Page 49 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
/ D S 6 K R X O G H U % H O W ( P H U J H Q F \ / R F N L Q J 5 H W U D F W R U ( / 5
The seat belt has an emergency locking
retractor (ELR), which is designed to lock
the seat belt only during a sudden stop or
impact. It also may lock if you pull the belt
across your body very quickly. If this hap-
pens, let the belt go back to unlock it, then
pull the belt across your body more slowly.
6 D I H W \ U H P L Q G H U
60A03860A040
To reduce the risk of sliding under the belt
during a collision, position the lap portion
of the belt across your lap as low on your
hips as possible and adjust it to a snug fit
by pulling the shoulder portion of the belt
upward through the latch plate. The length
of the diagonal shoulder strap adjusts itself
to allow freedom of movement.
: $ 5 1 , 1 *
(Continued)
Page 51 of 288
Downloaded from www.Manualslib.com manuals search engine
% ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
80JS029
To lengthen, release the latch plate from the
buckle, pull the latch plate (adjuster) in the
direction of the arrow, at right angles to the
belt. The latch plate should then be refitted
into the buckle and the belt tightened as
previously described.To unfasten the belt, press the release but-
ton on the buckle catch.NOTE:
To identify the center seat belt buckle and
latch plate in the rear seat, “CENTER” is
marked on the buckle and latch plate of the
center lap belt. The buckles are designed so
a latch plate cannot be inserted into the
wrong buckle. ' U L Y H U
Page 54 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
, Q V W D O O D W L R Q Z L W K / D S 6 K R X O G H U 6 H D W
% H O W VNOTE:
If the most upper position head restraint
interferes a child restraint system and pre-
vents the child restraint system from being
installed securely, remove the head
restraint.
Stow the removed head restraint in the lug-
gage compartment so it will not inconve-
nience the occupants.
( / 5 W \ S H E H O W
Install your child restraint system accord-
i
ng to the instructions provided by the child
restraint system manufacturer.
Make sure that the seat belt is securely
latched.Try to move the child restraint system in all
directions to make sure it is securely
installed.
, Q V W D O O D W L R Q Z L W K D / D S % H O W
60G132
Install your child restraint system according
to the instructions provided by the child
restraint system manufacturer.
To lengthen or tighten the belt, refer to the
“ / D S E H O W” item in this “Seat Belts and Child
Restraint Systems” section. After making
sure that the seat belt is securely latched,
try moving the child restraint system in all
directions, to make sure it is securely
installed. If you need to tighten the belt, pull
the free end of the webbing.
: $ 5 1 , 1 *
& K L O G U H Q F R X O G E H H Q G D Q J H U H G L Q D
F U D V K L I W K H L U F K L O G U H V W U D L Q W V \ V W H P V
D U H Q R W S U R S H U O \ V H F X U H G L Q W K H Y H K L
F O H : K H Q L Q V W D O O L Q J D F K L O G U H V W U D L Q W
V \ V W H P E H V X U H W R I R O O R Z W K H L Q V W U X F
W L R Q V E H O R Z % H V X U H W R V H F X U H W K H
F K L O G L Q W K H U H V W U D L Q W V \ V W H P D F F R U G
L Q J W R W K H P D Q X I D F W X U H U
Page 283 of 288
Downloaded from www.Manualslib.com manuals search engine 11-1
SPECIFICATIONS
64MS0-74E
SPECIFICATIONS
NOTE:
Specifications are subject to change without notice.
M/T: Manual transaxle
ITEM: Dimensions UNIT: mm
Overall length4300
Overall width1765
Overall height without Roof rails 1585
with Roof rails 1590
Wheelbase2600
Track Front 1535
Rear 1505
ITEM: Mass (weight) UNIT: kg
Curb mass (weight) D13A 1180 – 1205
D16AA 1250 – 1275
Gross vehicle mass (weight) rating D13A 1670
D16AA 1740
Permissible maximum Axle Weight
FrontD13A 860
D16AA 940
Rear 840
