2015 SUZUKI NEXA oil pressure
[x] Cancel search: oil pressurePage 14 of 288
Downloaded from www.Manualslib.com manuals search engine 0-8
55KS0-74E
9. Emission Warranty will not be affected by the change of owner,
provided all the documents are available.
10.All maintenance actions (as specified in the Owner’s Manual
and Service Booklet) need to be followed and recorded in the
manual for emission warranty.
11.The customer needs to produce the PUC (Pollution Under
Control) certificate valid for the period preceding the test during
which the failure is discovered. The receipts (for the mainte-
nance of the vehicle as per specification in Owner’s Manual
and Service Booklet from the date of original purchase of the
vehicle) will also be required.Conditions under which the Emission Warranty is not
APPLICABLE1. In the absence of valid PUC certificate.
2.
Vehicle not serviced from D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S
as per the schedule specified in the Owner’s Manual and
Service Booklet.
3
. Vehicle subjected to abnormal use (accident, motor race, ral-
lies or for the purpose of establishing the records etc).
4. Use of non MGP (Maruti Genuine Part).
5. Vehicle that has been tampered with.
6. Tampering with odometer so that the actual kilometer reading
can not be determined.
7. Use of adulterated fuel and/or unspecified oils (Engine oil,
Transmission oil and Brake oil etc).
Annexure - AList of parts covered under Emission Warranty
1. Fuel Injector Assembly, Pressure Regulator, Throttle Body
Assembly.
2. Electronic Control Module (ECM).
3. Intake Manifold.
4. EGR valve.
5. Ignition Coil.
6. Canister Assembly.
7. Vapour Liquid Seperator.
8. Fuel Tank and Filler Cap.
9. PCV (Positive Crankcase Ventilation) Valve.
10. Oil Filler Cap.
11. Catalytic Convertor.
12. Exhaust Manifold.
13. All Fuel Injection System related SENSORS.
14. High Pressure Fuel Pump.
15. Glow Plug.
16. Glow Plug Controller.
Page 82 of 288
Downloaded from www.Manualslib.com manuals search engine % ( ) 2 5 ( ' 5 , 9 , 1 *
0 6 (
2 L O 3 U H V V X U H / L J K WThis light comes on when the ignition
switch is turned to the “ON” position or the
engine switch is pressed to change the
ignition mode to “ON”, and goes out when
the engine is started. The light will come
on and remain on if there is insufficient oil
pressure. If the light comes on when driv-
ing, pull off the road as soon as you can
and stop the engine.
& K D U J L Q J / L J K W
50G052
This light comes on when the ignition
switch is turned to the “ON” position or the
engine switch is pressed to change the
ignition mode to “ON”, and goes out when
the engine is started. The light will come on
and remain on if there is something wrong
with the battery charging system. If the light
comes on when the engine is running, the
charging system should be inspected
immediately by your D X W K R U L V H G 0 D U X W L
6 X ] X N L Z R U N V K R S.
' U L Y H U
Page 227 of 288
Downloaded from www.Manualslib.com manuals search engine 7-4
INSPECTION AND MAINTENANCE
64MS0-74E
Interval: This interval should be judged by odometer reading
or months, whichever comes first.
FREE INSPECTION
PERIODIC MAINTENANCE AT COST
km (x1000)
1
5
10
20
30
40
50
60
70
80
months
1
6
12
24
36
48
60
72
84
96
5-5.
Brake drum and shoes (Wear)
-
-
I
I
I
I
I
I
I
I
5-6.Master cylinder and wheel cylinder or caliper, brake hoses and pipes (Fluid
leakage, damage)IIIIIIIIII
5-7.
Master cylinder sub assembly, wheel cylinder boot kit & caliper seal set
I
I
I
I
I
R
I
I
I
R
WHEEL
6-1.
Tyres (air pressure, abnormal wear, crack and rotation)
I
I&O
I&O
I&O
I&O
I&O
I&O
I&O
I&O
I&O
6-2. Wheels (Damage) I I I IIIIIII
6-3.
Front/Rear wheel bearing (Loose, damage)
I
I
I
I
I
I
I
I
I
I
FRONT / REAR SUSPENSION
7-1.
Suspension strut (Oil leakage, damage)
I
I
I
I
I
I
I
I
I
I
7-2. Suspension arms / Knuckle support (Loose, damage) – I I I I I I I I I
7-3.
Rear spring (Damage)
I
I
I
I
I
I
I
I
I
I
7-4.Shock absorbers (Oil leakage, damage) I I I I IIIIII
7-5.
All bolts and nuts (Loose)
–
T
T
T
T
T
T
T
T
T
7-6.Torsion rods – I I I I I I I I I
STEERING
8-1.
Steering wheel (Play, loose)
I
I
I
I
I
I
I
I
I
I
8-2.Steering column and tie rods (Loose, damage, wear) I I I I I I I I I I
ELECTRICAL
9-1.
Battery electrolyte (Level, leakage)
I
I
I
I
I
I
I
I
I
I
9-2. Wiring harness connection (Loose, damage) – I I I I I I I I I
9-3.
Lighting system (Operation, stains, damage)
I
I
I
I
I
I
I
I
I
I
9-4.Horn (Operation) IIIIII I II I
9-5.
System Voltage
)
I
I
I
I
I
I
I
I
I
BODY
10-1.
All chassis bolts and nuts (Tighten)
–
I
T
T
T
T
T
T
T
T
10-2. All latches, hinges and locks (Function)) I I&L I&L I&L I&L I&L I&L I&L I&L I&L
Page 234 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
If the coolant level is below the “LOW”
mark, more coolant should be added.
When the engine is cool, remove the
degassing tank cap by turning it anticlock-
wise slowly to release any pressure. And
add coolant until the degassing tank level
reaches the “FULL” mark. Never fill the
degassing tank above the “FULL” mark. & R R O D Q W 5 H S O D F H P H Q WSince special procedures are required, we
recommend you take your vehicle to your
D X W K R U L V H G 0 D U X W L 6 X ] X N L Z R U N V K R S for
coolant replacement.
$ L U & O H D Q H UIf the air cleaner is clogged with dust, there
will be greater intake resistance, resulting
in decreased power output and increased
fuel consumption.
61MM0A126
Unclamp the side clamps and remove the
element from the air cleaner case. If it
appears to be dirty, replace it with a new
one.
Clamp the side clamps securely.
* H D U 2 L O 0 D Q X D O 7 U D Q V D [ O H 2 L OWhen adding gear oil, use gear oil with the
appropriate viscosity and grade as shown
in the chart below.
We highly recommend you use:
“MARUTI * ( 1 8 , 1 ( GEAR OIL : ”
for manual transaxle gear oil.
0 D Q X D O W U D Q V D [ O H R L O
68LM728
* H D U 2 L O / H Y H O & K H F N V S H H G P D Q X D O W U D Q V D [ O H
52LM021
: $ 5 1 , 1 *
, W L V K D ] D U G R X V W R U H P R Y H W K H U H V H U
Y R L U W D Q N F D S G H J D V V L Q J W D Q N F D S I R U
D G L H V H O H Q J L Q H Z K H Q W K H Z D W H U W H P
S H U D W X U H L V K L J K E H F D X V H V F D O G L Q J
I O X L G D Q G V W H D P P D \ E H E O R Z Q R X W
X Q G H U S U H V V X U H : D L W X Q W L O W K H F R R O D Q W
W H P S H U D W X U H K D V O R Z H U H G E H I R U H
U H P R Y L Q J W K H F D S
( ; $ 0 3 / (
C
Fo o-30
-22-20
-4-10
14 32 50 68 86 104010203040
75W-80
(1) ( ; $ 0 3 / (
Page 286 of 288
Downloaded from www.Manualslib.com manuals search engine 6 3 ( & , ) , & $ 7 , 2 1 6
0 6 (
*1 When tire replacement is necessary and if the specified load index and speed rated tire is not available, then use a tire of higher load
index and speed rating.
*2: The spare wheel provided with alloy wheel variant is steel wheel rim, hence follow 4 tire rotation only.
(Refer: Section
“Inspection and maintenance”)
, 7 ( 0 : K H H O V D Q G 7 L U H V
Tire size, front and rear
205/60R16 92H
*1*2
Tire size, spare
205/60R16 92H
*2 (Steel wheel)
Rim size 205/60R16 tire: 16X6J
Tire pressures For the specified tire pressure, see the Tire Information Label located
on the driver’s door lock pillar.
, 7 ( 0 5 H F R P P H Q G H G ) X H O / X E U L F D Q W V D Q G & D S D F L W L H V D S S U R [
Fuel 48 L
Engine oil D13A 3.2 L (replacement with oil filter)
D16AA 5.25 L (replacement with oil filter)
Engine coolant D13A 6.0 L (including reservoir tank)
D16AA 5.5 L (including reservoir tank)
Manual transaxle oil 5M/T 2.6 L
6M/T 2.1 L
Brake fluid / Clutch fluid Refill to the proper oil level according to the instructions in the “INSPEC-
TION AND MAINTENANCE” section.