY ANTENNA
OUTSIDE KEY ANTENNA
OUTSIDE HANDLE
OUTSIDE HANDLE : Removal and InstallationINFOID:0000000012430142
REMOVAL
1. Remove outside handle. Refer to
DLK-170, "OUTSIDE HANDLE : Removal and Installation".
2. Remove screw (A) and outside handle finisher (1) from outside handle (2).
3. Remove outside key antenna (outside handle) (1) from outside handle (2).
INSTALLATION
Installation is in the reverse order of removal.
REAR BUMPER
REAR BUMPER : Removal and InstallationINFOID:0000000012430143
REMOVAL
1. Remove the rear bumper fascia. Refer to EXT-29, "Removal and Installation".
2. Disconnect the harness connector from the outside key antenna (rear bumper)
3. Release clips (A) and remove outside key antenna (rear bumper) (1).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3209ZZ
ALKIA3210ZZ
JMKIA7952ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

DOOR REQUEST SWITCHDLK-185
< REMOVAL AND INSTALLATION > [WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G H
I
J
L
M A
B
DLK
N
O P
DOOR REQUEST SWITCH
DRIVER SIDE
DRIVER SIDE : Removal and InstallationINFOID:0000000012430144
The door request switch (driver side) is serviced as an assembly with the outside handle. Refer to DLK-170,
"OUTSIDE HANDLE : Removal and Installation".
PASSENGER SIDE
PASSENGER SIDE : Removal and InstallationINFOID:0000000012430145
The door request switch (passenger side) is serviced as an assembly with the outside handle. Refer to DLK-
170, "OUTSIDE HANDLE : Removal and Installation".
BACK DOOR
BACK DOOR : Removal and InstallationINFOID:0000000012430146
REMOVAL
1. Remove back door outer finisher. Refer to EXT-48, "Removal and Installation".
2. Remove screws (A) and back door request switch (1) from back
door outer finisher (2).
INSTALLATION
Installation is in the reverse order of removal.
AWKIA2584ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com

DLK-186
< REMOVAL AND INSTALLATION >[WITH INTELLIGENT KEY SYSTEM]
INTELLIGENT KEY WARNING BUZZER
INTELLIGENT KEY WARNING BUZZER
Removal and InstallationINFOID:0000000012430147
REMOVAL
1. Remove front combination lamp (LH). Refer to
EXL-102, "Removal and Installation"
2. Remove bolt (A) and Intelligent Key warning buzzer (1).
INSTALLATION
Installation is in the reverse order of removal.
JMKIA7949ZZ
Revision: August 2015 2016 Versa Note

cardiagn.com