2015 SUZUKI NEXA Owners Manual

Downloaded from www.Manualslib.com manuals search engine 
%()25('5,9,1*
06(
/DS6KRXOGHU%HOW(PHUJHQF\/RFNLQJ5HWUDFWRU(/5
The seat belt has an emergency locking
retractor (ELR), which is designed to lock
the seat belt only during a sudden stop or
impact. It also may lock if you pull the belt
across your body very quickly. If this hap-
pens, let the belt go back to unlock it, then
pull the belt across your body more slowly.
6DIHW\UHPLQGHU
60A03860A040
To reduce the risk of sliding under the belt
during a collision, position the lap portion
of the belt across your lap as low on your
hips as possible and adjust it to a snug fit
by pulling the shoulder portion of the belt
upward through the latch plate. The length
of the diagonal shoulder strap adjusts itself
to allow freedom of movement.
:$ 5 1 , 1 *
(Continued)

Downloaded from www.Manualslib.com manuals search engine %()25('5,9,1*
06(
$OO6HDW%HOWV([FHSW5HDU&HQWHUAll seat belts except rear center are the
lap-shoulder belt.
60A036
To fasten the seat belt, sit up straight and
well back in the seat, pull the latch plate
attached to the seat belt across your body
and press it straight into the buckle until
you hear a click.
60A039
To unfasten the seat belt, push the button
on the buckle and retract the belt slowly
while attaching a hand to the belt or/and
the latch plate.
5HDU&HQWHU6HDW%HOWRear center seat belt is the lap belt.
To fasten the belt, pull the latch plate
attached to the seat belt across your hips
and press it straight into the buckle until you
hear a click. To reduce the risk of sliding
under the belt during a collision, position the
belt across your lap as low on your hips as
possible and adjust it to a snug fit.
80JS028
To tighten the belt, pull the free end of the
belt across alongside the lap strap.727,*+7(1
Low on hips

Downloaded from www.Manualslib.com manuals search engine 
%()25('5,9,1*
06(
80JS029
To lengthen, release the latch plate from the
buckle, pull the latch plate (adjuster) in the
direction of the arrow, at right angles to the
belt. The latch plate should then be refitted
into the buckle and the belt tightened as
previously described.To unfasten the belt, press the release but-
ton on the buckle catch.NOTE:
To identify the center seat belt buckle and
latch plate in the rear seat, “CENTER” is
marked on the buckle and latch plate of the
center lap belt. The buckles are designed so
a latch plate cannot be inserted into the
wrong buckle.'ULYHU

Downloaded from www.Manualslib.com manuals search engine %()25('5,9,1*
06(
6KRXOGHU$QFKRU+HLJKW$GMXVWHU
64J198
Adjust the shoulder anchor height so that
the shoulder belt rides on the center of the
outboard shoulder. To move upward, slide
the anchor up. To move downward, slide
the anchor down while pulling the lock
knob out. After adjustment, make sure that
the anchor is securely locked.
6HDW%HOW,QVSHFWLRQ
65D209S
Periodically inspect the seat belts to make
sure they work properly and are not dam-
aged. Check the webbing, buckles, latch
plates, retractors, anchorages, and guide
loops. Replace any seat belts which do not
work properly or are damaged.
&KLOG5HVWUDLQW6\VWHPV
60G332S
,QIDQWUHVWUDLQWUHDUVHDWRQO\
80JC007
:$ 5 1 , 1 *
%H VXUH WKDW WKH VKRXOGHU EHOW LV
SRVLWLRQHG RQ WKH FHQWHU RI WKH RXW
VLGHVKRXOGHU7KHEHOWVKRXOGEH
DZD\ IURP \RXU IDFH DQG QHFN EXW
QRW IDOOLQJ RII \RXU VKRXOGHU 0LVDG
MXVWPHQW RI WKH EHOW FRXOG UHGXFH
WKH HIIHFWLYHQHVV RI WKH VDIHW\ EHOW
LQDFUDVK
(;$03/(
:$ 5 1 , 1 *
%H VXUH WR LQVSHFW DOO VHDW EHOW
DVVHPEOLHV DIWHU DQ\ FROOLVLRQ $Q\
VHDW EHOW DVVHPEO\ ZKLFK ZDV LQ XVH
GXULQJ D FROOLVLRQ RWKHU WKDQ D YHU\
PLQRU RQH VKRXOG EH UHSODFHG HYHQ
LI GDPDJH WR WKH DVVHPEO\ LV QRW
REYLRXV $Q\ VHDW EHOW DVVHPEO\
ZKLFK ZDV QRW LQ XVH GXULQJ D FROOL
VLRQVKRXOGEHUHSODFHGLILWGRHVQRW
IXQFWLRQ SURSHUO\ LW LV GDPDJHG LQ
DQ\ ZD\ RU WKH VHDW EHOW SUHWHQVLRQ
HUVZHUHDFWLYDWHGWKDWLVLIWKHIURQW
DLUEDJVZHUHDFWLYDWHG(;$03/(
(;$03/(

Downloaded from www.Manualslib.com manuals search engine 
%()25('5,9,1*
06(
&KLOGUHVWUDLQW
80JC016
%RRVWHUVHDW
80JC008
MARUTI SUZUKI highly recommends that
you use a child restraint system to restrain
infants and small children. Many different
types of child restraint systems are avail-
able; make sure that the restraint system
you select meets applicable safety stan-
dards.All child restraint systems are designed to
be secured in vehicle seats by either seatbelts (lap belts or the lap portion of lap-
shoulder belts). MARUTI SUZUKI recom-
mends that child restraint systems be
installed on the rear seat as per the Child
Restraint System table in this section.
According to accident statistics, children are
safer when properly restrained in rear seat-
ing positions than in front seating positions.
NOTE:
Observe any statutory regulation about
child restraints.
58MS03065D608
65D609
(;$03/((;$03/(
:$ 5 1 , 1 *
'R QRW LQVWDOO D UHDUIDFLQJ FKLOG
UHVWUDLQWLQWKHIURQWSDVVHQJHU

Downloaded from www.Manualslib.com manuals search engine %()25('5,9,1*
06(
,QVWDOODWLRQZLWK/DS6KRXOGHU6HDW
%HOWVNOTE:
If the most upper position head restraint
interferes a child restraint system and pre-
vents the child restraint system from being
installed securely, remove the head
restraint.
Stow the removed head restraint in the lug-
gage compartment so it will not inconve-
nience the occupants.
(/5W\SHEHOW
Install your child restraint system accord-
i
ng to the instructions provided by the child
restraint system manufacturer.
Make sure that the seat belt is securely
latched.Try to move the child restraint system in all
directions to make sure it is securely
installed.
,QVWDOODWLRQZLWKD/DS%HOW
60G132
Install your child restraint system according
to the instructions provided by the child
restraint system manufacturer.
To lengthen or tighten the belt, refer to the
“/DSEHOW” item in this “Seat Belts and Child
Restraint Systems” section. After making
sure that the seat belt is securely latched,
try moving the child restraint system in all
directions, to make sure it is securely
installed. If you need to tighten the belt, pull
the free end of the webbing.
:$ 5 1 , 1 *
&KLOGUHQ FRXOG EH HQGDQJHUHG LQ D
FUDVK LI WKHLU FKLOG UHVWUDLQW V\VWHPV
DUH QRW SURSHUO\ VHFXUHG LQ WKH YHKL
FOH :KHQ LQVWDOOLQJ D FKLOG UHVWUDLQW
V\VWHPEHVXUHWRIROORZWKHLQVWUXF
WLRQV EHORZ %H VXUH WR VHFXUH WKH
FKLOG LQ WKH UHVWUDLQW V\VWHP DFFRUG
LQJ WR WKH PDQXIDFWXUHU

Downloaded from www.Manualslib.com manuals search engine 
%()25('5,9,1*
06(
&KLOG5HVWUDLQW6\VWHPIRU,QGLD&KLOG5HVWUDLQWThe suitability of each passenger’s seat position for carriage of children and fitting of child restraint system is shown in the table below.
Whenever you carry children up to 12 years of age, properly use the child restraints which conform to AIS 072, the standard for child
restraints, referring to the table.
MASS GROUPSeating position (or other site)
Front
PassengerRear
OutboardRear
CentreIntermediate
OutboardIntermediate
Centre
Group 0
Up to 10 kgXUXN.A.N.A.
Group 0+
Up to 13 kgXUXN.A.N.A.
Group I
9 to 18 kgXUXN.A.N.A.
Group II
15 to 25 kgXUXN.A.N.A.
Group III
22 to 36 kgXUXN.A.N.A.
Key of letters to be inserted in the above table:
U =Suitable for ‘universal’ category restraints approved for use in this mass group
X =Seat position not suitable for children in this mass group
N.A = Seat position not available for children in this mass group.
NOTE: ‘universal’ is the category in the AIS 072.
: ‘Outboard’ indicates window side seat.

Downloaded from www.Manualslib.com manuals search engine %()25('5,9,1*
06(
6HDW%HOW3UHWHQVLRQHU6\VWHP
LIHTXLSSHG
63J269
To determine if your vehicle is equipped
with a seat belt pretensioner system at the
front seating positions, check the label on
the front seat belt at the bottom part. If the
letters “p” and/or “PRE” appear as illus-
trated, your vehicle is equipped with the
seat belt pretensioner system. You can usethe pretensioner seat belts in the same
manner as ordinary seat belts.
Read this section and the “Supplemental
Restraint System (air bags)” section to
learn more about the pretensioner system.
The seat belt pretensioner system works
with the 6833/(0(17$/ 5(675$,17
6<67(0 $LU %DJV. The crash sensors
and the electronic controller of the air bag
system also control the seat belt preten-
sioners. The pretensioners are triggered
only when there is a frontal crash severe
enough to trigger the air bags and the seat
belts are fastened. For precautions and
general information including servicing the
pretensioner system, refer to the “Supple-
mental Restraint System (air bags)” sec-
tion in addition to this “Seat Belt
Pretensioner System” section, and follow
all those precautions.
The pretensioner is located in each front
seat belt retractor. The pretensioner tight-
ens the seat belt so the belt fits the occu-
pant’s body more snugly in the event of a
frontal crash. The retractors will remain
locked after the pretensioners are acti-
vated. Upon activation, some noise will
occur and some smoke may be released.
These conditions are not harmful and do
not indicate a fire in the vehicle.
The driver and all passengers must be
properly restrained by wearing seat belts
at all times, whether or not a pretensioner
is equipped at their seating position, toSit fully back in the seat; sit up straight; do
not lean forward or sideways. Adjust the
belt so the lap portion of the belt is worn
low across the pelvis, not across the waist.
Please refer to the “Seat Adjustment” sec-
tion and the instructions and precautions
about the seat belts in this “Seat Belts and
Child Restraint Systems” section for details
on proper seat and seat belt adjustments.
Please note that the pretensioners along
with the air bags will activate in severe
frontal collisions. They are not designed to
activate in side impacts, rear impacts, roll-
overs, or minor frontal collisions. The pre-
tensioners can be activated only once. If
the pretensioners are activated (that is, if
the air bags are activated), have the pre-
tensioner system serviced by an
DXWKRULVHG 0DUXWL 6X]XNL ZRUNVKRS as
soon as possible.
:$ 5 1 , 1 *
7KLV VHFWLRQ RI WKH RZQHU